From: Piotr Dymacz Date: Sat, 21 Mar 2020 22:20:31 +0000 (+0100) Subject: ath79: add support for ALFA Network AP121FE X-Git-Tag: v21.02.0-rc1~1466 X-Git-Url: http://git.openwrt.org/?a=commitdiff_plain;h=66abd58196a8e1195f1e2cd9871b4fc194b6570b;p=openwrt%2Fstaging%2Fhauke.git ath79: add support for ALFA Network AP121FE The AP121FE is a slightly modified version of already supported AP121F model (added to ar71xx in 0c6165d21a and to ath79 in 334bbc5198). The differences in compare to AP121F: - no micro SD card reader - USB data lines are included in Type-A plug - USB bus switched to device/peripheral mode (permanently, in bootstrap) Other than that, specifications are the same: - Atheros AR9331 - 400/400/200 MHz (CPU/DDR/AHB) - 64 MB of RAM (DDR1) - 16 MB of flash (SPI NOR) - 1x 10/100 Mbps Ethernet - 1T1R 2.4 GHz Wi-Fi, up to 15 dBm - 1x IPEX/U.FL connector, internal PCB antenna - 3x LED, 1x button, 1x switch - 4-pin UART header on PCB (2 mm pitch) - USB 2.0 Type-A plug (power and data) Flash instruction (under U-Boot web recovery mode): 1. Configure PC with static IP 192.168.1.2/24. 2. Connect PC with RJ45 port, press the reset button, power up device, wait for first blink of all LEDs (indicates network setup), then keep button for 3 following blinks and release it. 3. Open 192.168.1.1 address in your browser and upload sysupgrade image. Signed-off-by: Piotr Dymacz --- diff --git a/target/linux/ath79/dts/ar9331_alfa-network_ap121f.dts b/target/linux/ath79/dts/ar9331_alfa-network_ap121f.dts index 286b6d1be2..bfb6d3152c 100644 --- a/target/linux/ath79/dts/ar9331_alfa-network_ap121f.dts +++ b/target/linux/ath79/dts/ar9331_alfa-network_ap121f.dts @@ -1,38 +1,11 @@ // SPDX-License-Identifier: GPL-2.0-or-later OR MIT -#include "ar9331.dtsi" - -#include -#include +#include "ar9331_alfa-network_ap121f.dtsi" / { model = "ALFA Network AP121F"; compatible = "alfa-network,ap121f", "qca,ar9331"; - aliases { - label-mac-device = &wmac; - led-boot = &led_vpn; - led-failsafe = &led_vpn; - led-upgrade = &led_vpn; - serial0 = &uart; - }; - - keys { - compatible = "gpio-keys"; - - reset { - label = "reset"; - linux,code = ; - gpios = <&gpio 12 GPIO_ACTIVE_LOW>; - }; - - switch { - label = "switch"; - linux,code = ; - gpios = <&gpio 21 GPIO_ACTIVE_HIGH>; - }; - }; - leds { compatible = "gpio-leds"; @@ -54,81 +27,6 @@ }; }; -ð0 { - status = "okay"; - - mtd-mac-address = <&art 0x0>; - - gmac-config { - device = <&gmac>; - switch-phy-addr-swap = <0>; - switch-phy-swap = <0>; - }; -}; - -ð1 { - status = "okay"; - - compatible = "syscon", "simple-mfd"; -}; - -&spi { - status = "okay"; - - num-cs = <1>; - - flash@0 { - compatible = "jedec,spi-nor"; - reg = <0>; - spi-max-frequency = <50000000>; - m25p,fast-read; - - partitions { - compatible = "fixed-partitions"; - #address-cells = <1>; - #size-cells = <1>; - - partition@0 { - label = "u-boot"; - reg = <0x000000 0x030000>; - read-only; - }; - - partition@30000 { - label = "u-boot-env"; - reg = <0x030000 0x010000>; - }; - - art: partition@40000 { - label = "art"; - reg = <0x040000 0x010000>; - read-only; - }; - - partition@50000 { - compatible = "denx,uimage"; - label = "firmware"; - reg = <0x050000 0xfb0000>; - }; - }; - }; -}; - -&uart { - status = "okay"; -}; - &usb { - status = "okay"; dr_mode = "host"; }; - -&usb_phy { - status = "okay"; -}; - -&wmac { - status = "okay"; - - mtd-cal-data = <&art 0x1000>; -}; diff --git a/target/linux/ath79/dts/ar9331_alfa-network_ap121f.dtsi b/target/linux/ath79/dts/ar9331_alfa-network_ap121f.dtsi new file mode 100644 index 0000000000..74d65d828a --- /dev/null +++ b/target/linux/ath79/dts/ar9331_alfa-network_ap121f.dtsi @@ -0,0 +1,112 @@ +// SPDX-License-Identifier: GPL-2.0-or-later OR MIT + +#include "ar9331.dtsi" + +#include +#include + +/ { + aliases { + label-mac-device = &wmac; + led-boot = &led_vpn; + led-failsafe = &led_vpn; + led-upgrade = &led_vpn; + serial0 = &uart; + }; + + keys { + compatible = "gpio-keys"; + + reset { + label = "reset"; + linux,code = ; + gpios = <&gpio 12 GPIO_ACTIVE_LOW>; + debounce-interval = <60>; + }; + + switch { + label = "switch"; + linux,code = ; + gpios = <&gpio 21 GPIO_ACTIVE_HIGH>; + debounce-interval = <60>; + }; + }; +}; + +ð0 { + status = "okay"; + + mtd-mac-address = <&art 0x0>; + + gmac-config { + device = <&gmac>; + switch-phy-addr-swap = <0>; + switch-phy-swap = <0>; + }; +}; + +ð1 { + status = "okay"; + + compatible = "syscon", "simple-mfd"; +}; + +&spi { + status = "okay"; + + num-cs = <1>; + + flash@0 { + compatible = "jedec,spi-nor"; + reg = <0>; + spi-max-frequency = <50000000>; + m25p,fast-read; + + partitions { + compatible = "fixed-partitions"; + #address-cells = <1>; + #size-cells = <1>; + + partition@0 { + label = "u-boot"; + reg = <0x000000 0x030000>; + read-only; + }; + + partition@30000 { + label = "u-boot-env"; + reg = <0x030000 0x010000>; + }; + + art: partition@40000 { + label = "art"; + reg = <0x040000 0x010000>; + read-only; + }; + + partition@50000 { + compatible = "denx,uimage"; + label = "firmware"; + reg = <0x050000 0xfb0000>; + }; + }; + }; +}; + +&uart { + status = "okay"; +}; + +&usb { + status = "okay"; +}; + +&usb_phy { + status = "okay"; +}; + +&wmac { + status = "okay"; + + mtd-cal-data = <&art 0x1000>; +}; diff --git a/target/linux/ath79/dts/ar9331_alfa-network_ap121fe.dts b/target/linux/ath79/dts/ar9331_alfa-network_ap121fe.dts new file mode 100644 index 0000000000..178a32f4d0 --- /dev/null +++ b/target/linux/ath79/dts/ar9331_alfa-network_ap121fe.dts @@ -0,0 +1,32 @@ +// SPDX-License-Identifier: GPL-2.0-or-later OR MIT + +#include "ar9331_alfa-network_ap121f.dtsi" + +/ { + model = "ALFA Network AP121FE"; + compatible = "alfa-network,ap121fe", "qca,ar9331"; + + leds { + compatible = "gpio-leds"; + + lan { + label = "ap121fe:green:lan"; + gpios = <&gpio 17 GPIO_ACTIVE_LOW>; + }; + + led_vpn: vpn { + label = "ap121fe:green:vpn"; + gpios = <&gpio 27 GPIO_ACTIVE_LOW>; + }; + + wlan { + label = "ap121fe:green:wlan"; + gpios = <&gpio 0 GPIO_ACTIVE_HIGH>; + linux,default-trigger = "phy0tpt"; + }; + }; +}; + +&usb { + dr_mode = "peripheral"; +}; diff --git a/target/linux/ath79/generic/base-files/etc/board.d/01_leds b/target/linux/ath79/generic/base-files/etc/board.d/01_leds index ef7a0d4e3c..a90aaf0231 100755 --- a/target/linux/ath79/generic/base-files/etc/board.d/01_leds +++ b/target/linux/ath79/generic/base-files/etc/board.d/01_leds @@ -13,6 +13,7 @@ case "$board" in ucidef_set_led_switch "wan" "WAN" "$boardname:orange:eth1" "switch0" "0x04" ;; alfa-network,ap121f|\ +alfa-network,ap121fe|\ avm,fritz450e) ucidef_set_led_netdev "lan" "LAN" "$boardname:green:lan" "eth0" ;; diff --git a/target/linux/ath79/generic/base-files/etc/board.d/02_network b/target/linux/ath79/generic/base-files/etc/board.d/02_network index 518ca6f91a..ab8e24adde 100755 --- a/target/linux/ath79/generic/base-files/etc/board.d/02_network +++ b/target/linux/ath79/generic/base-files/etc/board.d/02_network @@ -75,6 +75,9 @@ ath79_setup_interfaces() winchannel,wb2000) ucidef_set_interface_lan "eth0" ;; + alfa-network,ap121fe) + ucidef_set_interface_lan "eth0 usb0" + ;; avm,fritz4020|\ pcs,cr3000|\ tplink,archer-c58-v1|\ @@ -398,6 +401,7 @@ ath79_setup_macs() label_mac=$lan_mac ;; alfa-network,ap121f|\ + alfa-network,ap121fe|\ engenius,ens202ext-v1) label_mac=$(mtd_get_mac_binary art 0x1002) ;; diff --git a/target/linux/ath79/image/generic.mk b/target/linux/ath79/image/generic.mk index 3f3a65105a..54e927cb8e 100644 --- a/target/linux/ath79/image/generic.mk +++ b/target/linux/ath79/image/generic.mk @@ -228,6 +228,15 @@ define Device/alfa-network_ap121f endef TARGET_DEVICES += alfa-network_ap121f +define Device/alfa-network_ap121fe + SOC := ar9331 + DEVICE_VENDOR := ALFA Network + DEVICE_MODEL := AP121FE + DEVICE_PACKAGES := kmod-usb-chipidea2 kmod-usb-gadget-eth -swconfig + IMAGE_SIZE := 16064k +endef +TARGET_DEVICES += alfa-network_ap121fe + define Device/allnet_all-wap02860ac SOC := qca9558 DEVICE_VENDOR := ALLNET