// SPDX-License-Identifier: GPL-2.0-or-later OR MIT #include "mt7621.dtsi" #include #include / { aliases { label-mac-device = &gmac0; led-boot = &led_status_red; led-failsafe = &led_status_green; led-running = &led_status_green; led-upgrade = &led_status_red; }; keys { compatible = "gpio-keys"; reset { label = "reset"; gpios = <&gpio 7 GPIO_ACTIVE_LOW>; linux,code = ; debounce-interval = <60>; }; wps { label = "wps"; gpios = <&gpio 18 GPIO_ACTIVE_LOW>; linux,code = ; }; }; leds { compatible = "gpio-leds"; led_status_red: status_red { label = "red:status"; gpios = <&gpio 16 GPIO_ACTIVE_LOW>; }; led_status_green: status_green { label = "green:status"; gpios = <&gpio 13 GPIO_ACTIVE_LOW>; }; rssi_low_red { label = "red:rssilow"; gpios = <&gpio 25 GPIO_ACTIVE_LOW>; }; rssi_low_green { label = "green:rssilow"; gpios = <&gpio 24 GPIO_ACTIVE_LOW>; }; rssi_med_green { label = "green:rssimed"; gpios = <&gpio 23 GPIO_ACTIVE_LOW>; }; rssi_high_green { label = "green:rssihigh"; gpios = <&gpio 22 GPIO_ACTIVE_LOW>; }; }; }; &spi0 { status = "okay"; flash@0 { compatible = "jedec,spi-nor"; reg = <0>; spi-max-frequency = <50000000>; partitions { compatible = "fixed-partitions"; #address-cells = <1>; #size-cells = <1>; partition@0 { label = "u-boot"; reg = <0x0 0x30000>; read-only; }; partition@30000 { label = "u-boot-env"; reg = <0x30000 0x10000>; read-only; }; factory: partition@40000 { compatible = "nvmem-cells"; label = "factory"; reg = <0x40000 0x10000>; #address-cells = <1>; #size-cells = <1>; read-only; eeprom_factory_0: eeprom@0 { reg = <0x0 0x4da8>; }; macaddr_factory_e000: macaddr@e000 { reg = <0xe000 0x6>; }; }; partition@50000 { compatible = "denx,uimage"; label = "firmware"; reg = <0x50000 0xfb0000>; }; }; }; }; &pcie { status = "okay"; }; &pcie0 { wifi@0,0 { compatible = "mediatek,mt76"; reg = <0x0000 0 0 0 0>; nvmem-cells = <&eeprom_factory_0>; nvmem-cell-names = "eeprom"; /* The correct MAC addresses are set in 10_fix_wifi_mac. */ }; }; &gmac0 { nvmem-cells = <&macaddr_factory_e000>; nvmem-cell-names = "mac-address"; }; &switch0 { ports { port@0 { status = "okay"; label = "lan"; }; }; }; ðernet { pinctrl-0 = <&mdio_pins>, <&rgmii1_pins>; }; &state_default { gpio { groups = "uart3", "jtag", "wdt"; function = "gpio"; }; };