ifconfig is effectively deprecated for quite some time now. Let's
replace the remaining occurrences for our target setup by the
corresponding ip commands now.
Note that this does not touch ar71xx, as it will be dropped anyway,
and changing it would only make backports harder.
Signed-off-by: Adrian Schmutzler <freifunk@adrianschmutzler.de>
meraki,mr24|\
meraki,mx60)
mac_lan=$(mtd_get_mac_binary_ubi board-config 0x66)
meraki,mr24|\
meraki,mx60)
mac_lan=$(mtd_get_mac_binary_ubi board-config 0x66)
- [ -n "$mac_lan" ] && ifconfig eth0 hw ether "$mac_lan"
+ [ -n "$mac_lan" ] && ip link set eth0 address "$mac_lan"
if [ -e "/sys/bus/mdio_bus/drivers/Infineon ADM6996/0:00" -o \
-e "/sys/bus/mdio_bus/drivers/Marvell 88E6060/0:10" ]; then
vconfig set_name_type DEV_PLUS_VID_NO_PAD
if [ -e "/sys/bus/mdio_bus/drivers/Infineon ADM6996/0:00" -o \
-e "/sys/bus/mdio_bus/drivers/Marvell 88E6060/0:10" ]; then
vconfig set_name_type DEV_PLUS_VID_NO_PAD
vconfig add eth0 1
ifname=eth0.1
else
vconfig add eth0 1
ifname=eth0.1
else
}
fi
[ -n "$pi_ifname" ] && grep -q "$pi_ifname" /proc/net/dev && {
}
fi
[ -n "$pi_ifname" ] && grep -q "$pi_ifname" /proc/net/dev && {
- ifconfig $pi_ifname $pi_ip netmask $pi_netmask broadcast $pi_broadcast up
+ ip addr add $pi_ip/$pi_netmask broadcast $pi_broadcast dev $pi_ifname
+ ip link set $pi_ifname up
if [ -e "/sys/bus/mdio_bus/drivers/Infineon ADM6996/0:00" -o \
-e "/sys/bus/mdio_bus/drivers/Marvell 88E6060/0:10" ]; then
vconfig rem eth0.1 2>/dev/null
if [ -e "/sys/bus/mdio_bus/drivers/Infineon ADM6996/0:00" -o \
-e "/sys/bus/mdio_bus/drivers/Marvell 88E6060/0:10" ]; then
vconfig rem eth0.1 2>/dev/null
- ifconfig $pi_ifname down
+ ip link set $pi_ifname down
elif [ -n "$pi_ifname" ]; then
elif [ -n "$pi_ifname" ]; then
- ifconfig $pi_ifname 0.0.0.0
+ ip -4 addr flush dev $pi_ifname
+ ip link set $masterif up
}
boot_hook_add preinit_main mt7621_bringup_dsa_master
\ No newline at end of file
}
boot_hook_add preinit_main mt7621_bringup_dsa_master
\ No newline at end of file
# hack: enable switch on Lamobo R1 and reset counters
case $(board_name) in
lamobo,lamobo-r1)
# hack: enable switch on Lamobo R1 and reset counters
case $(board_name) in
lamobo,lamobo-r1)
sleep 1
swconfig dev switch0 set reset 1
swconfig dev switch0 set reset_mib 1
sleep 1
swconfig dev switch0 set reset 1
swconfig dev switch0 set reset_mib 1