3 #include <dt-bindings/gpio/gpio.h>
4 #include <dt-bindings/input/input.h>
7 compatible = "belkin,f5d8235-v2", "ralink,rt3052-soc";
8 model = "Belkin F5D8235 v2";
11 led-boot = &led_router;
12 led-failsafe = &led_router;
13 led-running = &led_router;
14 led-upgrade = &led_router;
18 compatible = "cfi-flash";
19 reg = <0x1f000000 0x800000>;
24 compatible = "fixed-partitions";
34 compatible = "fixed-layout";
38 eeprom_uboot_40000: eeprom@40000 {
39 reg = <0x40000 0x200>;
42 macaddr_uboot_40004: macaddr@40004 {
49 compatible = "denx,uimage";
51 reg = <0x50000 0x790000>;
56 reg = <0x7e0000 0x10000>;
61 reg = <0x7f0000 0x10000>;
67 compatible = "realtek,rtl8366rb";
68 gpio-sda = <&gpio0 1 GPIO_ACTIVE_HIGH>;
69 gpio-sck = <&gpio0 2 GPIO_ACTIVE_HIGH>;
73 compatible = "gpio-leds";
76 label = "blue:internet";
77 gpios = <&gpio0 5 GPIO_ACTIVE_LOW>;
81 label = "amber:internet";
82 gpios = <&gpio0 6 GPIO_ACTIVE_LOW>;
87 gpios = <&gpio0 11 GPIO_ACTIVE_LOW>;
91 label = "amber:modem";
92 gpios = <&gpio0 8 GPIO_ACTIVE_LOW>;
96 label = "blue:router";
97 gpios = <&gpio0 9 GPIO_ACTIVE_LOW>;
101 label = "blue:storage";
102 gpios = <&gpio0 23 GPIO_ACTIVE_LOW>;
103 trigger-sources = <&otg_port1>;
104 linux,default-trigger = "usbport";
108 label = "amber:storage";
109 gpios = <&gpio0 22 GPIO_ACTIVE_LOW>;
113 label = "blue:security";
114 gpios = <&gpio0 13 GPIO_ACTIVE_LOW>;
118 label = "amber:security";
119 gpios = <&gpio0 12 GPIO_ACTIVE_LOW>;
126 groups = "spi", "i2c", "jtag", "mdio", "uartf";
132 nvmem-cells = <&macaddr_uboot_40004>;
133 nvmem-cell-names = "mac-address";
134 pinctrl-names = "default";
135 pinctrl-0 = <&rgmii_pins>;
140 mediatek,portmap = <0x3f>;
141 ralink,fct2 = <0x0002500c>;
143 * ext phy base addr 31, rx/tx clock skew 0,
144 * turbo mii off, rgmi 3.3v off, port 5 polling off
145 * port5: enabled, gige, full-duplex, rx/tx-flow-control
146 * port6: enabled, gige, full-duplex, rx/tx-flow-control
148 ralink,fpa2 = <0x1f003fff>;
152 nvmem-cells = <&eeprom_uboot_40000>;
153 nvmem-cell-names = "eeprom";