ath79: add etactica-eg200 support
authorKarl Palsson <karlp@etactica.com>
Mon, 7 May 2018 16:08:00 +0000 (16:08 +0000)
committerJohn Crispin <john@phrozen.org>
Fri, 8 Jun 2018 07:56:27 +0000 (09:56 +0200)
Based on original ar71xx eg200 board files

Tested working:
* usb hub, storage and serial port
* ethernet
* wifi
* leds
* button

sysupgrade from self->self passes validity checks.
sysupgrade from old ar71xx->ath79 passes. (however this doesn't migrate
wireless driver configs)

Only unknown issue is the existance of a /sys/class/leds/ath9k-phy0,
which doesn't "exist"

Signed-off-by: Karl Palsson <karlp@etactica.com>
target/linux/ath79/base-files/etc/board.d/01_leds
target/linux/ath79/base-files/etc/board.d/02_network
target/linux/ath79/dts/ar9331_etactica-eg200.dts [new file with mode: 0644]
target/linux/ath79/image/generic.mk

index 76b0257..80e32d9 100755 (executable)
@@ -18,6 +18,12 @@ case "$board" in
        ucidef_set_led_rssi "rssimediumhigh" "RSSIMEDIUMHIGH" "$boardname:green:rssi3" "wlan0" "60" "100"
        ucidef_set_led_rssi "rssihigh" "RSSIHIGH" "$boardname:green:rssi4" "wlan0" "80" "100"
        ;;
+"etactica,eg200")
+       ucidef_set_led_netdev "lan" "LAN" "$boardname:red:eth0" "eth0"
+       ucidef_set_led_wlan "wlan" "WLAN" "$boardname:red:wlan" "phy0tpt"
+       ucidef_set_led_oneshot "modbus" "Modbus" "$boardname:red:modbus" "100" "33"
+       ucidef_set_led_default "etactica" "etactica" "$boardname:red:etactica" "ignore"
+       ;;
 "glinet,ar150")
        ucidef_set_led_wlan "wlan" "WLAN" "gl-ar150:orange:wlan" "phy0tpt"
        ;;
index c02d9ff..a2d6ab0 100755 (executable)
@@ -8,6 +8,9 @@ ath79_setup_interfaces()
        local board="$1"
 
        case "$board" in
+       "etactica,eg200")
+               ucidef_set_interface_lan "eth0" "dhcp"
+               ;;
        "avm,fritz300e"|\
        "tplink,tl-mr10u"|\
        "tplink,tl-wr703n"|\
diff --git a/target/linux/ath79/dts/ar9331_etactica-eg200.dts b/target/linux/ath79/dts/ar9331_etactica-eg200.dts
new file mode 100644 (file)
index 0000000..1dc9608
--- /dev/null
@@ -0,0 +1,142 @@
+// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
+/dts-v1/;
+
+#include <dt-bindings/gpio/gpio.h>
+#include <dt-bindings/input/input.h>
+
+#include "ar9331.dtsi"
+
+/ {
+       model = "eTactica EG200";
+       compatible = "etactica,eg200", "rme-eg200";
+
+        aliases {
+                serial0 = &uart;
+        };
+
+       memory@0 {
+               device_type = "memory";
+               reg = <0x0 0x4000000>;
+       };
+
+       keys {
+               compatible = "gpio-keys-polled";
+               #address-cells = <1>;
+               #size-cells = <0>;
+               poll-interval = <50>;
+
+               restore {
+                       linux,code = <KEY_WPS_BUTTON>;
+                       gpios = <&gpio 11 GPIO_ACTIVE_LOW>;
+               };
+       };
+
+       leds {
+               compatible = "gpio-leds";
+
+               modbus {
+                       label = "eg200:red:modbus";
+                       gpios = <&gpio 16 GPIO_ACTIVE_HIGH>;
+                       default-state = "off";
+               };
+
+               etactica {
+                       label = "eg200:red:etactica";
+                       gpios = <&gpio 15 GPIO_ACTIVE_HIGH>;
+                       default-state = "off";
+               };
+
+               eth0 {
+                       label = "eg200:red:eth0";
+                       gpios = <&gpio 13 GPIO_ACTIVE_LOW>;
+                       default-state = "off";
+               };
+
+               wlan {
+                       label = "eg200:red:wlan";
+                       gpios = <&gpio 0 GPIO_ACTIVE_LOW>;
+                       default-state = "off";
+               };
+       };
+};
+
+&uart {
+       status = "okay";
+};
+
+&gpio {
+       status = "okay";
+};
+
+&usb {
+       dr_mode = "host";
+       status = "okay";
+};
+
+&usb_phy {
+       status = "okay";
+};
+
+&mdio0 {
+       status = "okay";
+       phy4: ethernet-phy@4 {
+               reg = <4>;
+               phy-mode = "mii";
+       };
+};
+
+&eth0 {
+       status = "okay";
+       mtd-mac-address = <&art 0x0>;
+       phy-handle = <&phy4>;
+
+       gmac-config {
+               device = <&gmac>;
+               switch-phy-addr-swap = <1>;
+               switch-phy-swap = <1>;
+       };
+};
+
+&spi {
+       num-chipselects = <1>;
+       status = "okay";
+
+       flash@0 {
+               #address-cells = <1>;
+               #size-cells = <1>;
+               compatible = "jedec,spi-nor";
+               spi-max-frequency = <50000000>;
+               reg = <0>;
+
+               partitions {
+                       compatible = "fixed-partitions";
+                       #address-cells = <1>;
+                       #size-cells = <1>;
+
+                       uboot@0 {
+                               reg = <0x0 0x40000>;
+                               read-only;
+                       };
+
+                       uboot-env@40000 {
+                               reg = <0x40000 0x10000>;
+                               read-only;
+                       };
+
+                       firmware@50000 {
+                               reg = <0x50000 0xfa0000>;
+                       };
+
+                       art: art@ff0000 {
+                               reg = <0xff0000 0x10000>;
+                               read-only;
+                       };
+               };
+       };
+};
+
+&wmac {
+       status = "okay";
+       mtd-cal-data = <&art 0x1000>;
+       mtd-mac-address = <&art 0x1002>;
+};
index cb5dc38..9475d0a 100644 (file)
@@ -44,6 +44,15 @@ define Device/embeddedwireless_dorin
 endef
 TARGET_DEVICES += embeddedwireless_dorin
 
+define Device/etactica-eg200
+  ATH_SOC := ar9331
+  DEVICE_TITLE := eTactica EG200
+  DEVICE_PACKAGES := kmod-usb-chipidea2 kmod-ledtrig-oneshot \
+       kmod-usb-serial kmod-usb-serial-ftdi kmod-usb-storage  kmod-fs-ext4
+  SUPPORTED_DEVICES += etactica,eg200 rme-eg200
+endef
+TARGET_DEVICES += etactica-eg200
+
 define Device/glinet_ar150
   ATH_SOC := ar9330
   DEVICE_TITLE := GL.iNet GL-AR150