ramips: Change all '/include/' clauses to '#include' so preprocessing can be done...

[openwrt/svn-archive/archive.git] / target / linux / ramips / dts / MT7620a_V22SG.dts

diff --git a/target/linux/ramips/dts/MT7620a_V22SG.dts b/target/linux/ramips/dts/MT7620a_V22SG.dts
index cec912df3b93aa9dd4f738638d43fbafa15cf039..8dff80d40aa6cb9ebd444249cb2258a9efbaeb3b 100644 (file)
--- a/target/linux/ramips/dts/MT7620a_V22SG.dts
+++ b/target/linux/ramips/dts/MT7620a_V22SG.dts
@@ -1,14 +1,11 @@
 /dts-v1/;
 
-/include/ "mt7620a.dtsi"
+#include "mt7620a.dtsi"
 
 / {
        compatible = "ralink,mt7620a-eval-board", "ralink,mt7620a-soc";
        model = "Ralink MT7620a V22SG High Power evaluation board";
 
-       /*palmbus@10000000 {
-       };*/
-
        pinctrl {
                state_default: pinctrl0 {
                        gpio {
@@ -20,11 +17,9 @@
 
        ethernet@10100000 {
                status = "okay";
-
                pinctrl-names = "default";
                pinctrl-0 = <&rgmii1_pins &rgmii2_pins &mdio_pins>;
-
-               ralink,port-map = "llllw";
+               mediatek,portmap = "llllw";
 
                port@4 {
                        status = "okay";
@@ -54,7 +49,7 @@
        };
 
        gsw@10110000 {
-               ralink,port4 = "gmac";
+               mediatek,port4 = "gmac";
        };
 
        pcie@10140000 {
@@ -74,11 +69,13 @@
                #address-cells = <1>;
                #size-cells = <0>;
                poll-interval = <20>;
+
                reset {
                        label = "reset";
                        gpios = <&gpio0 1 1>;
                        linux,code = <0x198>;
                };
+
                aoss {
                        label = "aoss";
                        gpios = <&gpio0 2 1>;
@@ -90,21 +87,25 @@
                #address-cells = <1>;
                #size-cells = <1>;
                compatible = "mtk,mt7620-nand";
+
                partition@0 {
                        label = "u-boot";
                        reg = <0x0 0x40000>;
                        read-only;
                };
+
                partition@40000 {
                        label = "u-boot-env";
                        reg = <0x40000 0x20000>;
                        read-only;
                };
+
                factory: partition@60000 {
                        label = "factory";
                        reg = <0x60000 0x20000>;
                        read-only;
                };
+
                partition@80000 {
                        label = "firmware";
                        reg = <0x80000 0x7f80000>;