1 // SPDX-License-Identifier: GPL-2.0-or-later OR MIT
3 #include <dt-bindings/leds/common.h>
5 #include "qca9556_avm_fritz-repeater.dtsi"
8 compatible = "avm,fritzdvbc", "qca,qca9556";
9 model = "AVM FRITZ!WLAN Repeater DVB-C";
12 led-boot = &led_power;
13 led-failsafe = &led_power;
14 led-running = &led_power;
15 led-upgrade = &led_power;
19 compatible = "spi-gpio";
23 sck-gpios = <&gpio 14 GPIO_ACTIVE_LOW>;
24 mosi-gpios = <&gpio 15 GPIO_ACTIVE_LOW>;
25 num-chipselects = <0>;
27 spi_gpio: led_gpio@0 {
28 compatible = "fairchild,74hc595";
32 registers-number = <2>;
33 spi-max-frequency = <10000000>;
37 gpios = <16 GPIO_ACTIVE_HIGH>;
39 line-name = "gpio-latch-bit";
45 * GPIO pins 100 or greater in the vendor GPL dump are redirected
46 * to the shift register.
47 * So OEM source pin 100 becomes 0 on the SR and so forth.
50 compatible = "gpio-leds";
53 function = LED_FUNCTION_POWER;
54 color = <LED_COLOR_ID_GREEN>;
55 gpios = <&spi_gpio 6 GPIO_ACTIVE_LOW>;
59 function = LED_FUNCTION_WLAN;
60 color = <LED_COLOR_ID_GREEN>;
61 gpios = <&spi_gpio 7 GPIO_ACTIVE_LOW>;
62 linux,default-trigger = "phy1tpt";
67 gpios = <&spi_gpio 5 GPIO_ACTIVE_LOW>;
71 label = "green:rssihigh";
72 gpios = <&spi_gpio 1 GPIO_ACTIVE_LOW>;
76 label = "green:rssimediumhigh";
77 gpios = <&spi_gpio 2 GPIO_ACTIVE_LOW>;
81 label = "green:rssimedium";
82 gpios = <&spi_gpio 3 GPIO_ACTIVE_LOW>;
86 label = "green:rssimediumlow";
87 gpios = <&spi_gpio 4 GPIO_ACTIVE_LOW>;
91 label = "green:rssilow";
92 gpios = <&spi_gpio 0 GPIO_ACTIVE_LOW>;
101 compatible = "qcom,ath10k";
102 reg = <0x0000 0 0 0 0>;
103 nvmem-cells = <&cal_urlader_198a>;
104 nvmem-cell-names = "calibration";
111 gpios = <109 GPIO_ACTIVE_HIGH>;
113 line-name = "PCIE EP reset";
118 gpios = <110 GPIO_ACTIVE_HIGH>;
120 line-name = "PCIE Bus reset";