From: Django Armstrong Date: Sun, 20 Jan 2019 16:46:42 +0000 (+0000) Subject: ath79: add support for Devolo WiFi Pro 1750e X-Git-Url: http://git.openwrt.org/?a=commitdiff_plain;h=1c2f7b511514d43d8a826b26e09817b2750a2bf4;p=openwrt%2Fstaging%2Flynxis.git ath79: add support for Devolo WiFi Pro 1750e Hardware -------- CPU: Qualcomm Atheros QCA9558 RAM: 128M DDR2 FLASH: 16MiB ETH: 1x Atheros AR8035 (PoE in) 1x Atheros AR8033 WiFi2: QCA9558 3T3R (SiGE SE2565T 2.4 GHz power amp x3) WiFi5: QCA9880 3T3R (Skyworks 5003L1 5 GHz power amp x3) BTN: 1x Reset 1x WPS 1x USB eject LED: 1x LED blue 1x LED red BEEP: 1x GPIO attached piezo beeper UART: 3.3V GND TX RX (115200-N-8) (3.3V is pin closest to rear ports) Dupont 4 pin header Rear RJ45 serial port non-functional USB: 1x v2.0 Installation ------------ Make sure you set a password for the root user as prompted on first setup! 1. Upload OpenWRT sysupgrade image via SSH to the device. Use /tmp as the destination folder on the device. User is root, password previously set in the web interface. 2. Install OpenWRT with > sysupgrade -n -F /tmp/ Signed-off-by: Django Armstrong --- diff --git a/target/linux/ath79/base-files/etc/board.d/02_network b/target/linux/ath79/base-files/etc/board.d/02_network index 1569b110bd..4197f331b7 100755 --- a/target/linux/ath79/base-files/etc/board.d/02_network +++ b/target/linux/ath79/base-files/etc/board.d/02_network @@ -62,7 +62,8 @@ ath79_setup_interfaces() ucidef_add_switch "switch0" \ "0@eth0" "1:lan:1" "3:lan:4" "4:lan:3" "5:lan:2" "2:wan" ;; - devolo,dvl1200e) + devolo,dvl1200e|\ + devolo,dvl1750e) ucidef_set_interface_lan "eth0 eth1" ;; dlink,dir-825-b1) diff --git a/target/linux/ath79/base-files/etc/hotplug.d/firmware/11-ath10k-caldata b/target/linux/ath79/base-files/etc/hotplug.d/firmware/11-ath10k-caldata index 76efa24b52..84e43ceee5 100644 --- a/target/linux/ath79/base-files/etc/hotplug.d/firmware/11-ath10k-caldata +++ b/target/linux/ath79/base-files/etc/hotplug.d/firmware/11-ath10k-caldata @@ -90,6 +90,7 @@ case "$FIRMWARE" in devolo,dvl1200e|\ devolo,dvl1200i|\ devolo,dvl1750c|\ + devolo,dvl1750e|\ devolo,dvl1750i) ath10kcal_extract "art" 20480 2116 ath10kcal_patch_mac_crc $(macaddr_add $(mtd_get_mac_binary art 0) -1) diff --git a/target/linux/ath79/dts/qca9558_devolo_dvl1750e.dts b/target/linux/ath79/dts/qca9558_devolo_dvl1750e.dts new file mode 100644 index 0000000000..2570eb7cea --- /dev/null +++ b/target/linux/ath79/dts/qca9558_devolo_dvl1750e.dts @@ -0,0 +1,83 @@ +// SPDX-License-Identifier: GPL-2.0-or-later OR MIT +/dts-v1/; + +#include +#include + +#include "qca9558_devolo_dvl1xxx.dtsi" + +/ { + compatible = "devolo,dvl1750e", "qca,qca9557"; + model = "devolo WiFi pro 1750e"; + + aliases { + led-boot = &status_blue; + led-failsafe = &status_red; + led-running = &status_blue; + led-upgrade = &status_red; + }; + + keys { + wps { + label = "WPS Button"; + linux,code = ; + gpios = <&gpio 16 GPIO_ACTIVE_LOW>; + debounce-interval = <60>; + }; + + usb_eject { + label = "USB Eject Button"; + linux,code = ; + linux,input-type = ; + gpios = <&gpio 19 GPIO_ACTIVE_LOW>; + debounce-interval = <60>; + }; + }; + + leds { + compatible = "gpio-leds"; + + status_blue: status_blue { + label = "dvl1750e:blue:status"; + gpios = <&gpio 14 GPIO_ACTIVE_LOW>; + default-state = "on"; + }; + + status_red: status_red { + label = "dvl1750e:red:status"; + gpios = <&gpio 15 GPIO_ACTIVE_LOW>; + }; + }; + + beeper { + compatible = "gpio-beeper"; + gpios = <&gpio 4 GPIO_ACTIVE_HIGH>; + }; + + + gpio_export { + compatible = "gpio-export"; + + gpio_usb_power { + gpio-export,name = "devolo:power:usb"; + gpio-export,output = <1>; + gpios = <&gpio 11 GPIO_ACTIVE_HIGH>; + }; + }; +}; + +&usb_phy0 { + status = "okay"; +}; + +&usb0 { + status = "okay"; +}; + +&mdio1 { + status = "okay"; +}; + +ð1 { + status = "okay"; +}; diff --git a/target/linux/ath79/image/generic.mk b/target/linux/ath79/image/generic.mk index 22ba5305b1..9d0412fe97 100644 --- a/target/linux/ath79/image/generic.mk +++ b/target/linux/ath79/image/generic.mk @@ -186,6 +186,14 @@ define Device/devolo_dvl1750c endef TARGET_DEVICES += devolo_dvl1750c +define Device/devolo_dvl1750e + ATH_SOC := qca9558 + DEVICE_TITLE := devolo WiFi pro 1750e + DEVICE_PACKAGES := kmod-usb2 kmod-ath10k-ct ath10k-firmware-qca988x-ct + IMAGE_SIZE := 15936k +endef +TARGET_DEVICES += devolo_dvl1750e + define Device/devolo_dvl1750i ATH_SOC := qca9558 DEVICE_TITLE := devolo WiFi pro 1750i