brcm47xx: remove linux 4.9 support
[openwrt/openwrt.git] / target / linux / kirkwood / patches-4.9 / 105-ea4500.patch
1 --- a/arch/arm/boot/dts/kirkwood-linksys-viper.dts
2 +++ b/arch/arm/boot/dts/kirkwood-linksys-viper.dts
3 @@ -69,6 +69,17 @@
4 };
5 };
6
7 + mvsw61xx {
8 + compatible = "marvell,88e6171";
9 + status = "okay";
10 + reg = <0x10>;
11 +
12 + mii-bus = <&mdio>;
13 + cpu-port-0 = <5>;
14 + cpu-port-1 = <6>;
15 + is-indirect;
16 + };
17 +
18 dsa {
19 compatible = "marvell,dsa";
20 #address-cells = <2>;
21 @@ -161,22 +172,22 @@
22 };
23
24 partition@200000 {
25 - label = "kernel";
26 + label = "kernel1";
27 reg = <0x200000 0x2A0000>;
28 };
29
30 partition@4A0000 {
31 - label = "rootfs";
32 + label = "rootfs1";
33 reg = <0x4A0000 0x1760000>;
34 };
35
36 partition@1C00000 {
37 - label = "alt_kernel";
38 + label = "kernel2";
39 reg = <0x1C00000 0x2A0000>;
40 };
41
42 partition@1EA0000 {
43 - label = "alt_rootfs";
44 + label = "rootfs2";
45 reg = <0x1EA0000 0x1760000>;
46 };
47
48 @@ -225,10 +236,14 @@
49 };
50
51 /* eth1 is connected to the switch at port 6. However DSA only supports a
52 - * single CPU port. So leave this port disabled to avoid confusion.
53 + * single CPU port. Upstream uses DSA so they disable this port to avoid confusion.
54 */
55 &eth1 {
56 - status = "disabled";
57 + status = "okay";
58 + ethernet1-port@0 {
59 + speed = <1000>;
60 + duplex = <1>;
61 + };
62 };
63
64 /* There is no battery on the board, so the RTC does not keep