3 #include "kirkwood.dtsi"
4 #include "kirkwood-6281.dtsi"
7 model = "Seagate GoFlex Home";
8 compatible = "seagate,goflexhome", "marvell,kirkwood-88f6281", "marvell,kirkwood";
11 led-boot = &led_health;
12 led-failsafe = &led_fault;
13 led-running = &led_health;
14 led-upgrade = &led_fault;
18 device_type = "memory";
19 reg = <0x00000000 0x8000000>;
23 bootargs = "console=ttyS0,115200n8 earlyprintk root=/dev/sda1 rootdelay=10";
28 pinctrl: pin-controller@10000 {
29 pmx_usb_power_enable: pmx-usb-power-enable {
30 marvell,pins = "mpp29";
31 marvell,function = "gpio";
34 pmx_led_white: pmx-led-white {
35 marvell,pins = "mpp40";
36 marvell,function = "gpio";
39 pmx_led_green: pmx-led_green {
40 marvell,pins = "mpp46";
41 marvell,function = "gpio";
44 pmx_led_orange: pmx-led-orange {
45 marvell,pins = "mpp47";
46 marvell,function = "gpio";
61 compatible = "gpio-leds";
64 label = "status:green:health";
65 gpios = <&gpio1 14 GPIO_ACTIVE_LOW>;
70 label = "status:orange:fault";
71 gpios = <&gpio1 15 GPIO_ACTIVE_LOW>;
75 label = "status:white:misc";
76 gpios = <&gpio1 8 GPIO_ACTIVE_LOW>;
77 linux,default-trigger = "disk-activity";
82 compatible = "simple-bus";
87 pinctrl-0 = <&pmx_usb_power_enable>;
88 pinctrl-names = "default";
90 usb_power: regulator@1 {
91 compatible = "regulator-fixed";
93 regulator-name = "USB Power";
94 regulator-min-microvolt = <5000000>;
95 regulator-max-microvolt = <5000000>;
99 gpio = <&gpio0 29 GPIO_ACTIVE_HIGH>;
111 reg = <0x0000000 0x0100000>;
117 reg = <0x0100000 0xff00000>;
124 ethphy0: ethernet-phy@0 {
133 phy-handle = <ðphy0>;