2 #include <dt-bindings/interrupt-controller/irq.h>
3 #include <dt-bindings/gpio/gpio.h>
6 compatible = "lantiq,falcon-easy98000", "lantiq,falcon";
9 bootargs-append = "console=ttyLTQ0,115200 init=/etc/preinit";
13 device_type = "memory";
14 reg = <0x0 0x4000000>;
18 compatible = "gpio-leds";
19 pinctrl-names = "default";
20 pinctrl-0 = <&bootled_pins>;
23 label = "easy98000:green:gpon";
24 gpios = <&gpio0 9 GPIO_ACTIVE_HIGH>;
25 default-state = "keep";
28 label = "easy98000:red:gpon";
29 gpios = <&gpio0 10 GPIO_ACTIVE_HIGH>;
30 default-state = "keep";
33 label = "easy98000:green:gpon_tx";
34 gpios = <&gpio0 11 GPIO_ACTIVE_HIGH>;
35 default-state = "keep";
38 label = "easy98000:green:gpon_rx";
39 gpios = <&gpio0 12 GPIO_ACTIVE_HIGH>;
40 default-state = "keep";
43 label = "easy98000:green:voice";
44 gpios = <&gpio0 13 GPIO_ACTIVE_HIGH>;
45 default-state = "keep";
48 label = "easy98000:green:status";
49 gpios = <&gpio0 14 GPIO_ACTIVE_HIGH>;
50 default-state = "keep";
56 eth0: ethernet@0000000 {
57 compatible = "davicom,dm9000";
58 device_type = "network";
59 reg = <0x0000003 0x1>, <0x0000001 0x1>;
60 reg-names = "addr", "data";
61 interrupt-parent = <&gpio1>;
62 #interrupt-cells = <2>;
63 interrupts = <10 IRQ_TYPE_LEVEL_LOW>;
64 local-mac-address = [ 00 00 00 00 00 00 ];
68 compatible = "lantiq,easy98000_addon";
69 reg = <0x3c00000 0x2>;
73 compatible = "lantiq,easy98000_cpld_led";
74 reg = <0x3c0000c 0x2>, <0x3c00012 0x2>;
78 /* // enable this for second uart:
87 compatible = "atmel,at25", "atmel,at25160n";
89 spi-max-frequency = <1000000>;
102 clock-frequency = <100000>;
104 /* eeprom-emulation by OMU */
106 compatible = "at,24c02";
110 compatible = "at,24c02";