qualcommax: remove usage of malibu_first_phy_addr

[openwrt/staging/jow.git] / target / linux / qualcommax / files / arch / arm64 / boot / dts / qcom / ipq8074-ess.dtsi

diff --git a/target/linux/qualcommax/files/arch/arm64/boot/dts/qcom/ipq8074-ess.dtsi b/target/linux/qualcommax/files/arch/arm64/boot/dts/qcom/ipq8074-ess.dtsi
index 6f98e01b9a58beb35891a3abf039f9a0c3aae9be..76838b86c579e54c3b9dd9a5f800429250b985b9 100644 (file)
--- a/target/linux/qualcommax/files/arch/arm64/boot/dts/qcom/ipq8074-ess.dtsi
+++ b/target/linux/qualcommax/files/arch/arm64/boot/dts/qcom/ipq8074-ess.dtsi
@@ -23,24 +23,6 @@
                switch_access_mode = "local bus";
                switch_cpu_bmp = <ESS_PORT0>;  /* cpu port bitmap */
                switch_inner_bmp = <ESS_PORT7>; /*inner port bitmap*/
-               /* This is a special binding that controls how the malibu PHY are
-                * init. This value reflect the PHY addr of the first malibu PHY.
-                * Malibu PHY are in a bundle of 5 PHY.
-                * Some device might have some port not connected.
-                * SSDK still needs the addrs of the first PHY (even if not connected)
-                * to correctly setup the malibu PHY.
-                *
-                * This is needed as previously SSDK based this on the port bmp, but
-                * this can be problematic now that we specify correct bmp.
-                *
-                * Most common configuration have the malibu PHY placed at 0.
-                * But some device might have it placed at address 16.
-                * To drive the correct value, check the port id of the malibu PHY
-                * and try to understand what is the first one in devices where some
-                * port are missing. port_phyinfo is normally the way to go to derive
-                * this value in the few special cases.
-                */
-               malibu_first_phy_addr = <0>;
                clocks = <&gcc GCC_CMN_12GPLL_AHB_CLK>,
                         <&gcc GCC_CMN_12GPLL_SYS_CLK>,
                         <&gcc GCC_UNIPHY0_AHB_CLK>,