// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
-/dts-v1/;
+
+#include "ar9344.dtsi"
#include <dt-bindings/gpio/gpio.h>
#include <dt-bindings/input/input.h>
-#include "ar9344.dtsi"
-
/ {
model = "Winchannel WB2000";
compatible = "winchannel,wb2000", "qca,ar9344";
compatible = "gpio-leds";
wlan2g {
- label = "wb2000:green:2g";
+ label = "green:2g";
gpios = <&gpio 20 GPIO_ACTIVE_HIGH>;
linux,default-trigger = "phy0tpt";
};
usb {
- label = "wb2000:green:usb";
+ label = "green:usb";
gpios = <&gpio 21 GPIO_ACTIVE_HIGH>;
trigger-sources = <&hub_port1>, <&hub_port2>;
linux,default-trigger = "usbport";
};
led_system: system {
- label = "wb2000:green:system";
+ label = "green:system";
gpios = <&gpio 22 GPIO_ACTIVE_LOW>;
default-state = "on";
};
};
keys {
- compatible = "gpio-keys-polled";
- poll-interval = <50>;
+ compatible = "gpio-keys";
reset {
linux,code = <KEY_RESTART>;
compatible = "gpio-leds";
wlan {
- label = "wb2000:green:5g";
+ label = "green:5g";
gpios = <&ath9k 6 GPIO_ACTIVE_LOW>;
linux,default-trigger = "phy1tpt";
};
clock-frequency = <40000000>;
};
-&uart {
- status = "okay";
-};
-
&spi {
- num-cs = <1>;
-
status = "okay";
flash@0 {
reg = <0x0000 0 0 0 0>;
qca,no-eeprom;
mtd-mac-address = <&addr 0x0>;
- mtd-mac-address-increment = <0x10>;
+ mac-address-increment = <0x10>;
#gpio-cells = <2>;
gpio-controller;
};
pll-data = <0xe000000 0x04000101 0x04001313>;
mtd-mac-address = <&addr 0x0>;
- mtd-mac-address-increment = <0x21>;
+ mac-address-increment = <0x21>;
phy-mode = "rgmii-rxid";
phy-handle = <&phy4>;