/dts-v1/; /include/ "danube.dtsi" / { model = "ARV752DPW - Arcor 802"; chosen { bootargs = "console=ttyLTQ0,115200 init=/etc/preinit"; }; memory@0 { reg = <0x0 0x4000000>; }; sram@1F000000 { vmmc@107000 { status = "okay"; gpios = <&gpiomm 1 0>; }; }; fpi@10000000 { localbus@0 { nor-boot@0 { compatible = "lantiq,nor"; bank-width = <2>; reg = <0 0x0 0x800000>; #address-cells = <1>; #size-cells = <1>; partition@0 { label = "uboot"; reg = <0x00000 0x10000>; read-only; }; partition@10000 { label = "uboot_env"; reg = <0x10000 0x10000>; read-only; }; partition@20000 { label = "firmware"; reg = <0x20000 0x7d0000>; }; partition@7f0000 { label = "board_config"; reg = <0x7f0000 0x10000>; read-only; }; }; mac_addr { compatible = "lantiq,eth-mac"; reg = <0 0x7f0016 0x6>; mac-increment = <2>; }; gpiomm: gpiomm@4000000 { compatible = "lantiq,gpio-mm"; reg = <1 0x0 0x10 >; #address-cells = <1>; #size-cells = <1>; #gpio-cells = <2>; gpio-controller; lantiq,shadow = <0x3>; }; }; gpio: pinmux@E100B10 { pinctrl-names = "default"; pinctrl-0 = <&state_default>; state_default: pinmux { ebu { lantiq,groups = "ebu cs1"; lantiq,function = "ebu"; }; exin { lantiq,groups = "exin1"; lantiq,function = "exin"; lantiq,pull = <2>; lantiq,output = <0>; }; pci_in { lantiq,groups = "req2", "req1"; lantiq,function = "pci"; lantiq,open-drain = <1>; lantiq,pull = <2>; lantiq,output = <0>; }; pci_out { lantiq,groups = "gnt1"; lantiq,function = "pci"; lantiq,output = <1>; }; pci_rst { lantiq,pins = "io21"; lantiq,pull = <2>; lantiq,output = <1>; }; leds { lantiq,pins = "io3", "io5", "io6", "io8"; lantiq,output = <1>; lantiq,pull = <0>; }; keys { lantiq,pins = "io11", "io12", "io13", "io28"; lantiq,output = <0>; lantiq,pull = <2>; lantiq,open-drain = <1>; }; }; }; ifxhcd@E101000 { status = "okay"; gpios = <&gpiomm 0 0>; }; etop@E180000 { phy-mode = "rmii"; }; pci@E105400 { status = "okay"; lantiq,external-clock; gpio-reset = <&gpio 21 0>; interrupt-map = <0x7000 0 0 1 &icu0 135>; req-mask = <0x3>; }; }; ralink_eep { compatible = "ralink,eeprom"; ralink,eeprom = "RT2860.eeprom"; }; gpio-keys-polled { compatible = "gpio-keys-polled"; #address-cells = <1>; #size-cells = <0>; poll-interval = <100>; /* wps { label = "wps"; gpios = <&gpio 11 1>; linux,code = <0x211>; }; */ restart { label = "restart"; gpios = <&gpio 12 1>; linux,code = <0x110>; }; dsl { label = "dsl"; gpios = <&gpio 13 1>; linux,code = <0x111>; }; reset { label = "reset"; gpios = <&gpio 28 1>; linux,code = <0x198>; }; }; gpio-leds { compatible = "gpio-leds"; power1 { label = "power1"; gpios = <&gpio 3 1>; }; internet { label = "internet"; gpios = <&gpio 4 1>; }; message { label = "message"; gpios = <&gpio 5 1>; }; power { label = "power"; gpios = <&gpio 6 1>; default-state = "keep"; }; voice1 { label = "voice1"; gpios = <&gpio 8 1>; }; microphone { label = "umts"; gpios = <&gpiomm 3 1>; }; wifi { label = "wifi"; gpios = <&gpiomm 4 1>; }; fxs1 { label = "fxs1"; gpios = <&gpiomm 5 1>; }; fxs2 { label = "fxs2"; gpios = <&gpiomm 6 1>; }; fxo { label = "fxo"; gpios = <&gpiomm 7 1>; }; internet2 { label = "internet2"; gpios = <&gpiomm 8 1>; }; voice2 { label = "voice2"; gpios = <&gpiomm 9 1>; }; }; };