#include <linux/mtd/mtd.h>
#include <linux/mtd/partitions.h>
#include <linux/delay.h>
-#include <linux/rtl8366_smi.h>
+#include <linux/rtl8366s.h>
#include <asm/mach-ar71xx/ar71xx.h>
.offset = 0,
.size = 0x040000,
.mask_flags = MTD_WRITEABLE,
- } , {
+ }, {
.name = "config",
.offset = 0x040000,
.size = 0x010000,
.mask_flags = MTD_WRITEABLE,
- } , {
+ }, {
.name = "firmware",
.offset = 0x050000,
.size = 0x610000,
- } , {
+ }, {
.name = "caldata",
.offset = 0x660000,
.size = 0x010000,
.mask_flags = MTD_WRITEABLE,
+ }, {
+ .name = "unknown",
+ .offset = 0x670000,
+ .size = 0x190000,
+ .mask_flags = MTD_WRITEABLE,
}
};
#endif /* CONFIG_MTD_PARTITIONS */
static struct flash_platform_data dir825b1_flash_data = {
#ifdef CONFIG_MTD_PARTITIONS
- .parts = dir825b1_partitions,
- .nr_parts = ARRAY_SIZE(dir825b1_partitions),
+ .parts = dir825b1_partitions,
+ .nr_parts = ARRAY_SIZE(dir825b1_partitions),
#endif
};
{
.desc = "reset",
.type = EV_KEY,
- .code = BTN_0,
- .threshold = 5,
+ .code = KEY_RESTART,
+ .threshold = 3,
.gpio = DIR825B1_GPIO_BTN_RESET,
.active_low = 1,
- } , {
+ }, {
.desc = "powersave",
.type = EV_KEY,
.code = BTN_1,
- .threshold = 5,
+ .threshold = 3,
.gpio = DIR825B1_GPIO_BTN_POWERSAVE,
.active_low = 1,
}
};
-static struct rtl8366_smi_platform_data dir825b1_rtl8366_smi_data = {
+static struct rtl8366s_platform_data dir825b1_rtl8366s_data = {
.gpio_sda = DIR825B1_GPIO_RTL8366_SDA,
.gpio_sck = DIR825B1_GPIO_RTL8366_SCK,
};
-static struct platform_device dir825b1_rtl8366_smi_device = {
- .name = "rtl8366-smi",
+static struct platform_device dir825b1_rtl8366s_device = {
+ .name = RTL8366S_DRIVER_NAME,
.id = -1,
.dev = {
- .platform_data = &dir825b1_rtl8366_smi_data,
+ .platform_data = &dir825b1_rtl8366s_data,
}
};
static void __init dir825b1_setup(void)
{
- u8 mac[6], i;
-
- memcpy(mac, (u8*)KSEG1ADDR(DIR825B1_MAC_LOCATION_1), 6);
- for(i = 5; i >= 3; i--)
- if(++mac[i] != 0x00) break;
-
- ar71xx_set_mac_base(mac);
+ u8 *mac = (u8 *) KSEG1ADDR(DIR825B1_MAC_LOCATION_1);
ar71xx_add_device_mdio(0x0);
- ar71xx_eth0_data.mii_bus_dev = &dir825b1_rtl8366_smi_device.dev;
+ ar71xx_init_mac(ar71xx_eth0_data.mac_addr, mac, 1);
+ ar71xx_eth0_data.mii_bus_dev = &dir825b1_rtl8366s_device.dev;
ar71xx_eth0_data.phy_if_mode = PHY_INTERFACE_MODE_RGMII;
ar71xx_eth0_data.speed = SPEED_1000;
ar71xx_eth0_data.duplex = DUPLEX_FULL;
ar71xx_eth0_pll_data.pll_1000 = 0x11110000;
- ar71xx_eth1_data.mii_bus_dev = &dir825b1_rtl8366_smi_device.dev;
+ ar71xx_init_mac(ar71xx_eth1_data.mac_addr, mac, 2);
+ ar71xx_eth1_data.mii_bus_dev = &dir825b1_rtl8366s_device.dev;
ar71xx_eth1_data.phy_if_mode = PHY_INTERFACE_MODE_RGMII;
ar71xx_eth1_data.phy_mask = 0x10;
ar71xx_eth1_pll_data.pll_1000 = 0x11110000;
ar71xx_add_device_usb();
- platform_device_register(&dir825b1_rtl8366_smi_device);
+ platform_device_register(&dir825b1_rtl8366s_device);
ap94_pci_init((u8 *) KSEG1ADDR(DIR825B1_CAL_LOCATION_0),
(u8 *) KSEG1ADDR(DIR825B1_MAC_LOCATION_0),