3 #include <dt-bindings/gpio/gpio.h>
4 #include <dt-bindings/input/input.h>
7 compatible = "sitecom,wl-351", "ralink,rt3052-soc";
8 model = "Sitecom WL-351 v1 002";
11 led-boot = &led_power;
12 led-failsafe = &led_power;
13 led-running = &led_power;
14 led-upgrade = &led_power;
18 compatible = "cfi-flash";
19 reg = <0x1f000000 0x800000>;
24 compatible = "fixed-partitions";
36 reg = <0x30000 0x10000>;
40 factory: partition@40000 {
41 compatible = "nvmem-cells";
43 reg = <0x40000 0x10000>;
48 eeprom_factory_0: eeprom@0 {
52 macaddr_factory_4: macaddr@4 {
58 compatible = "denx,uimage";
60 reg = <0x50000 0x3b0000>;
66 compatible = "gpio-leds";
69 label = "amber:power";
70 gpios = <&gpio0 8 GPIO_ACTIVE_LOW>;
74 label = "amber:unpopulated";
75 gpios = <&gpio0 12 GPIO_ACTIVE_LOW>;
79 label = "blue:unpopulated";
80 gpios = <&gpio0 13 GPIO_ACTIVE_LOW>;
85 compatible = "gpio-keys-polled";
90 gpios = <&gpio0 10 GPIO_ACTIVE_LOW>;
91 linux,code = <KEY_RESTART>;
96 gpios = <&gpio0 0 GPIO_ACTIVE_LOW>;
97 linux,code = <KEY_WPS_BUTTON>;
102 compatible = "realtek,rtl8366rb";
103 gpio-sda = <&gpio0 1 GPIO_ACTIVE_HIGH>;
104 gpio-sck = <&gpio0 2 GPIO_ACTIVE_HIGH>;
110 groups = "spi", "i2c", "jtag", "mdio", "uartf";
116 nvmem-cells = <&macaddr_factory_4>;
117 nvmem-cell-names = "mac-address";
118 pinctrl-names = "default";
119 pinctrl-0 = <&rgmii_pins>;
124 mediatek,portmap = <0x3f>;
125 ralink,fct2 = <0x0002500c>;
127 * ext phy base addr 31, rx/tx clock skew 0,
128 * turbo mii off, rgmi 3.3v off, port 5 polling off
129 * port5: enabled, gige, full-duplex, rx/tx-flow-control
130 * port6: enabled, gige, full-duplex, rx/tx-flow-control
132 ralink,fpa2 = <0x1f003fff>;
136 nvmem-cells = <&eeprom_factory_0>;
137 nvmem-cell-names = "eeprom";