1 // SPDX-License-Identifier: GPL-2.0-only
5 #include <dt-bindings/gpio/gpio.h>
6 #include <dt-bindings/input/input.h>
9 model = "TP-Link TL-MR3040 V2";
10 compatible = "tplink,tl-mr3040-v2", "qca,ar9331";
15 led-failsafe = &led_lan;
16 label-mac-device = ð0;
20 compatible = "gpio-leds";
22 pinctrl-names = "default";
23 pinctrl-0 = <&switch_led_disable_pins>;
26 label = "tp-link:green:wlan";
27 gpios = <&gpio 26 GPIO_ACTIVE_LOW>;
28 linux,default-trigger = "phy0tpt";
32 label = "tp-link:green:lan";
33 gpios = <&gpio 17 GPIO_ACTIVE_LOW>;
37 label = "tp-link:green:3g";
38 gpios = <&gpio 27 GPIO_ACTIVE_LOW>;
39 trigger-sources = <&hub_port>;
40 linux,default-trigger = "usbport";
45 compatible = "gpio-keys";
49 linux,code = <KEY_RESTART>;
50 gpios = <&gpio 11 GPIO_ACTIVE_HIGH>;
51 debounce-interval = <60>;
56 linux,input-type = <EV_SW>;
58 gpios = <&gpio 19 GPIO_ACTIVE_HIGH>;
59 debounce-interval = <60>;
64 linux,input-type = <EV_SW>;
66 gpios = <&gpio 20 GPIO_ACTIVE_HIGH>;
67 debounce-interval = <60>;
71 reg_usb_vbus: reg_usb_vbus {
72 compatible = "regulator-fixed";
73 regulator-name = "usb_vbus";
74 regulator-min-microvolt = <5000000>;
75 regulator-max-microvolt = <5000000>;
76 gpio = <&gpio 18 GPIO_ACTIVE_HIGH>;
82 clock-frequency = <25000000>;
93 vbus-supply = <®_usb_vbus>;
98 #trigger-source-cells = <0>;
109 num-chipselects = <1>;
112 compatible = "jedec,spi-nor";
113 spi-max-frequency = <50000000>;
117 compatible = "fixed-partitions";
118 #address-cells = <1>;
123 reg = <0x000000 0x020000>;
128 compatible = "tplink,firmware";
130 reg = <0x020000 0x3d0000>;
133 art: partition@3f0000 {
135 reg = <0x3f0000 0x010000>;
145 mtd-mac-address = <&uboot 0x1fc00>;
149 switch-phy-addr-swap = <0>;
150 switch-phy-swap = <0>;
157 compatible = "syscon", "simple-mfd";
163 mtd-cal-data = <&art 0x1000>;
164 mtd-mac-address = <&uboot 0x1fc00>;