// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
-/dts-v1/;
-#include <dt-bindings/gpio/gpio.h>
-#include <dt-bindings/input/input.h>
-
-#include "ar7100.dtsi"
+#include "ar7161_netgear_wndr.dtsi"
/ {
compatible = "netgear,wndr3800", "qca,ar7161";
model = "Netgear WNDR3800";
- memory@0 {
- device_type = "memory";
- reg = <0x0 0x8000000>;
+ aliases {
+ label-mac-device = ð0;
};
+};
- extosc: ref {
- compatible = "fixed-clock";
- #clock-cells = <0>;
- clock-output-names = "ref";
- clock-frequency = <40000000>;
+&partitions {
+ partition@0 {
+ label = "u-boot";
+ reg = <0x000000 0x050000>;
+ read-only;
};
- reset-leds {
- compatible = "reset-leds";
-
- wps {
- label = "netgear:green:usb";
- resets = <&rst 12>;
- };
+ partition@50000 {
+ label = "u-boot-env";
+ reg = <0x050000 0x020000>;
+ read-only;
};
- gpio-leds {
- compatible = "gpio-leds";
-
- wps {
- label = "netgear:orange:wps";
- gpios = <&gpio 0 GPIO_ACTIVE_LOW>;
- default-state = "off";
- };
-
- power_green {
- label = "netgear:green:power";
- gpios = <&gpio 1 GPIO_ACTIVE_LOW>;
- default-state = "off";
- };
-
- power_orange {
- label = "netgear:orange:power";
- gpios = <&gpio 2 GPIO_ACTIVE_LOW>;
- default-state = "off";
- };
-
- wps_green {
- label = "netgear:green:wps";
- gpios = <&gpio 4 GPIO_ACTIVE_LOW>;
- default-state = "off";
- };
-
- wan_green {
- label = "netgear:green:wan";
- gpios = <&gpio 6 GPIO_ACTIVE_LOW>;
- default-state = "off";
- };
+ partition@70000 {
+ label = "firmware";
+ reg = <0x070000 0xf80000>;
+ compatible = "openwrt,uimage", "denx,uimage";
+ openwrt,ih-magic = <0x33373031>;
+ openwrt,ih-type = <IH_TYPE_FILESYSTEM>;
};
- gpio-keys-polled {
- compatible = "gpio-keys-polled";
- #address-cells = <1>;
- #size-cells = <0>;
- poll-interval = <100>;
-
- button@0 {
- label = "wps";
- linux,code = <KEY_WPS_BUTTON>;
- gpios = <&gpio 3 GPIO_ACTIVE_LOW>;
- };
-
- button@1 {
- label = "reset";
- linux,code = <KEY_RESTART>;
- gpios = <&gpio 18 GPIO_ACTIVE_LOW>;
- };
-
- button@2 {
- label = "wifi";
- linux,code = <BTN_2>;
- gpios = <&gpio 11 GPIO_ACTIVE_LOW>;
- };
- };
-
- rtl8366s {
- compatible = "realtek,rtl8366s";
- gpio-sda = <&gpio 5 GPIO_ACTIVE_HIGH>;
- gpio-sck = <&gpio 7 GPIO_ACTIVE_HIGH>;
-
- mdio-bus {
- status = "okay";
-
- phy-mask = <0x10>;
-
- phy4: ethernet-phy@4 {
- reg = <4>;
- phy-mode = "rgmii";
- };
- };
+ art: partition@ff0000 {
+ label = "art";
+ reg = <0xff0000 0x010000>;
+ read-only;
};
};
-&usb_phy {
- status = "okay";
+&ath9k0 {
+ nvmem-cells = <&macaddr_art_c>, <&cal_art_1000>;
+ nvmem-cell-names = "mac-address", "calibration";
};
-&usb1 {
- status = "okay";
+&ath9k1 {
+ nvmem-cells = <&macaddr_art_0>, <&cal_art_5000>;
+ nvmem-cell-names = "mac-address", "calibration";
};
-&usb2 {
- status = "okay";
+ð0 {
+ nvmem-cells = <&macaddr_art_0>;
+ nvmem-cell-names = "mac-address";
};
-&pcie0 {
- status = "okay";
+ð1 {
+ nvmem-cells = <&macaddr_art_6>;
+ nvmem-cell-names = "mac-address";
};
-&uart {
- status = "okay";
-};
+&art {
+ compatible = "nvmem-cells";
+ #address-cells = <1>;
+ #size-cells = <1>;
-&spi {
- status = "okay";
- num-cs = <1>;
-
- flash@0 {
- #address-cells = <1>;
- #size-cells = <1>;
- compatible = "mx25l12805d";
- reg = <0>;
- spi-max-frequency = <25000000>;
-
- partitions {
- compatible = "fixed-partitions";
- #address-cells = <1>;
- #size-cells = <1>;
-
- partition@0 {
- label = "u-boot";
- reg = <0x000000 0x050000>;
- read-only;
- };
-
- partition@1 {
- label = "u-boot-env";
- reg = <0x050000 0x020000>;
- };
-
- partition@2 {
- label = "firmware";
- reg = <0x70000 0xf80000>;
- };
-
- partition@3 {
- label = "art";
- reg = <0xff0000 0x010000>;
- read-only;
- };
- };
+ macaddr_art_0: macaddr@0 {
+ reg = <0x0 0x6>;
};
-};
-
-ð0 {
- status = "okay";
- pll-data = <0x11110000 0x00001099 0x00991099>;
-
- fixed-link {
- speed = <1000>;
- full-duplex;
+ macaddr_art_6: macaddr@6 {
+ reg = <0x6 0x6>;
};
-};
-ð1 {
- status = "okay";
-
- pll-data = <0x11110000 0x00001099 0x00991099>;
+ macaddr_art_c: macaddr@c {
+ reg = <0xc 0x6>;
+ };
- resets = <&rst 13>;
- reset-names = "mac";
+ cal_art_1000: cal@1000 {
+ reg = <0x1000 0xeb8>;
+ };
- phy-handle = <&phy4>;
+ cal_art_5000: cal@5000 {
+ reg = <0x5000 0xeb8>;
+ };
};