ar71xx: add Abicom SC300M support
[openwrt/openwrt.git] / target / linux / ar71xx / files / arch / mips / ath79 / mach-om5pac.c
1 /*
2 * OpenMesh OM5P-AC support
3 *
4 * Copyright (C) 2013 Marek Lindner <marek@open-mesh.com>
5 * Copyright (C) 2014 Sven Eckelmann <sven@open-mesh.com>
6 *
7 * This program is free software; you can redistribute it and/or modify it
8 * under the terms of the GNU General Public License version 2 as published
9 * by the Free Software Foundation.
10 */
11
12 #include <linux/gpio.h>
13 #include <linux/mtd/mtd.h>
14 #include <linux/mtd/partitions.h>
15 #include <linux/platform_device.h>
16 #include <linux/i2c.h>
17 #include <linux/i2c-algo-bit.h>
18 #include <linux/i2c-gpio.h>
19 #include <linux/platform_data/phy-at803x.h>
20
21 #include <asm/mach-ath79/ar71xx_regs.h>
22 #include <asm/mach-ath79/ath79.h>
23
24 #include "common.h"
25 #include "dev-ap9x-pci.h"
26 #include "dev-eth.h"
27 #include "dev-leds-gpio.h"
28 #include "dev-m25p80.h"
29 #include "dev-wmac.h"
30 #include "machtypes.h"
31 #include "pci.h"
32
33 #define OM5PAC_GPIO_LED_POWER 18
34 #define OM5PAC_GPIO_LED_GREEN 21
35 #define OM5PAC_GPIO_LED_RED 23
36 #define OM5PAC_GPIO_LED_YELLOW 22
37 #define OM5PAC_GPIO_LED_LAN 20
38 #define OM5PAC_GPIO_LED_WAN 19
39 #define OM5PAC_GPIO_I2C_SCL 12
40 #define OM5PAC_GPIO_I2C_SDA 11
41
42 #define OM5PAC_KEYS_POLL_INTERVAL 20 /* msecs */
43 #define OM5PAC_KEYS_DEBOUNCE_INTERVAL (3 * OM5PAC_KEYS_POLL_INTERVAL)
44
45 #define OM5PAC_WMAC_CALDATA_OFFSET 0x1000
46
47 static struct gpio_led om5pac_leds_gpio[] __initdata = {
48 {
49 .name = "om5pac:blue:power",
50 .gpio = OM5PAC_GPIO_LED_POWER,
51 .active_low = 1,
52 }, {
53 .name = "om5pac:red:wifi",
54 .gpio = OM5PAC_GPIO_LED_RED,
55 .active_low = 1,
56 }, {
57 .name = "om5pac:yellow:wifi",
58 .gpio = OM5PAC_GPIO_LED_YELLOW,
59 .active_low = 1,
60 }, {
61 .name = "om5pac:green:wifi",
62 .gpio = OM5PAC_GPIO_LED_GREEN,
63 .active_low = 1,
64 }, {
65 .name = "om5pac:blue:lan",
66 .gpio = OM5PAC_GPIO_LED_LAN,
67 .active_low = 1,
68 }, {
69 .name = "om5pac:blue:wan",
70 .gpio = OM5PAC_GPIO_LED_WAN,
71 .active_low = 1,
72 }
73 };
74
75 static struct flash_platform_data om5pac_flash_data = {
76 .type = "mx25l12805d",
77 };
78
79 static struct i2c_gpio_platform_data om5pac_i2c_device_platdata = {
80 .sda_pin = OM5PAC_GPIO_I2C_SDA,
81 .scl_pin = OM5PAC_GPIO_I2C_SCL,
82 .udelay = 10,
83 .sda_is_open_drain = 1,
84 .scl_is_open_drain = 1,
85 };
86
87 static struct platform_device om5pac_i2c_device = {
88 .name = "i2c-gpio",
89 .id = 0,
90 .dev = {
91 .platform_data = &om5pac_i2c_device_platdata,
92 },
93 };
94
95 static struct i2c_board_info om5pac_i2c_devs[] __initdata = {
96 {
97 I2C_BOARD_INFO("tmp423", 0x4c),
98 },
99 };
100
101 static struct at803x_platform_data om5pac_at803x_data = {
102 .disable_smarteee = 1,
103 .enable_rgmii_rx_delay = 1,
104 .enable_rgmii_tx_delay = 1,
105 };
106
107 static struct mdio_board_info om5pac_mdio0_info[] = {
108 {
109 .bus_id = "ag71xx-mdio.0",
110 .phy_addr = 1,
111 .platform_data = &om5pac_at803x_data,
112 },
113 {
114 .bus_id = "ag71xx-mdio.0",
115 .phy_addr = 2,
116 .platform_data = &om5pac_at803x_data,
117 },
118 };
119
120 static void __init om5p_ac_setup_qca955x_eth_cfg(u32 mask,
121 unsigned int rxd,
122 unsigned int rxdv,
123 unsigned int txd,
124 unsigned int txe)
125 {
126 void __iomem *base;
127 u32 t;
128
129 base = ioremap(QCA955X_GMAC_BASE, QCA955X_GMAC_SIZE);
130
131 t = mask;
132 t |= rxd << QCA955X_ETH_CFG_RXD_DELAY_SHIFT;
133 t |= rxdv << QCA955X_ETH_CFG_RDV_DELAY_SHIFT;
134 t |= txd << QCA955X_ETH_CFG_TXD_DELAY_SHIFT;
135 t |= txe << QCA955X_ETH_CFG_TXE_DELAY_SHIFT;
136
137 __raw_writel(t, base + QCA955X_GMAC_REG_ETH_CFG);
138
139 iounmap(base);
140 }
141
142 static void __init om5p_ac_setup(void)
143 {
144 u8 *art = (u8 *)KSEG1ADDR(0x1fff0000);
145 u8 mac[6];
146
147 /* temperature sensor */
148 platform_device_register(&om5pac_i2c_device);
149 i2c_register_board_info(0, om5pac_i2c_devs,
150 ARRAY_SIZE(om5pac_i2c_devs));
151
152 ath79_gpio_output_select(OM5PAC_GPIO_LED_WAN, QCA955X_GPIO_OUT_GPIO);
153
154 ath79_register_m25p80(&om5pac_flash_data);
155 ath79_register_leds_gpio(-1, ARRAY_SIZE(om5pac_leds_gpio),
156 om5pac_leds_gpio);
157
158 ath79_init_mac(mac, art, 0x02);
159 ath79_register_wmac(art + OM5PAC_WMAC_CALDATA_OFFSET, mac);
160
161 om5p_ac_setup_qca955x_eth_cfg(QCA955X_ETH_CFG_RGMII_EN, 3, 3, 0, 0);
162 ath79_register_mdio(0, 0x0);
163
164 mdiobus_register_board_info(om5pac_mdio0_info,
165 ARRAY_SIZE(om5pac_mdio0_info));
166
167 ath79_init_mac(ath79_eth0_data.mac_addr, art, 0x00);
168 ath79_init_mac(ath79_eth1_data.mac_addr, art, 0x01);
169
170 /* GMAC0 is connected to the PHY1 */
171 ath79_eth0_data.phy_if_mode = PHY_INTERFACE_MODE_RGMII;
172 ath79_eth0_data.mii_bus_dev = &ath79_mdio0_device.dev;
173 ath79_eth0_data.phy_mask = BIT(1);
174 ath79_eth0_pll_data.pll_1000 = 0x82000101;
175 ath79_eth0_pll_data.pll_100 = 0x80000101;
176 ath79_eth0_pll_data.pll_10 = 0x80001313;
177 ath79_register_eth(0);
178
179 /* GMAC1 is connected to MDIO1 in SGMII mode */
180 ath79_eth1_data.phy_if_mode = PHY_INTERFACE_MODE_SGMII;
181 ath79_eth1_data.mii_bus_dev = &ath79_mdio0_device.dev;
182 ath79_eth1_data.phy_mask = BIT(2);
183 ath79_eth1_pll_data.pll_1000 = 0x03000101;
184 ath79_eth1_pll_data.pll_100 = 0x80000101;
185 ath79_eth1_pll_data.pll_10 = 0x80001313;
186 ath79_eth1_data.speed = SPEED_1000;
187 ath79_eth1_data.duplex = DUPLEX_FULL;
188 ath79_register_eth(1);
189
190 ath79_register_pci();
191 }
192
193 MIPS_MACHINE(ATH79_MACH_OM5P_AC, "OM5P-AC", "OpenMesh OM5P AC", om5p_ac_setup);