ramips: add support for I-O DATA WN-AC733GR3
authorINAGAKI Hiroshi <musashino.open@gmail.com>
Thu, 14 Mar 2019 14:46:43 +0000 (23:46 +0900)
committerChristian Lamparter <chunkeey@gmail.com>
Wed, 20 Mar 2019 23:57:20 +0000 (00:57 +0100)
I-O DATA WN-AC733GR3 is a 2.4/5 GHz band 11ac router, based on
MediaTek MT7620A.

Specification

- SoC : MediaTek MT7620A
- RAM : DDR2 64 MiB
- Flash : SPI-NOR 8 MiB
- WLAN : 2.4/5 GHz
  - 2.4 GHz : MT7620A (SoC), 2T2R
  - 5 GHz   : MT7610E, 1T1R
- Ethernet : 10/100/1000 Mbps (RTL8367RB)
- LED/key : 4x/4x (2x buttons, 1x slide-switch)
- UART : through-hole on PCB
  - J1: Vcc, RX, GND, TX from LED side
  - 57600n8

Flash instruction using factory image:

1. Boot WN-AC733GR3 normaly
2. Access to "http://192.168.0.1/" and open firmware update page
("ファームウェア")
3. Select the OpenWrt factory image and click update ("更新") button
to perform firmware update
4. Wait ~150 seconds to complete flashing

Signed-off-by: INAGAKI Hiroshi <musashino.open@gmail.com>
target/linux/ramips/base-files/etc/board.d/01_leds
target/linux/ramips/base-files/etc/board.d/02_network
target/linux/ramips/dts/WN-AC733GR3.dts [new file with mode: 0644]
target/linux/ramips/image/mt7620.mk

index 9cca231..69b95ee 100755 (executable)
@@ -196,7 +196,8 @@ ht-tm02)
        ucidef_set_led_netdev "eth" "Ethernet" "$boardname:green:lan" "eth0"
        set_wifi_led "$boardname:blue:wlan"
        ;;
-iodata,wn-ac1167gr)
+iodata,wn-ac1167gr|\
+iodata,wn-ac733gr3)
        ucidef_set_led_wlan "wlan5g" "WLAN5G" "$boardname:green:wlan5g" "phy0radio"
        ucidef_set_led_wlan "wlan2g" "WLAN2G" "$boardname:green:wlan2g" "phy1radio"
        ;;
index 890efa0..20a50cc 100755 (executable)
@@ -324,7 +324,8 @@ ramips_setup_interfaces()
                ucidef_add_switch "switch0" \
                        "0:lan" "1:lan" "5:wan" "6@eth0"
                ;;
-       iodata,wn-ac1167gr)
+       iodata,wn-ac1167gr|\
+       iodata,wn-ac733gr3)
                ucidef_add_switch "switch1" \
                        "1:lan:4" "2:lan:3" "3:lan:2" "4:lan:1" "0:wan" "6@eth0"
                ;;
@@ -546,7 +547,8 @@ ramips_setup_macs()
                [ -n "$lan_mac" ] || lan_mac=$(cat /sys/class/net/eth0/address)
                wan_mac=$(macaddr_add "$lan_mac" 1)
                ;;
-       iodata,wn-ac1167gr)
+       iodata,wn-ac1167gr|\
+       iodata,wn-ac733gr3)
                wan_mac=$(macaddr_add "$(mtd_get_mac_binary Factory 4)" -1)
                ;;
        iodata,wn-ax1167gr|\
diff --git a/target/linux/ramips/dts/WN-AC733GR3.dts b/target/linux/ramips/dts/WN-AC733GR3.dts
new file mode 100644 (file)
index 0000000..ea837c4
--- /dev/null
@@ -0,0 +1,198 @@
+// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
+/dts-v1/;
+
+#include "mt7620a.dtsi"
+
+#include <dt-bindings/gpio/gpio.h>
+#include <dt-bindings/input/input.h>
+
+/ {
+       compatible = "iodata,wn-ac733gr3", "ralink,mt7620a-soc";
+       model = "I-O DATA WN-AC733GR3";
+
+       aliases {
+               led-boot = &led_power;
+               led-failsafe = &led_power;
+               led-running = &led_power;
+               led-upgrade = &led_power;
+       };
+
+       memory@0 {
+               device_type = "memory";
+               reg = <0x0 0x4000000>;
+       };
+
+       leds {
+               compatible = "gpio-leds";
+
+               led_power: power {
+                       label = "wn-ac733gr3:green:power";
+                       gpios = <&gpio0 7 GPIO_ACTIVE_LOW>;
+                       default-state = "on";
+               };
+
+               notification {
+                       label = "wn-ac733gr3:green:notification";
+                       gpios = <&gpio0 8 GPIO_ACTIVE_LOW>;
+               };
+
+               wlan2g {
+                       label = "wn-ac733gr3:green:wlan2g";
+                       gpios = <&gpio0 10 GPIO_ACTIVE_LOW>;
+               };
+
+               wlan5g {
+                       label = "wn-ac733gr3:green:wlan5g";
+                       gpios = <&gpio0 14 GPIO_ACTIVE_LOW>;
+               };
+       };
+
+       keys {
+               compatible = "gpio-keys-polled";
+               poll-interval = <20>;
+
+               reset {
+                       label = "reset";
+                       gpios = <&gpio0 1 GPIO_ACTIVE_LOW>;
+                       linux,code = <KEY_RESTART>;
+               };
+
+               wps {
+                       label = "wps";
+                       gpios = <&gpio0 2 GPIO_ACTIVE_LOW>;
+                       linux,code = <KEY_WPS_BUTTON>;
+               };
+
+               router {
+                       label = "router";
+                       gpios = <&gpio0 12 GPIO_ACTIVE_LOW>;
+                       linux,code = <BTN_0>;
+                       linux,input-type = <EV_SW>;
+               };
+
+               auto {
+                       label = "auto";
+                       gpios = <&gpio0 13 GPIO_ACTIVE_LOW>;
+                       linux,code = <BTN_0>;
+                       linux,input-type = <EV_SW>;
+               };
+       };
+
+       rtl8367rb {
+               compatible = "realtek,rtl8367b";
+               gpio-sda = <&gpio0 22 GPIO_ACTIVE_HIGH>;
+               gpio-sck = <&gpio0 23 GPIO_ACTIVE_HIGH>;
+               realtek,extif1 = <1 0 1 1 1 1 1 1 2>;
+       };
+};
+
+&spi0 {
+       status = "okay";
+
+       flash@0 {
+               compatible = "jedec,spi-nor";
+               reg = <0>;
+               spi-max-frequency = <10000000>;
+
+               partitions {
+                       compatible = "fixed-partitions";
+                       #address-cells = <1>;
+                       #size-cells = <1>;
+
+                       partition@0 {
+                               label = "u-boot";
+                               reg = <0x0 0x30000>;
+                               read-only;
+                       };
+
+                       partition@30000 {
+                               label = "u-boot-env";
+                               reg = <0x30000 0x10000>;
+                               read-only;
+                       };
+
+                       Factory: partition@40000 {
+                               label = "Factory";
+                               reg = <0x40000 0x8000>;
+                               read-only;
+                       };
+
+                       iNIC_rf: partition@48000 {
+                               label = "iNIC_rf";
+                               reg = <0x48000 0x8000>;
+                               read-only;
+                       };
+
+                       partition@50000 {
+                               compatible = "denx,uimage";
+                               label = "firmware";
+                               reg = <0x50000 0x6d4000>;
+                       };
+
+                       partition@724000 {
+                               label = "manufacture";
+                               reg = <0x724000 0x8c000>;
+                               read-only;
+                       };
+
+                       partition@7b0000 {
+                               label = "backup";
+                               reg = <0x7b0000 0x10000>;
+                               read-only;
+                       };
+
+                       partition@7c0000 {
+                               label = "storage";
+                               reg = <0x7c0000 0x40000>;
+                               read-only;
+                       };
+               };
+       };
+};
+
+&ethernet {
+       pinctrl-names = "default";
+       pinctrl-0 = <&rgmii1_pins>;
+       mtd-mac-address = <&Factory 0x4>;
+
+       port@5 {
+               status = "okay";
+               mediatek,fixed-link = <1000 1 1 1>;
+               phy-mode = "rgmii";
+       };
+};
+
+&gpio0 {
+       rtl8367rb_reset {
+               gpio-hog;
+               gpios = <0 GPIO_ACTIVE_HIGH>;
+               output-high;
+               line-name = "rtl8367rb-reset";
+       };
+};
+
+&pinctrl {
+       state_default: pinctrl0 {
+               gpio {
+                       ralink,group = "i2c", "uartf", "mdio";
+                       ralink,function = "gpio";
+               };
+       };
+};
+
+&pcie {
+       status = "okay";
+};
+
+&pcie0 {
+       wifi@0,0 {
+               compatible = "mediatek,mt76";
+               reg = <0x0000 0 0 0 0>;
+               mediatek,mtd-eeprom = <&iNIC_rf 0x0>;
+               ieee80211-freq-limit = <5000000 6000000>;
+       };
+};
+
+&wmac {
+       ralink,mtd-eeprom = <&Factory 0x0>;
+};
index 77a5b57..0098613 100644 (file)
@@ -367,6 +367,18 @@ define Device/iodata_wn-ac1167gr
 endef
 TARGET_DEVICES += iodata_wn-ac1167gr
 
+define Device/iodata_wn-ac733gr3
+  DTS := WN-AC733GR3
+  DEVICE_TITLE := I-O DATA WN-AC733GR3
+  IMAGE_SIZE := 6992k
+  IMAGES += factory.bin
+  IMAGE/factory.bin := \
+    $$(sysupgrade_bin) | check-size $$$$(IMAGE_SIZE) | \
+    elx-header 01040006 8844A2D168B45A2D
+  DEVICE_PACKAGES := kmod-mt76x0e kmod-switch-rtl8367b
+endef
+TARGET_DEVICES += iodata_wn-ac733gr3
+
 define Device/kimax_u35wf
   DTS := U35WF
   IMAGE_SIZE := 16064k