-/dts-v1/;
-
-#include "mt7621.dtsi"
-
-#include <dt-bindings/input/input.h>
-#include <dt-bindings/gpio/gpio.h>
+#include "mt7621_mikrotik.dtsi"
/ {
compatible = "mikrotik,routerboard-m33g", "mediatek,mt7621-soc";
led-upgrade = &led_usr;
};
- chosen {
- bootargs = "console=ttyS0,115200";
- };
-
leds {
compatible = "gpio-leds";
led_usr: usr {
- label = "routerboard-m33g:green:usr";
+ label = "green:usr";
gpios = <&gpio 0 GPIO_ACTIVE_HIGH>;
};
};
- keys {
- compatible = "gpio-keys";
-
- res {
- label = "res";
- gpios = <&gpio 18 GPIO_ACTIVE_LOW>;
- linux,code = <KEY_RESTART>;
- };
- };
-
pcie0_vcc_reg {
compatible = "regulator-fixed";
regulator-name = "pcie0_vcc";
};
&spi0 {
- status = "okay";
-
- flash@0 {
- compatible = "jedec,spi-nor";
- reg = <0>;
- spi-max-frequency = <3125000>;
-
- partitions {
- compatible = "fixed-partitions";
- #address-cells = <1>;
- #size-cells = <1>;
-
- partition@0 {
- label = "RouterBoot";
- reg = <0x0 0x40000>;
- read-only;
- compatible = "mikrotik,routerboot-partitions";
- #address-cells = <1>;
- #size-cells = <1>;
-
- partition@0 {
- label = "bootloader1";
- reg = <0x0 0x0>;
- read-only;
- };
-
- hard_config: hard_config {
- read-only;
- };
-
- partition@10000 {
- label = "bootloader2";
- reg = <0x10000 0xf000>;
- read-only;
- };
-
- soft_config {
- };
-
- partition@30000 {
- label = "bios";
- reg = <0x30000 0x1000>;
- read-only;
- };
- };
- };
- };
-
flash@1 {
compatible = "jedec,spi-nor";
reg = <1>;
- // XXX empiric value to obtain actual 10MHz SCK at the chip
- spi-max-frequency = <3125000>;
+ spi-max-frequency = <33000000>;
partitions {
compatible = "fixed-partitions";
partition@40000 {
compatible = "mikrotik,minor";
label = "firmware";
- reg = <0x040000 0xFC0000>;
+ reg = <0x040000 0xfc0000>;
};
};
};
};
+&gmac1 {
+ status = "okay";
+ label = "wan";
+ phy-handle = <ðphy0>;
+};
+
+&mdio {
+ ethphy0: ethernet-phy@0 {
+ reg = <0>;
+ };
+};
+
&switch0 {
ports {
- port@0 {
- status = "okay";
- label = "wan";
- };
-
port@1 {
status = "okay";
label = "lan1";
&pcie {
status = "okay";
};
+
+&uartlite3 {
+ status = "okay";
+};