target/linux/ath79/dts/qca9557_dlink_dap-2660-a1.dts

   1 // SPDX-License-Identifier: GPL-2.0-or-later OR MIT
   2
   3 #include "qca955x_dlink_dap-2xxx.dtsi"
   4
   5 / {
   6         compatible = "dlink,dap-2660-a1", "qca,qca9557";
   7         model = "D-Link DAP-2660 A1";
   8
   9         aliases {
  10                 led-boot = &led_power_green;
  11                 led-failsafe = &led_power_red;
  12                 led-running = &led_power_green;
  13                 led-upgrade = &led_power_red;
  14         };
  15
  16         keys {
  17                 compatible = "gpio-keys";
  18
  19                 reset {
  20                         label = "reset";
  21                         linux,code = <KEY_RESTART>;
  22                         gpios = <&gpio 17 GPIO_ACTIVE_LOW>;
  23                 };
  24         };
  25
  26         leds {
  27                 compatible = "gpio-leds";
  28
  29                 led_power_red: power_red {
  30                         label = "red:power";
  31                         gpios = <&gpio 14 GPIO_ACTIVE_LOW>;
  32                 };
  33
  34                 led_power_green: power_green {
  35                         label = "green:power";
  36                         gpios = <&gpio 23 GPIO_ACTIVE_LOW>;
  37                         default-state = "on";
  38                 };
  39         };
  40 };
  41
  42 &partitions {
  43         partition@70000 {
  44                 label = "firmware";
  45                 reg = <0x70000 0xee0000>;
  46                 compatible = "wrg";
  47         };
  48
  49         partition@f50000 {
  50                 label = "dlink";
  51                 reg = <0xf50000 0xa0000>;
  52                 read-only;
  53         };
  54
  55         art: partition@ff0000 {
  56                 label = "art";
  57                 reg = <0xff0000 0x10000>;
  58                 read-only;
  59         };
  60 };
  61
  62 &mdio0 {
  63         status = "okay";
  64
  65         phy4: ethernet-phy@4 {
  66                 reg = <4>;
  67         };
  68 };
  69
  70 &eth0 {
  71         status = "okay";
  72
  73         pll-data = <0x82000000 0x80000101 0x80001313>;
  74
  75         phy-handle = <&phy4>;
  76         phy-mode = "rgmii-id";
  77
  78         gmac-config {
  79                 device = <&gmac>;
  80                 rgmii-enabled = <1>;
  81                 rxd-delay = <3>;
  82                 rxdv-delay = <3>;
  83         };
  84 };
  85
  86 &pcie0 {
  87         status = "okay";
  88 };