target/linux/ath79/dts/qca9558_ocedo_ursus.dts

   1 // SPDX-License-Identifier: GPL-2.0-or-later OR MIT
   2
   3 #include "qca955x.dtsi"
   4
   5 #include <dt-bindings/gpio/gpio.h>
   6 #include <dt-bindings/input/input.h>
   7
   8 / {
   9         compatible = "ocedo,ursus", "qca,qca9558";
  10         model = "OCEDO Ursus";
  11
  12         leds {
  13                 compatible = "gpio-leds";
  14
  15                 wifi2 {
  16                         label = "green:wlan2g";
  17                         gpios = <&gpio 14 GPIO_ACTIVE_LOW>;
  18                         linux,default-trigger = "phy1tpt";
  19                 };
  20
  21                 wifi5 {
  22                         label = "green:wlan5g";
  23                         gpios = <&gpio 15 GPIO_ACTIVE_LOW>;
  24                         linux,default-trigger = "phy0tpt";
  25                 };
  26         };
  27 };
  28
  29 &pcie1 {
  30         status = "okay";
  31 };
  32
  33 &spi {
  34         status = "okay";
  35
  36         flash@0 {
  37                 compatible = "jedec,spi-nor";
  38                 reg = <0>;
  39                 spi-max-frequency = <50000000>;
  40
  41                 partitions {
  42                         compatible = "fixed-partitions";
  43                         #address-cells = <1>;
  44                         #size-cells = <1>;
  45
  46                         uboot: partition@0 {
  47                                 label = "u-boot";
  48                                 reg = <0x000000 0x040000>;
  49                                 read-only;
  50                         };
  51
  52                         partition@40000 {
  53                                 label = "u-boot-env";
  54                                 reg = <0x040000 0x010000>;
  55                         };
  56
  57                         partition@50000 {
  58                                 compatible = "denx,uimage";
  59                                 label = "firmware";
  60                                 reg = <0x050000 0x740000>;
  61                         };
  62
  63                         partition@790000 {
  64                                 label = "vendor";
  65                                 reg = <0x790000 0x740000>;
  66                                 read-only;
  67                         };
  68
  69                         partition@ed0000 {
  70                                 label = "data";
  71                                 reg = <0xed0000 0x110000>;
  72                                 read-only;
  73                         };
  74
  75                         partition@fe0000 {
  76                                 label = "id";
  77                                 reg = <0xfe0000 0x010000>;
  78                                 read-only;
  79                         };
  80
  81                         art: partition@ff0000 {
  82                                 label = "art";
  83                                 reg = <0xff0000 0x010000>;
  84                                 read-only;
  85                         };
  86                 };
  87         };
  88 };
  89
  90 &wmac {
  91         status = "okay";
  92
  93         mtd-cal-data = <&art 0x1000>;
  94         nvmem-cells = <&macaddr_art_6>;
  95         nvmem-cell-names = "mac-address";
  96 };
  97
  98 &mdio0 {
  99         status = "okay";
 100
 101         phy1: ethernet-phy@1 {
 102                 reg = <1>;
 103         };
 104
 105         phy2: ethernet-phy@2 {
 106                 reg = <2>;
 107                 at803x-override-sgmii-link-check;
 108         };
 109 };
 110
 111 &eth0 {
 112         status = "okay";
 113         nvmem-cells = <&macaddr_art_0>;
 114         nvmem-cell-names = "mac-address";
 115
 116         phy-mode = "rgmii-rxid";
 117         phy-handle = <&phy1>;
 118         pll-data = <0x8e000000 0x80000101 0x80001313>;
 119
 120         gmac_config: gmac-config {
 121                 device = <&gmac>;
 122
 123                 rxdv-delay = <3>;
 124                 rxd-delay = <3>;
 125                 txen-delay = <0>;
 126                 txd-delay = <0>;
 127                 rgmii-enabled = <1>;
 128         };
 129 };
 130
 131 &eth1 {
 132         status = "okay";
 133         nvmem-cells = <&macaddr_art_12>;
 134         nvmem-cell-names = "mac-address";
 135         phy-handle = <&phy2>;
 136         pll-data = <0x3000101 0x101 0x1313>;
 137         qca955x-sgmii-fixup;
 138 };
 139
 140 &art {
 141         compatible = "nvmem-cells";
 142         #address-cells = <1>;
 143         #size-cells = <1>;
 144
 145         macaddr_art_0: macaddr@0 {
 146                 reg = <0x0 0x6>;
 147         };
 148
 149         macaddr_art_6: macaddr@6 {
 150                 reg = <0x6 0x6>;
 151         };
 152
 153         macaddr_art_12: macaddr@12 {
 154                 reg = <0x12 0x6>;
 155         };
 156 };