include/configs/apalis-tk1.h

   1 /* SPDX-License-Identifier: GPL-2.0+ */
   2 /*
   3  * Copyright (c) 2017 Toradex, Inc.
   4  *
   5  * Configuration settings for the Toradex Apalis TK1 modules.
   6  */
   7
   8 #ifndef __CONFIG_H
   9 #define __CONFIG_H
  10
  11 #include <linux/sizes.h>
  12
  13 #include "tegra124-common.h"
  14
  15 #define CONFIG_ARCH_MISC_INIT
  16
  17 /* Board-specific serial config */
  18 #define CONFIG_TEGRA_ENABLE_UARTA
  19 #define CONFIG_SYS_NS16550_COM1         NV_PA_APB_UARTA_BASE
  20
  21 /* Environment in eMMC, before config block at the end of 1st "boot sector" */
  22 #define CONFIG_ENV_OFFSET               (-CONFIG_ENV_SIZE + \
  23                                          CONFIG_TDX_CFG_BLOCK_OFFSET)
  24 #define CONFIG_SYS_MMC_ENV_DEV          0
  25 #define CONFIG_SYS_MMC_ENV_PART         1
  26
  27 /* PCI host support */
  28 #undef CONFIG_PCI_SCAN_SHOW
  29
  30 /* PCI networking support */
  31 #define CONFIG_E1000_NO_NVM
  32
  33 /* General networking support */
  34 #define CONFIG_TFTP_BLOCKSIZE           16352
  35 #define CONFIG_TFTP_TSIZE
  36
  37 #undef CONFIG_IPADDR
  38 #define CONFIG_IPADDR           192.168.10.2
  39 #define CONFIG_NETMASK          255.255.255.0
  40 #undef CONFIG_SERVERIP
  41 #define CONFIG_SERVERIP         192.168.10.1
  42
  43 #define DFU_ALT_EMMC_INFO       "apalis-tk1.img raw 0x0 0x500 mmcpart 1; " \
  44                                 "boot part 0 1 mmcpart 0; " \
  45                                 "rootfs part 0 2 mmcpart 0; " \
  46                                 "uImage fat 0 1 mmcpart 0; " \
  47                                 "tegra124-apalis-eval.dtb fat 0 1 mmcpart 0"
  48
  49 #define EMMC_BOOTCMD \
  50         "set_emmcargs=setenv emmcargs ip=off root=PARTUUID=${uuid} " \
  51                 "ro rootfstype=ext4 rootwait\0" \
  52         "emmcboot=run setup; run emmcfinduuid; run set_emmcargs; " \
  53                 "setenv bootargs ${defargs} ${emmcargs} " \
  54                 "${setupargs} ${vidargs}; echo Booting from internal eMMC; " \
  55                 "run emmcdtbload; " \
  56                 "load mmc ${emmcdev}:${emmcbootpart} ${kernel_addr_r} " \
  57                 "${boot_file} && run fdt_fixup && " \
  58                 "bootm ${kernel_addr_r} - ${dtbparam}\0" \
  59         "emmcbootpart=1\0" \
  60         "emmcdev=0\0" \
  61         "emmcdtbload=setenv dtbparam; load mmc ${emmcdev}:${emmcbootpart} " \
  62                 "${fdt_addr_r} ${soc}-apalis-${fdt_board}.dtb && " \
  63                 "setenv dtbparam ${fdt_addr_r}\0" \
  64         "emmcfinduuid=part uuid mmc ${mmcdev}:${emmcrootpart} uuid\0" \
  65         "emmcrootpart=2\0"
  66
  67 #define NFS_BOOTCMD \
  68         "nfsargs=ip=:::::eth0:on root=/dev/nfs rw\0" \
  69         "nfsboot=pci enum; run setup; setenv bootargs ${defargs} ${nfsargs} " \
  70                 "${setupargs} ${vidargs}; echo Booting via DHCP/TFTP/NFS...; " \
  71                 "run nfsdtbload; dhcp ${kernel_addr_r} " \
  72                 "&& run fdt_fixup && bootm ${kernel_addr_r} - ${dtbparam}\0" \
  73         "nfsdtbload=setenv dtbparam; tftp ${fdt_addr_r} " \
  74                 "${soc}-apalis-${fdt_board}.dtb " \
  75                 "&& setenv dtbparam ${fdt_addr_r}\0"
  76
  77 #define SD_BOOTCMD \
  78         "set_sdargs=setenv sdargs ip=off root=PARTUUID=${uuid} ro " \
  79         "rootfstype=ext4 rootwait\0" \
  80         "sdboot=run setup; run sdfinduuid; run set_sdargs; " \
  81                 "setenv bootargs ${defargs} ${sdargs} ${setupargs} " \
  82                 "${vidargs}; echo Booting from SD card in 8bit slot...; " \
  83                 "run sddtbload; load mmc ${sddev}:${sdbootpart} " \
  84                 "${kernel_addr_r} ${boot_file} && run fdt_fixup && " \
  85                 "bootm ${kernel_addr_r} - ${dtbparam}\0" \
  86         "sdbootpart=1\0" \
  87         "sddev=1\0" \
  88         "sddtbload=setenv dtbparam; load mmc ${sddev}:${sdbootpart} " \
  89                 "${fdt_addr_r} ${soc}-apalis-${fdt_board}.dtb " \
  90                 "&& setenv dtbparam ${fdt_addr_r}\0" \
  91         "sdfinduuid=part uuid mmc ${sddev}:${sdrootpart} uuid\0" \
  92         "sdrootpart=2\0"
  93
  94 #define USB_BOOTCMD \
  95         "set_usbargs=setenv usbargs ip=off root=PARTUUID=${uuid} ro " \
  96                 "rootfstype=ext4 rootwait\0" \
  97         "usbboot=run setup; usb start; run usbfinduuid; run set_usbargs; " \
  98                 "setenv bootargs ${defargs} ${setupargs} " \
  99                 "${usbargs} ${vidargs}; echo Booting from USB stick...; " \
 100                 "run usbdtbload; load usb ${usbdev}:${usbbootpart} " \
 101                 "${kernel_addr_r} ${boot_file} && run fdt_fixup && " \
 102                 "bootm ${kernel_addr_r} - ${dtbparam}\0" \
 103         "usbbootpart=1\0" \
 104         "usbdev=0\0" \
 105         "usbdtbload=setenv dtbparam; load usb ${usbdev}:${usbbootpart} " \
 106                 "${fdt_addr_r} ${soc}-apalis-${fdt_board}.dtb " \
 107                 "&& setenv dtbparam ${fdt_addr_r}\0" \
 108         "usbfinduuid=part uuid usb ${usbdev}:${usbrootpart} uuid\0" \
 109         "usbrootpart=2\0"
 110
 111 #define BOARD_EXTRA_ENV_SETTINGS \
 112         "boot_file=uImage\0" \
 113         "console=ttyS0\0" \
 114         "defargs=lp0_vec=2064@0xf46ff000 core_edp_mv=1150 core_edp_ma=4000 " \
 115                 "usb_port_owner_info=2 lane_owner_info=6 emc_max_dvfs=0\0" \
 116         "dfu_alt_info=" DFU_ALT_EMMC_INFO "\0" \
 117         EMMC_BOOTCMD \
 118         "fdt_board=eval\0" \
 119         "fdt_fixup=;\0" \
 120         NFS_BOOTCMD \
 121         SD_BOOTCMD \
 122         USB_BOOTCMD \
 123         "setethupdate=if env exists ethaddr; then; else setenv ethaddr " \
 124                 "00:14:2d:00:00:00; fi; pci enum && tftpboot ${loadaddr} " \
 125                 "flash_eth.img && source ${loadaddr}\0" \
 126         "setsdupdate=setenv interface mmc; setenv drive 1; mmc rescan; " \
 127                 "load ${interface} ${drive}:1 ${loadaddr} flash_blk.img " \
 128                 "|| setenv drive 2; mmc rescan; load ${interface} ${drive}:1 " \
 129                 "${loadaddr} flash_blk.img && " \
 130                 "source ${loadaddr}\0" \
 131         "setup=setenv setupargs igb_mac=${ethaddr} " \
 132                 "consoleblank=0 no_console_suspend=1 console=tty1 " \
 133                 "console=${console},${baudrate}n8 debug_uartport=lsport,0 " \
 134                 "${memargs}\0" \
 135         "setupdate=run setsdupdate || run setusbupdate || run setethupdate\0" \
 136         "setusbupdate=usb start && setenv interface usb; setenv drive 0; " \
 137                 "load ${interface} ${drive}:1 ${loadaddr} flash_blk.img && " \
 138                 "source ${loadaddr}\0" \
 139         USB_BOOTCMD \
 140         "vidargs=video=tegrafb0:640x480-16@60 fbcon=map:1\0"
 141
 142 /* Increase console I/O buffer size */
 143 #undef CONFIG_SYS_CBSIZE
 144 #define CONFIG_SYS_CBSIZE               1024
 145
 146 /* Increase arguments buffer size */
 147 #undef CONFIG_SYS_BARGSIZE
 148 #define CONFIG_SYS_BARGSIZE CONFIG_SYS_CBSIZE
 149
 150 /* Increase maximum number of arguments */
 151 #undef CONFIG_SYS_MAXARGS
 152 #define CONFIG_SYS_MAXARGS              32
 153
 154 #define CONFIG_CMD_TIME
 155
 156 #define CONFIG_SYS_BOOT_RAMDISK_HIGH
 157
 158 #include "tegra-common-usb-gadget.h"
 159 #include "tegra-common-post.h"
 160
 161 /* Reserve top 1M for secure RAM */
 162 #define CONFIG_ARMV7_SECURE_BASE                0xfff00000
 163 #define CONFIG_ARMV7_SECURE_RESERVE_SIZE        0x00100000
 164
 165 #endif /* __CONFIG_H */