kirkwood: copy config and patches to 5.15

[openwrt/staging/mkresin.git] / target / linux / kirkwood / patches-5.15 / 103-iomega-ix2-200.patch

diff --git a/target/linux/kirkwood/patches-5.15/103-iomega-ix2-200.patch b/target/linux/kirkwood/patches-5.15/103-iomega-ix2-200.patch
new file mode 100644 (file)
index 0000000..9313b4b
--- /dev/null
+++ b/target/linux/kirkwood/patches-5.15/103-iomega-ix2-200.patch
@@ -0,0 +1,67 @@
+--- a/arch/arm/boot/dts/kirkwood-iomega_ix2_200.dts
++++ b/arch/arm/boot/dts/kirkwood-iomega_ix2_200.dts
+@@ -8,6 +8,13 @@
+       model = "Iomega StorCenter ix2-200";
+       compatible = "iom,ix2-200", "marvell,kirkwood-88f6281", "marvell,kirkwood";
+ 
++      aliases {
++              led-boot = &led_power;
++              led-failsafe = &led_health;
++              led-running = &led_power;
++              led-upgrade = &led_health;
++      };
++
+       memory {
+               device_type = "memory";
+               reg = <0x00000000 0x10000000>;
+@@ -127,16 +134,16 @@
+                             &pmx_led_rebuild &pmx_led_health >;
+               pinctrl-names = "default";
+ 
+-              power_led {
++              led_power: power_led {
+                       label = "status:white:power_led";
+                       gpios = <&gpio0 16 GPIO_ACTIVE_HIGH>;
+-                      default-state = "keep";
++                      default-state = "on";
+               };
+               rebuild_led {
+                       label = "status:white:rebuild_led";
+                       gpios = <&gpio1 4 GPIO_ACTIVE_HIGH>;
+               };
+-              health_led {
++              led_health: health_led {
+                       label = "status:red:health_led";
+                       gpios = <&gpio1 5 GPIO_ACTIVE_HIGH>;
+               };
+@@ -186,18 +193,18 @@
+       };
+ 
+       partition@a0000 {
+-              label = "env";
++              label = "u-boot environment";
+               reg = <0xa0000 0x20000>;
+               read-only;
+       };
+ 
+       partition@100000 {
+-              label = "uImage";
++              label = "kernel";
+               reg = <0x100000 0x300000>;
+       };
+ 
+       partition@400000 {
+-              label = "rootfs";
++              label = "ubi";
+               reg = <0x400000 0x1C00000>;
+       };
+ };
+@@ -211,7 +218,7 @@
+ };
+ 
+ &eth0 {
+-      status = "okay";
++      status = "disabled";
+       ethernet0-port@0 {
+               speed = <1000>;
+               duplex = <1>;