As the LED controller is working now, we can make good use of the LEDs
now.
- Drop the model-name prefix
- Rename eth0 / eth1 LEDs to LAN1 / LAN2, as they are labeled as such
on the casing
- Enable wired LEDs in userspace
Signed-off-by: David Bauer <mail@david-bauer.net>
--- /dev/null
+
+. /lib/functions/leds.sh
+. /lib/functions/uci-defaults.sh
+
+board=$(board_name)
+boardname="${board##*,}"
+
+board_config_update
+
+case $board in
+extreme-networks,ws-ap3825i)
+ ucidef_set_led_netdev "lan1" "LAN1" "green:lan1" "eth1"
+ ucidef_set_led_netdev "lan2" "LAN2" "green:lan2" "eth0"
+ ;;
+esac
+
+board_config_flush
+
+exit 0
wifi1 {
gpios = <&spi_gpio 3 GPIO_ACTIVE_HIGH>;
wifi1 {
gpios = <&spi_gpio 3 GPIO_ACTIVE_HIGH>;
- label = "ws-ap3825i:green:radio1";
+ label = "green:radio1";
linux,default-trigger = "phy0tpt";
};
wifi2 {
gpios = <&spi_gpio 2 GPIO_ACTIVE_HIGH>;
linux,default-trigger = "phy0tpt";
};
wifi2 {
gpios = <&spi_gpio 2 GPIO_ACTIVE_HIGH>;
- label = "ws-ap3825i:green:radio2";
+ label = "green:radio2";
linux,default-trigger = "phy1tpt";
};
led_power_green: power_green {
gpios = <&spi_gpio 0 GPIO_ACTIVE_HIGH>;
linux,default-trigger = "phy1tpt";
};
led_power_green: power_green {
gpios = <&spi_gpio 0 GPIO_ACTIVE_HIGH>;
- label = "ws-ap3825i:green:power";
};
led_power_red: power_red {
gpios = <&spi_gpio 1 GPIO_ACTIVE_HIGH>;
};
led_power_red: power_red {
gpios = <&spi_gpio 1 GPIO_ACTIVE_HIGH>;
- label = "ws-ap3825i:red:power";
gpios = <&spi_gpio 6 GPIO_ACTIVE_HIGH>;
gpios = <&spi_gpio 6 GPIO_ACTIVE_HIGH>;
- label = "ws-ap3825i:red:eth0";
gpios = <&spi_gpio 4 GPIO_ACTIVE_HIGH>;
gpios = <&spi_gpio 4 GPIO_ACTIVE_HIGH>;
- label = "ws-ap3825i:green:eth0";
gpios = <&spi_gpio 7 GPIO_ACTIVE_HIGH>;
gpios = <&spi_gpio 7 GPIO_ACTIVE_HIGH>;
- label = "ws-ap3825i:red:eth1";
gpios = <&spi_gpio 5 GPIO_ACTIVE_HIGH>;
gpios = <&spi_gpio 5 GPIO_ACTIVE_HIGH>;
- label = "ws-ap3825i:green:eth1";