kirkwood: use generic diag.sh

[openwrt/openwrt.git] / target / linux / kirkwood / patches-4.19 / 105-ea4500.patch

diff --git a/target/linux/kirkwood/patches-4.19/105-ea4500.patch b/target/linux/kirkwood/patches-4.19/105-ea4500.patch
index c7c8b38f95e40b984836d6fdfc556ce0b649d3ff..601c1cad6d8e3344c19baa6ada44074ff595c761 100644 (file)
--- a/target/linux/kirkwood/patches-4.19/105-ea4500.patch
+++ b/target/linux/kirkwood/patches-4.19/105-ea4500.patch
@@ -1,6 +1,26 @@
 --- a/arch/arm/boot/dts/kirkwood-linksys-viper.dts
 +++ b/arch/arm/boot/dts/kirkwood-linksys-viper.dts
-@@ -67,9 +67,23 @@
+@@ -24,6 +24,10 @@
+       };
+ 
+       aliases {
++              led-boot = &led_white_health;
++              led-failsafe = &led_white_health;
++              led-running = &led_white_health;
++              led-upgrade = &led_white_health;
+               serial0 = &uart0;
+       };
+ 
+@@ -56,7 +60,7 @@
+               pinctrl-0 = < &pmx_led_white_health &pmx_led_white_pulse >;
+               pinctrl-names = "default";
+ 
+-              white-health {
++              led_white_health: white-health {
+                       label = "viper:white:health";
+                       gpios = <&gpio0 7 GPIO_ACTIVE_HIGH>;
+               };
+@@ -67,9 +71,23 @@
                };
        };
  
@@ -26,7 +46,7 @@
                compatible = "marvell,dsa";
                #address-cells = <2>;
                #size-cells = <0>;
-@@ -161,22 +175,22 @@
+@@ -161,22 +179,22 @@
                };
  
                partition@200000 {
@@ -53,7 +73,7 @@
                        reg = <0x1EA0000 0x1760000>;
                };
  
-@@ -207,53 +221,6 @@
+@@ -207,53 +225,6 @@
  
  &mdio {
        status = "okay";
@@ -107,7 +127,7 @@
  };
  
  &uart0 {
-@@ -272,10 +239,14 @@
+@@ -272,10 +243,14 @@
  };
  
  /* eth1 is connected to the switch at port 6. However DSA only supports a