1 #include "qcom-ipq8064-v1.0.dtsi"
4 model = "Qualcomm IPQ8064/DB149";
5 compatible = "qcom,ipq8064-db149", "qcom,ipq8064";
12 reg = <0x41200000 0x300000>;
23 stdout-path = "serial0:115200n8";
28 i2c4_pins: i2c4_pinmux {
29 pins = "gpio12", "gpio13";
36 pins = "gpio18", "gpio19", "gpio21";
38 drive-strength = <10>;
43 mdio0_pins: mdio0_pins {
45 pins = "gpio0", "gpio1";
52 rgmii0_pins: rgmii0_pins {
54 pins = "gpio2", "gpio66";
62 qcom,mode = <GSBI_PROT_I2C_UART>;
64 uart2: serial@12490000 {
70 qcom,mode = <GSBI_PROT_SPI>;
75 spi-max-frequency = <50000000>;
77 pinctrl-0 = <&spi_pins>;
78 pinctrl-names = "default";
80 cs-gpios = <&qcom_pinmux 20 0>;
83 compatible = "s25fl256s1";
86 spi-max-frequency = <50000000>;
91 label = "lowlevel_init";
97 reg = <0x1b0000 0x80000>;
101 label = "u-boot-env";
102 reg = <0x230000 0x40000>;
107 reg = <0x270000 0x40000>;
112 reg = <0x2b0000 0x1d50000>;
149 pinctrl-0 = <&mdio0_pins>;
150 pinctrl-names = "default";
152 phy0: ethernet-phy@0 {
154 qca,ar8327-initvals = <
155 0x00004 0x7600000 /* PAD0_MODE */
156 0x00008 0x1000000 /* PAD5_MODE */
157 0x0000c 0x80 /* PAD6_MODE */
158 0x000e4 0x6a545 /* MAC_POWER_SEL */
159 0x000e0 0xc74164de /* SGMII_CTRL */
160 0x0007c 0x4e /* PORT0_STATUS */
161 0x00094 0x4e /* PORT6_STATUS */
165 phy4: ethernet-phy@4 {
169 phy6: ethernet-phy@6 {
173 phy7: ethernet-phy@7 {
182 phy-handle = <&phy4>;
184 pinctrl-0 = <&rgmii0_pins>;
185 pinctrl-names = "default";
203 phy-handle = <&phy6>;
210 phy-handle = <&phy7>;