The MAC addresses for lan/wan are swapped compared to the vendor
firmware. This adjusts to vendor configuration, which is:
lan *:7b label
wan *:7c label+1
2.4g *:7b label
5g *:7a label-1
Only one address is stored in <&mac 0x8>, corresponding to the label.
This has been checked on revisions v1, v2 and v3.
Since ar71xx calculates the ath10k MAC address based on the ethernet
addresses, the number there is adjusted, too.
Signed-off-by: Adrian Schmutzler <freifunk@adrianschmutzler.de>
ath10kcal_extract "art" 0x5000 0x2f20
ln -sf /lib/firmware/ath10k/pre-cal-pci-0000\:00\:00.0.bin \
/lib/firmware/ath10k/QCA9888/hw2.0/board.bin
ath10kcal_extract "art" 0x5000 0x2f20
ln -sf /lib/firmware/ath10k/pre-cal-pci-0000\:00\:00.0.bin \
/lib/firmware/ath10k/QCA9888/hw2.0/board.bin
- ath10kcal_patch_mac $(macaddr_add $(cat /sys/class/net/eth0/address) -1)
+ ath10kcal_patch_mac $(macaddr_add $(cat /sys/class/net/eth1/address) -1)
;;
cf-e385ac)
ath10kcal_extract "art" 0x5000 0x2f20
;;
cf-e385ac)
ath10kcal_extract "art" 0x5000 0x2f20
ath79_register_mdio(0, 0x0);
ath79_register_mdio(1, 0x0);
ath79_register_mdio(0, 0x0);
ath79_register_mdio(1, 0x0);
- ath79_init_mac(ath79_eth0_data.mac_addr, mac, 0);
- ath79_init_mac(ath79_eth1_data.mac_addr, mac, 1);
+ ath79_init_mac(ath79_eth1_data.mac_addr, mac, 0);
+ ath79_init_mac(ath79_eth0_data.mac_addr, mac, 1);
/* WAN port */
ath79_eth0_data.phy_if_mode = PHY_INTERFACE_MODE_MII;
/* WAN port */
ath79_eth0_data.phy_if_mode = PHY_INTERFACE_MODE_MII;
ath79_register_mdio(0, 0x0);
ath79_register_mdio(1, 0x0);
ath79_register_mdio(0, 0x0);
ath79_register_mdio(1, 0x0);
- ath79_init_mac(ath79_eth0_data.mac_addr, mac, 0);
- ath79_init_mac(ath79_eth1_data.mac_addr, mac, 1);
+ ath79_init_mac(ath79_eth1_data.mac_addr, mac, 0);
+ ath79_init_mac(ath79_eth0_data.mac_addr, mac, 1);
/* WAN port */
ath79_eth0_data.phy_if_mode = PHY_INTERFACE_MODE_MII;
/* WAN port */
ath79_eth0_data.phy_if_mode = PHY_INTERFACE_MODE_MII;