kirkwood: remove support for kernel 4.14

[openwrt/staging/wigyori.git] / target / linux / kirkwood / patches-4.14 / 103-iomega-ix2-200.patch

diff --git a/target/linux/kirkwood/patches-4.14/103-iomega-ix2-200.patch b/target/linux/kirkwood/patches-4.14/103-iomega-ix2-200.patch
deleted file mode 100644 (file)
index 9313b4b..0000000
--- a/target/linux/kirkwood/patches-4.14/103-iomega-ix2-200.patch
+++ /dev/null
@@ -1,67 +0,0 @@
---- a/arch/arm/boot/dts/kirkwood-iomega_ix2_200.dts
-+++ b/arch/arm/boot/dts/kirkwood-iomega_ix2_200.dts
-@@ -8,6 +8,13 @@
-       model = "Iomega StorCenter ix2-200";
-       compatible = "iom,ix2-200", "marvell,kirkwood-88f6281", "marvell,kirkwood";
- 
-+      aliases {
-+              led-boot = &led_power;
-+              led-failsafe = &led_health;
-+              led-running = &led_power;
-+              led-upgrade = &led_health;
-+      };
-+
-       memory {
-               device_type = "memory";
-               reg = <0x00000000 0x10000000>;
-@@ -127,16 +134,16 @@
-                             &pmx_led_rebuild &pmx_led_health >;
-               pinctrl-names = "default";
- 
--              power_led {
-+              led_power: power_led {
-                       label = "status:white:power_led";
-                       gpios = <&gpio0 16 GPIO_ACTIVE_HIGH>;
--                      default-state = "keep";
-+                      default-state = "on";
-               };
-               rebuild_led {
-                       label = "status:white:rebuild_led";
-                       gpios = <&gpio1 4 GPIO_ACTIVE_HIGH>;
-               };
--              health_led {
-+              led_health: health_led {
-                       label = "status:red:health_led";
-                       gpios = <&gpio1 5 GPIO_ACTIVE_HIGH>;
-               };
-@@ -186,18 +193,18 @@
-       };
- 
-       partition@a0000 {
--              label = "env";
-+              label = "u-boot environment";
-               reg = <0xa0000 0x20000>;
-               read-only;
-       };
- 
-       partition@100000 {
--              label = "uImage";
-+              label = "kernel";
-               reg = <0x100000 0x300000>;
-       };
- 
-       partition@400000 {
--              label = "rootfs";
-+              label = "ubi";
-               reg = <0x400000 0x1C00000>;
-       };
- };
-@@ -211,7 +218,7 @@
- };
- 
- &eth0 {
--      status = "okay";
-+      status = "disabled";
-       ethernet0-port@0 {
-               speed = <1000>;
-               duplex = <1>;