proto_config_add_boolean autoconnect
proto_config_add_int plmn
proto_config_add_int timeout
+ proto_config_add_int mtu
proto_config_add_defaults
}
proto_qmi_setup() {
local interface="$1"
local dataformat connstat
- local device apn auth username password pincode delay modes pdptype profile dhcpv6 autoconnect plmn timeout $PROTO_DEFAULT_OPTIONS
+ local device apn auth username password pincode delay modes pdptype
+ local profile dhcpv6 autoconnect plmn timeout mtu $PROTO_DEFAULT_OPTIONS
local ip4table ip6table
local cid_4 pdh_4 cid_6 pdh_6
local ip_6 ip_prefix_length gateway_6 dns1_6 dns2_6
- json_get_vars device apn auth username password pincode delay modes pdptype profile dhcpv6 autoconnect plmn ip4table ip6table timeout $PROTO_DEFAULT_OPTIONS
+
+ json_get_vars device apn auth username password pincode delay modes
+ json_get_vars pdptype profile dhcpv6 autoconnect plmn ip4table
+ json_get_vars ip6table timeout mtu $PROTO_DEFAULT_OPTIONS
[ "$timeout" = "" ] && timeout="10"
return 1
}
+ [ -n "$mtu" ] && {
+ echo "Setting MTU to $mtu"
+ /sbin/ip link set dev $ifname mtu $mtu
+ }
+
echo "Waiting for SIM initialization"
local uninitialized_timeout=0
while uqmi -s -d "$device" --get-pin-status | grep '"UIM uninitialized"' > /dev/null; do
fi
done
- if uqmi -s -d "$device" --get-pin-status | grep '"Not supported"' > /dev/null; then
+ if uqmi -s -d "$device" --get-pin-status | grep '"Not supported"\|"Invalid QMI command"' > /dev/null; then
[ -n "$pincode" ] && {
uqmi -s -d "$device" --verify-pin1 "$pincode" > /dev/null || uqmi -s -d "$device" --uim-verify-pin1 "$pincode" > /dev/null || {
echo "Unable to verify PIN"
}
proto_close_data
proto_send_update "$interface"
+
+ local zone="$(fw3 -q network "$interface" 2>/dev/null)"
+
[ -n "$pdh_6" ] && {
if [ -z "$dhcpv6" -o "$dhcpv6" = 0 ]; then
json_load "$(uqmi -s -d $device --set-client-id wds,$cid_6 --get-current-settings)"
proto_add_dns_server "$dns1_6"
proto_add_dns_server "$dns2_6"
}
+ [ -n "$zone" ] && {
+ proto_add_data
+ json_add_string zone "$zone"
+ proto_close_data
+ }
proto_send_update "$interface"
else
json_init
proto_add_dynamic_defaults
# RFC 7278: Extend an IPv6 /64 Prefix to LAN
json_add_string extendprefix 1
+ [ -n "$zone" ] && json_add_string zone "$zone"
json_close_object
ubus call network add_dynamic "$(json_dump)"
fi
json_add_string proto "dhcp"
[ -n "$ip4table" ] && json_add_string ip4table "$ip4table"
proto_add_dynamic_defaults
+ [ -n "$zone" ] && json_add_string zone "$zone"
json_close_object
ubus call network add_dynamic "$(json_dump)"
}