ramips: add support for netis WF2770
authorSungbo Eo <mans0n@gorani.run>
Mon, 11 Nov 2019 16:23:07 +0000 (01:23 +0900)
committerAdrian Schmutzler <freifunk@adrianschmutzler.de>
Sun, 17 May 2020 16:41:48 +0000 (18:41 +0200)
netis WF2770 is a 2.4/5GHz band AC750 router, based on MediaTek MT7620A.

Specifications:
- SoC: MT7620A
- RAM: DDR2 64MB
- Flash: SPI NOR 16MB
- WiFi:
  - 2.4GHz: SoC internal
  - 5GHz: MT7610EN
- Ethernet: 5x 10/100/1000Mbps
  - Switch: MT7530BU
- UART:
  - J2: 3.3V, RX, TX, GND (3.3V is the square pad) / 57600 8N1

MAC addresses in factory partition:
0x0004: LAN, WiFi 2.4GHz (label_mac-6)
0x0028: not used (label_mac-1)
0x002e: WAN (label_mac)
0x8004: WiFi 5GHz (label_mac+2)

Installation via web interface:
1.  Flash **initramfs** image through the stock web interface.
2.  Boot into OpenWrt and perform sysupgrade with sysupgrade image.

Revert to stock firmware:
1.  Perform sysupgrade with stock image.

Reviewed-by: Pawel Dembicki <paweldembicki@gmail.com>
Signed-off-by: Sungbo Eo <mans0n@gorani.run>
target/linux/ramips/dts/mt7620a_netis_wf2770.dts [new file with mode: 0644]
target/linux/ramips/image/Makefile
target/linux/ramips/image/mt7620.mk
target/linux/ramips/image/mt7621.mk
target/linux/ramips/mt7620/base-files/etc/board.d/02_network

diff --git a/target/linux/ramips/dts/mt7620a_netis_wf2770.dts b/target/linux/ramips/dts/mt7620a_netis_wf2770.dts
new file mode 100644 (file)
index 0000000..a0e9cff
--- /dev/null
@@ -0,0 +1,161 @@
+// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
+/dts-v1/;
+
+#include "mt7620a.dtsi"
+
+#include <dt-bindings/gpio/gpio.h>
+#include <dt-bindings/input/input.h>
+
+/ {
+       compatible = "netis,wf2770", "ralink,mt7620a-soc";
+       model = "NETIS WF2770";
+
+       leds {
+               compatible = "gpio-leds";
+
+               wlan {
+                       label = "wf2770:blue:wlan";
+                       gpios = <&gpio0 14 GPIO_ACTIVE_LOW>;
+                       linux,default-trigger = "phy0tpt";
+               };
+       };
+
+       keys {
+               compatible = "gpio-keys";
+
+               reset {
+                       label = "reset";
+                       gpios = <&gpio0 1 GPIO_ACTIVE_LOW>;
+                       linux,code = <KEY_RESTART>;
+               };
+
+               wps {
+                       label = "wps";
+                       gpios = <&gpio0 2 GPIO_ACTIVE_LOW>;
+                       linux,code = <KEY_WPS_BUTTON>;
+               };
+
+               rfkill {
+                       label = "rfkill";
+                       gpios = <&gpio0 7 GPIO_ACTIVE_LOW>;
+                       linux,code = <KEY_RFKILL>;
+               };
+
+               led-toggle {
+                       label = "led-toggle";
+                       gpios = <&gpio0 11 GPIO_ACTIVE_LOW>;
+                       linux,code = <KEY_LIGHTS_TOGGLE>;
+               };
+       };
+};
+
+&spi0 {
+       status = "okay";
+
+       flash@0 {
+               compatible = "jedec,spi-nor";
+               reg = <0>;
+               spi-max-frequency = <50000000>;
+
+               partitions {
+                       compatible = "fixed-partitions";
+                       #address-cells = <1>;
+                       #size-cells = <1>;
+
+                       partition@0 {
+                               label = "u-boot";
+                               reg = <0x0 0x30000>;
+                               read-only;
+                       };
+
+                       partition@30000 {
+                               label = "config";
+                               reg = <0x30000 0x10000>;
+                               read-only;
+                       };
+
+                       factory: partition@40000 {
+                               label = "factory";
+                               reg = <0x40000 0x10000>;
+                               read-only;
+                       };
+
+                       partition@50000 {
+                               compatible = "denx,uimage";
+                               label = "firmware";
+                               reg = <0x50000 0xfb0000>;
+                       };
+               };
+       };
+};
+
+&state_default {
+       gpio {
+               groups = "i2c", "uartf";
+               function = "gpio";
+       };
+};
+
+&ethernet {
+       pinctrl-names = "default";
+       pinctrl-0 = <&rgmii1_pins &mdio_pins>;
+
+       mtd-mac-address = <&factory 0x4>;
+
+       port@5 {
+               status = "okay";
+               mediatek,fixed-link = <1000 1 1 1>;
+               phy-mode = "rgmii";
+       };
+
+       mdio-bus {
+               status = "okay";
+
+               ethernet-phy@0 {
+                       reg = <0>;
+                       phy-mode = "rgmii";
+               };
+
+               ethernet-phy@1 {
+                       reg = <1>;
+                       phy-mode = "rgmii";
+               };
+
+               ethernet-phy@2 {
+                       reg = <2>;
+                       phy-mode = "rgmii";
+               };
+
+               ethernet-phy@3 {
+                       reg = <3>;
+                       phy-mode = "rgmii";
+               };
+
+               ethernet-phy@4 {
+                       reg = <4>;
+                       phy-mode = "rgmii";
+               };
+
+               ethernet-phy@1f {
+                       reg = <0x1f>;
+                       phy-mode = "rgmii";
+               };
+       };
+};
+
+&pcie {
+       status = "okay";
+};
+
+&pcie0 {
+       wifi@0,0 {
+               compatible = "mediatek,mt76";
+               reg = <0x0000 0 0 0 0>;
+               mediatek,mtd-eeprom = <&factory 0x8000>;
+               ieee80211-freq-limit = <5000000 6000000>;
+       };
+};
+
+&wmac {
+       ralink,mtd-eeprom = <&factory 0x0>;
+};
index 4806226..b00e6d8 100644 (file)
@@ -100,6 +100,12 @@ define Build/mkdlinkfw-factory
        mv $@.new $@
 endef
 
+define Build/netis-tail
+       echo -n $(1) >> $@
+       echo -n $(UIMAGE_NAME)-yun | $(STAGING_DIR_HOST)/bin/mkhash md5 | \
+               sed 's/../\\\\x&/g' | xargs echo -ne >> $@
+endef
+
 define Build/poray-header
        $(STAGING_DIR_HOST)/bin/mkporayfw $(1) -f $@ -o $@.new
        mv $@.new $@
index 4fa8c68..e435b1d 100644 (file)
@@ -700,6 +700,17 @@ define Device/netgear_wn3000rp-v3
 endef
 TARGET_DEVICES += netgear_wn3000rp-v3
 
+define Device/netis_wf2770
+  SOC := mt7620a
+  IMAGE_SIZE := 16064k
+  UIMAGE_NAME := WF2770_0.0.00
+  DEVICE_VENDOR := NETIS
+  DEVICE_MODEL := WF2770
+  DEVICE_PACKAGES := kmod-mt76x0e
+  KERNEL_INITRAMFS := $(KERNEL_DTB) | netis-tail WF2770 | uImage lzma
+endef
+TARGET_DEVICES += netis_wf2770
+
 define Device/nexx_wt3020-4m
   SOC := mt7620n
   BLOCKSIZE := 4k
index 082bb31..343379b 100644 (file)
@@ -81,12 +81,6 @@ define Build/iodata-mstc-header
        )
 endef
 
-define Build/netis-tail
-       echo -n $(1) >> $@
-       echo -n $(UIMAGE_NAME)-yun | $(STAGING_DIR_HOST)/bin/mkhash md5 | \
-               sed 's/../\\\\x&/g' | xargs echo -ne >> $@
-endef
-
 define Build/ubnt-erx-factory-image
        if [ -e $(KDIR)/tmp/$(KERNEL_INITRAMFS_IMAGE) -a "$$(stat -c%s $@)" -lt "$(KERNEL_SIZE)" ]; then \
                echo '21001:6' > $(1).compat; \
index 20932f6..c1dbf8d 100755 (executable)
@@ -170,6 +170,7 @@ ramips_setup_interfaces()
                        "1:lan:4" "2:lan:3" "4:lan:2" "5:lan:1" "0:wan" "6@eth0"
                ;;
        linksys,e1700|\
+       netis,wf2770|\
        ralink,mt7620a-mt7530-evb)
                ucidef_add_switch "switch0"
                ucidef_add_switch_attr "switch0" "enable" "false"
@@ -338,6 +339,10 @@ ramips_setup_macs()
        linksys,e1700)
                wan_mac=$(mtd_get_mac_ascii config WAN_MAC_ADDR)
                ;;
+       netis,wf2770)
+               wan_mac=$(mtd_get_mac_binary factory 0x2e)
+               label_mac=$wan_mac
+               ;;
        tplink,archer-c2-v1|\
        tplink,archer-c20-v1|\
        tplink,archer-c20i|\