brcm2708: remove linux 4.4 support

[openwrt/staging/yousong.git] / target / linux / brcm2708 / patches-4.4 / 0557-lirc_rpi-Delete-vestigial-gpio_in_pull-parameter.patch

diff --git a/target/linux/brcm2708/patches-4.4/0557-lirc_rpi-Delete-vestigial-gpio_in_pull-parameter.patch b/target/linux/brcm2708/patches-4.4/0557-lirc_rpi-Delete-vestigial-gpio_in_pull-parameter.patch
deleted file mode 100644 (file)
index 58bab71..0000000
--- a/target/linux/brcm2708/patches-4.4/0557-lirc_rpi-Delete-vestigial-gpio_in_pull-parameter.patch
+++ /dev/null
@@ -1,38 +0,0 @@
-From d2517545ca23d2a147402f7c5f736d046e921b34 Mon Sep 17 00:00:00 2001
-From: Phil Elwell <phil@raspberrypi.org>
-Date: Mon, 5 Dec 2016 09:58:16 +0000
-Subject: [PATCH] lirc_rpi: Delete vestigial gpio_in_pull parameter
-
-The RPi GPIO no longer support run-time "pull" settings - one should
-Device Tree and pinctrl instead - so remove the parameter to avoid
-confusion.
-
-See: https://github.com/raspberrypi/linux/issues/1711
-
-Signed-off-by: Phil Elwell <phil@raspberrypi.org>
----
- drivers/staging/media/lirc/lirc_rpi.c | 6 ------
- 1 file changed, 6 deletions(-)
-
---- a/drivers/staging/media/lirc/lirc_rpi.c
-+++ b/drivers/staging/media/lirc/lirc_rpi.c
-@@ -64,8 +64,6 @@
- 
- /* set the default GPIO input pin */
- static int gpio_in_pin = 18;
--/* set the default pull behaviour for input pin */
--static int gpio_in_pull = BCM2708_PULL_DOWN;
- /* set the default GPIO output pin */
- static int gpio_out_pin = 17;
- /* enable debugging messages */
-@@ -716,10 +714,6 @@ module_param(gpio_in_pin, int, S_IRUGO);
- MODULE_PARM_DESC(gpio_in_pin, "GPIO input pin number of the BCM processor."
-                " (default 18");
- 
--module_param(gpio_in_pull, int, S_IRUGO);
--MODULE_PARM_DESC(gpio_in_pull, "GPIO input pin pull configuration."
--               " (0 = off, 1 = up, 2 = down, default down)");
--
- module_param(sense, int, S_IRUGO);
- MODULE_PARM_DESC(sense, "Override autodetection of IR receiver circuit"
-                " (0 = active high, 1 = active low )");