1dd16987144b2e14961ff352d67803c076f3dd09
[openwrt/openwrt.git] / target / linux / ath79 / dts / ar7242_avm_fritz300e.dts
1 // SPDX-License-Identifier: GPL-2.0-or-later OR MIT
2 /dts-v1/;
3
4 #include <dt-bindings/gpio/gpio.h>
5 #include <dt-bindings/input/input.h>
6
7 #include "ar7242.dtsi"
8
9 / {
10 compatible = "avm,fritz300e", "qca,ar7242";
11 model = "AVM FRITZ!WLAN Repeater 300E";
12
13 memory@0 {
14 device_type = "memory";
15 reg = <0x0 0x4000000>;
16 };
17
18 gpio-keys {
19 compatible = "gpio-keys-polled";
20 #address-cells = <1>;
21 #size-cells = <0>;
22 poll-interval = <20>;
23
24 wps {
25 label = "wps";
26 linux,code = <KEY_WPS_BUTTON>;
27 gpios = <&gpio 12 GPIO_ACTIVE_LOW>;
28 debounce-interval = <60>;
29 };
30 };
31
32 leds {
33 compatible = "gpio-leds";
34
35 power {
36 label = "fritz300e:green:power";
37 gpios = <&gpio 13 GPIO_ACTIVE_LOW>;
38 default-state = "on";
39 };
40
41 lan {
42 label = "fritz300e:green:lan";
43 gpios = <&gpio 15 GPIO_ACTIVE_LOW>;
44 };
45
46 wlan {
47 label = "fritz300e:green:wlan";
48 gpios = <&gpio 16 GPIO_ACTIVE_LOW>;
49 };
50 };
51
52 ath9k-leds {
53 compatible = "gpio-leds";
54
55 rssi0 {
56 label = "fritz300e:green:rssi0";
57 gpios = <&ath9k 10 GPIO_ACTIVE_LOW>;
58 };
59
60 rssi1 {
61 label = "fritz300e:green:rssi1";
62 gpios = <&ath9k 4 GPIO_ACTIVE_LOW>;
63 };
64
65 rssi2 {
66 label = "fritz300e:green:rssi2";
67 gpios = <&ath9k 6 GPIO_ACTIVE_LOW>;
68 };
69
70 rssi3 {
71 label = "fritz300e:green:rssi3";
72 gpios = <&ath9k 7 GPIO_ACTIVE_LOW>;
73 };
74
75 rssi4 {
76 label = "fritz300e:green:rssi4";
77 gpios = <&ath9k 5 GPIO_ACTIVE_LOW>;
78 };
79 };
80
81 eth-phy-reset {
82 compatible = "regulator-fixed";
83
84 regulator-name = "eth-phy-reset";
85 regulator-min-microvolt = <3300000>;
86 regulator-max-microvolt = <3300000>;
87
88 gpio = <&gpio 11 GPIO_ACTIVE_LOW>;
89 startup-delay-us = <300000>;
90 enable-active-high;
91
92 regulator-always-on;
93 };
94 };
95
96 &spi {
97 status = "okay";
98 num-cs = <1>;
99
100 flash@0 {
101 #address-cells = <1>;
102 #size-cells = <1>;
103 compatible = "jedec,spi-nor";
104 reg = <0>;
105 spi-max-frequency = <25000000>;
106
107 partitions {
108 compatible = "fixed-partitions";
109 #address-cells = <1>;
110 #size-cells = <1>;
111
112 partition@0 {
113 reg = <0x0 0x20000>;
114 label = "urloader";
115 read-only;
116 };
117
118 partition@20000 {
119 reg = <0x20000 0xee0000>;
120 label = "firmware";
121 };
122
123 partition@f00000 {
124 reg = <0xf00000 0x80000>;
125 label = "tffs (1)";
126 read-only;
127 };
128
129 partition@f80000 {
130 reg = <0xf80000 0x80000>;
131 label = "tffs (2)";
132 read-only;
133 };
134 };
135 };
136 };
137
138 &uart {
139 status = "okay";
140 };
141
142 &pcie {
143 status = "okay";
144
145 ath9k: wifi@0 {
146 reg = <0x0000 0 0 0 0>;
147 #gpio-cells = <2>;
148 gpio-controller;
149 qca,no-eeprom;
150 };
151 };
152
153 &mdio0 {
154 status = "okay";
155
156 phy0: ethernet-phy@0 {
157 reg = <0>;
158 phy-mode = "rgmii";
159 };
160 };
161
162 &eth0 {
163 status = "okay";
164
165 phy-mode = "rgmii";
166 phy-handle = <&phy0>;
167
168 pll-data = <0x16000000 0x00000101 0x00001313>;
169 };