3 #include <dt-bindings/gpio/gpio.h>
4 #include <dt-bindings/input/input.h>
7 compatible = "sitecom,wl-351", "ralink,rt3052-soc";
8 model = "Sitecom WL-351 v1 002";
11 led-boot = &led_power;
12 led-failsafe = &led_power;
13 led-running = &led_power;
14 led-upgrade = &led_power;
18 compatible = "cfi-flash";
19 reg = <0x1f000000 0x800000>;
24 compatible = "fixed-partitions";
36 reg = <0x30000 0x10000>;
40 factory: partition@40000 {
42 reg = <0x40000 0x10000>;
47 compatible = "denx,uimage";
49 reg = <0x50000 0x3b0000>;
55 compatible = "gpio-leds";
58 label = "amber:power";
59 gpios = <&gpio0 8 GPIO_ACTIVE_LOW>;
63 label = "amber:unpopulated";
64 gpios = <&gpio0 12 GPIO_ACTIVE_LOW>;
68 label = "blue:unpopulated";
69 gpios = <&gpio0 13 GPIO_ACTIVE_LOW>;
74 compatible = "gpio-keys-polled";
79 gpios = <&gpio0 10 GPIO_ACTIVE_LOW>;
80 linux,code = <KEY_RESTART>;
85 gpios = <&gpio0 0 GPIO_ACTIVE_LOW>;
86 linux,code = <KEY_WPS_BUTTON>;
91 compatible = "realtek,rtl8366rb";
92 gpio-sda = <&gpio0 1 GPIO_ACTIVE_HIGH>;
93 gpio-sck = <&gpio0 2 GPIO_ACTIVE_HIGH>;
99 groups = "spi", "i2c", "jtag", "mdio", "uartf";
105 mtd-mac-address = <&factory 0x4>;
106 pinctrl-names = "default";
107 pinctrl-0 = <&rgmii_pins>;
112 mediatek,portmap = <0x3f>;
113 ralink,fct2 = <0x0002500c>;
115 * ext phy base addr 31, rx/tx clock skew 0,
116 * turbo mii off, rgmi 3.3v off, port 5 polling off
117 * port5: enabled, gige, full-duplex, rx/tx-flow-control
118 * port6: enabled, gige, full-duplex, rx/tx-flow-control
120 ralink,fpa2 = <0x1f003fff>;
124 ralink,mtd-eeprom = <&factory 0x0>;