-/include/ "vr9.dtsi"
+#include "vr9.dtsi"
+
+#include <dt-bindings/input/input.h>
/ {
+ compatible = "tplink,tdw89x0", "lantiq,xway", "lantiq,vr9";
+
chosen {
- bootargs = "console=ttyLTQ0,115200 init=/etc/preinit";
+ bootargs = "console=ttyLTQ0,115200";
+ };
- leds {
- /* the power led can't be controlled, use the wps led instead */
- boot = &wps;
- failsafe = &wps;
+ aliases {
+ /* the power led can't be controlled, use the wps led instead */
+ led-boot = &wps;
+ led-failsafe = &wps;
- dsl = &dsl;
- internet = &internet;
- usb = &usb0;
- usb2 = &usb2;
- };
+ led-dsl = &dsl;
+ led-internet = &internet;
+ led-wifi = &wifi;
+ led-usb = &usb0;
+ led-usb2 = &usb2;
};
memory@0 {
};
fpi@10000000 {
- spi@E100800 {
- compatible = "lantiq,spi-xway";
- reg = <0xE100800 0x100>;
- interrupt-parent = <&icu0>;
- interrupts = <22 23 24>;
- #address-cells = <1>;
- #size-cells = <1>;
- m25p80@0 {
- #address-cells = <1>;
- #size-cells = <1>;
- compatible = "jedec,spi-nor";
- reg = <3 0>;
- spi-max-frequency = <33250000>;
- m25p,fast-read;
-
- partition@0 {
- reg = <0x0 0x20000>;
- label = "u-boot";
- read-only;
- };
-
- partition@20000 {
- reg = <0x20000 0x7a0000>;
- label = "firmware";
- };
-
- partition@7c0000 {
- reg = <0x7c0000 0x10000>;
- label = "config";
- read-only;
- };
-
- ath9k_cal: partition@7d0000 {
- reg = <0x7d0000 0x30000>;
- label = "boardconfig";
- read-only;
- };
- };
- };
-
gpio: pinmux@E100B10 {
pinctrl-names = "default";
pinctrl-0 = <&state_default>;
lantiq,open-drain = <0>;
lantiq,output = <1>;
};
- spi {
- lantiq,groups = "spi", "spi_cs4";
- lantiq,function = "spi";
- };
pcie-rst {
lantiq,pins = "io38";
lantiq,pull = <0>;
lantiq,output = <1>;
};
};
- };
-
- eth@E108000 {
- #address-cells = <1>;
- #size-cells = <0>;
- compatible = "lantiq,xrx200-net";
- reg = < 0xE108000 0x3000 /* switch */
- 0xE10B100 0x70 /* mdio */
- 0xE10B1D8 0x30 /* mii */
- 0xE10B308 0x30 /* pmac */
- >;
- interrupt-parent = <&icu0>;
- interrupts = <73 72>;
-
- lan: interface@0 {
- compatible = "lantiq,xrx200-pdi";
- #address-cells = <1>;
- #size-cells = <0>;
- reg = <0>;
- mtd-mac-address = <&ath9k_cal 0xf100>;
- lantiq,switch;
-
- ethernet@0 {
- compatible = "lantiq,xrx200-pdi-port";
- reg = <0>;
- phy-mode = "rgmii";
- phy-handle = <&phy0>;
- // gpios = <&gpio 42 1>;
- };
- ethernet@5 {
- compatible = "lantiq,xrx200-pdi-port";
- reg = <5>;
- phy-mode = "rgmii";
- phy-handle = <&phy5>;
- };
- ethernet@2 {
- compatible = "lantiq,xrx200-pdi-port";
- reg = <2>;
- phy-mode = "gmii";
- phy-handle = <&phy11>;
- };
- ethernet@3 {
- compatible = "lantiq,xrx200-pdi-port";
- reg = <4>;
- phy-mode = "gmii";
- phy-handle = <&phy13>;
- };
- };
-
- mdio@0 {
- #address-cells = <1>;
- #size-cells = <0>;
- compatible = "lantiq,xrx200-mdio";
- phy0: ethernet-phy@0 {
- reg = <0x0>;
- compatible = "lantiq,phy11g", "ethernet-phy-ieee802.3-c22";
- };
- phy5: ethernet-phy@5 {
- reg = <0x5>;
- compatible = "lantiq,phy11g", "ethernet-phy-ieee802.3-c22";
- };
- phy11: ethernet-phy@11 {
- reg = <0x11>;
- compatible = "lantiq,phy11g", "ethernet-phy-ieee802.3-c22";
+ pins_spi_default: pins_spi_default {
+ spi_in {
+ lantiq,groups = "spi_di";
+ lantiq,function = "spi";
};
- phy13: ethernet-phy@13 {
- reg = <0x13>;
- compatible = "lantiq,phy11g", "ethernet-phy-ieee802.3-c22";
+ spi_out {
+ lantiq,groups = "spi_do", "spi_clk",
+ "spi_cs4";
+ lantiq,function = "spi";
+ lantiq,output = <1>;
};
};
};
ifxhcd@E101000 {
status = "okay";
- gpios = <&gpio 33 0>;
+ gpios = <&gpio 33 GPIO_ACTIVE_HIGH>;
lantiq,portmask = <0x3>;
};
ifxhcd@E106000 {
status = "okay";
- gpios = <&gpio 33 0>;
+ gpios = <&gpio 33 GPIO_ACTIVE_HIGH>;
};
};
gphy-xrx200 {
compatible = "lantiq,phy-xrx200";
- firmware = "lantiq/vr9_phy11g_a2x.bin";
+ firmware = "lantiq/xrx200_phy11g_a22.bin";
phys = [ 00 01 ];
};
- pcie {
- compatible = "lantiq,pcie-xway";
- };
-
- ath9k_eep {
- compatible = "ath9k,eeprom";
- ath,eep-flash = <&ath9k_cal 0x21000>;
- ath,mac-offset = <0xf100>;
- ath,mac-increment;
- ath,led-pin = <0>;
- ath,disable-5ghz;
- ath,led-active-high;
- };
-
gpio-keys-polled {
compatible = "gpio-keys-polled";
#address-cells = <1>;
poll-interval = <100>;
reset {
label = "reset";
- gpios = <&gpio 0 1>;
- linux,code = <0x198>;
+ gpios = <&gpio 0 GPIO_ACTIVE_LOW>;
+ linux,code = <KEY_RESTART>;
};
wifi {
label = "wifi";
- gpios = <&gpio 9 0>;
- linux,code = <0xf7>;
- linux,input-type = <5>; /* EV_SW */
+ gpios = <&gpio 9 GPIO_ACTIVE_HIGH>;
+ linux,code = <KEY_RFKILL>;
+ linux,input-type = <EV_SW>;
};
wps {
label = "wps";
- gpios = <&gpio 39 1>;
- linux,code = <0x211>;
+ gpios = <&gpio 39 GPIO_ACTIVE_LOW>;
+ linux,code = <KEY_WPS_BUTTON>;
};
};
compatible = "gpio-leds";
/*
power is not controllable via gpio
- */
+ */
dsl: dsl {
label = "tdw89x0:green:dsl";
- gpios = <&gpio 4 0>;
+ gpios = <&gpio 4 GPIO_ACTIVE_HIGH>;
};
internet: internet {
label = "tdw89x0:green:internet";
- gpios = <&gpio 5 0>;
+ gpios = <&gpio 5 GPIO_ACTIVE_HIGH>;
};
usb0: usb0 {
label = "tdw89x0:green:usb";
- gpios = <&gpio 19 0>;
+ gpios = <&gpio 19 GPIO_ACTIVE_HIGH>;
};
usb2: usb2 {
label = "tdw89x0:green:usb2";
- gpios = <&gpio 20 0>;
+ gpios = <&gpio 20 GPIO_ACTIVE_HIGH>;
};
wps: wps {
label = "tdw89x0:green:wps";
- gpios = <&gpio 37 0>;
+ gpios = <&gpio 37 GPIO_ACTIVE_HIGH>;
+ };
+ };
+
+ wifi-leds {
+ compatible = "gpio-leds";
+
+ wifi: wifi {
+ label = "tdw89x0:green:wifi";
+ gpios = <&ath9k 0 GPIO_ACTIVE_HIGH>;
+ };
+ };
+};
+
+&spi {
+ pinctrl-names = "default";
+ pinctrl-0 = <&pins_spi_default>;
+
+ status = "ok";
+
+ m25p80@4 {
+ #address-cells = <1>;
+ #size-cells = <1>;
+ compatible = "jedec,spi-nor";
+ reg = <4 0>;
+ spi-max-frequency = <33250000>;
+ m25p,fast-read;
+
+ partitions {
+ compatible = "fixed-partitions";
+ #address-cells = <1>;
+ #size-cells = <1>;
+
+ partition@0 {
+ reg = <0x0 0x20000>;
+ label = "u-boot";
+ read-only;
+ };
+
+ partition@20000 {
+ reg = <0x20000 0x7a0000>;
+ label = "firmware";
+ };
+
+ partition@7c0000 {
+ reg = <0x7c0000 0x10000>;
+ label = "config";
+ read-only;
+ };
+
+ ath9k_cal: partition@7d0000 {
+ reg = <0x7d0000 0x30000>;
+ label = "boardconfig";
+ read-only;
+ };
+ };
+ };
+};
+
+ð0 {
+ lan: interface@0 {
+ compatible = "lantiq,xrx200-pdi";
+ #address-cells = <1>;
+ #size-cells = <0>;
+ reg = <0>;
+ mtd-mac-address = <&ath9k_cal 0xf100>;
+ lantiq,switch;
+
+ ethernet@0 {
+ compatible = "lantiq,xrx200-pdi-port";
+ reg = <0>;
+ phy-mode = "rgmii";
+ phy-handle = <&phy0>;
+ // gpios = <&gpio 42 GPIO_ACTIVE_LOW>;
+ };
+ ethernet@5 {
+ compatible = "lantiq,xrx200-pdi-port";
+ reg = <5>;
+ phy-mode = "rgmii";
+ phy-handle = <&phy5>;
+ };
+ ethernet@2 {
+ compatible = "lantiq,xrx200-pdi-port";
+ reg = <2>;
+ phy-mode = "gmii";
+ phy-handle = <&phy11>;
+ };
+ ethernet@3 {
+ compatible = "lantiq,xrx200-pdi-port";
+ reg = <4>;
+ phy-mode = "gmii";
+ phy-handle = <&phy13>;
+ };
+ };
+
+ mdio@0 {
+ #address-cells = <1>;
+ #size-cells = <0>;
+ compatible = "lantiq,xrx200-mdio";
+ phy0: ethernet-phy@0 {
+ reg = <0x0>;
+ compatible = "lantiq,phy11g", "ethernet-phy-ieee802.3-c22";
+ };
+ phy5: ethernet-phy@5 {
+ reg = <0x5>;
+ compatible = "lantiq,phy11g", "ethernet-phy-ieee802.3-c22";
+ };
+ phy11: ethernet-phy@11 {
+ reg = <0x11>;
+ compatible = "lantiq,phy11g", "ethernet-phy-ieee802.3-c22";
+ };
+ phy13: ethernet-phy@13 {
+ reg = <0x13>;
+ compatible = "lantiq,phy11g", "ethernet-phy-ieee802.3-c22";
+ };
+ };
+};
+
+&pcie0 {
+ pcie@0 {
+ reg = <0 0 0 0 0>;
+ #interrupt-cells = <1>;
+ #size-cells = <2>;
+ #address-cells = <3>;
+ device_type = "pci";
+
+ ath9k: wifi@168c,002e {
+ compatible = "pci168c,002e";
+ reg = <0 0 0 0 0>;
+ #gpio-cells = <2>;
+ gpio-controller;
+ qca,no-eeprom;
+ qca,disable-5ghz;
+ mtd-mac-address = <&ath9k_cal 0xf100>;
+ mtd-mac-address-increment = <2>;
};
};
};
projects / openwrt / openwrt.git / blobdiff