ath79: add support for Comfast E314N-v2
authorJoan Moreau <jom@grosjo.net>
Sat, 30 Mar 2019 13:27:17 +0000 (13:27 +0000)
committerDavid Bauer <mail@david-bauer.net>
Fri, 9 Aug 2019 05:49:21 +0000 (07:49 +0200)
Taken code from https://patchwork.ozlabs.org/patch/884850/ that was never
pushed by the author, and adapted to ath79.

The Comfast E314N-V2 is a 2.4 GHz 2x2 radio with a built-in directional
antenna and a second Ethernet port - very similar to the Ubiquiti
NanoStation M2. The Ethernet port features a pass-through PoE capability,
enabled or disabled with a slide switch.

Specifications :
- System-On-Chip: Qualcomm/Atheros QCA9531
- CPU/Speed: 650 MHz
- Flash size: 8 MiB
- RAM: 64 MiB
- 2 Ethernet 1Gbp
- 1 reset button
- 1 switch to choose PoE from LAN or Wan. 48Vdc
- Wifi 2.4 Ghz (b/g/n)
- UART inside the box (3.3V, pins marked on the PCB)

Firmware can be flashed on these units by the following method:
1.) Apply power to the unit
2.) Immediately AFTER applying power, hold down the reset button
3.) The WAN, LAN, and wireless lights will flash - wait three seconds
    (three flashes) and then release the button.
4.) After a second, the lights will flutter quickly and the unit will be
    visible at 192.168.1.1. A web page will be available to enable quick
    and simple uploading and flashing of firmware.

During the boot process, these units also look for a tftp server at
192.168.1.10. If one is present, the firmware can be uploaded as a file
called firmware-auto.bin

Signed-off-by: Joan Moreau <jom@grosjo.net>
[wrapped commit message - fix commit title capitalization]
Signed-off-by: David Bauer <mail@david-bauer.net>
target/linux/ath79/base-files/etc/board.d/01_leds
target/linux/ath79/base-files/etc/board.d/02_network
target/linux/ath79/dts/qca9531_comfast_cf-e314n-v2.dts [new file with mode: 0644]
target/linux/ath79/image/generic.mk

index aad41b0..db7991d 100755 (executable)
@@ -54,6 +54,15 @@ comfast,cf-e120a-v3)
        ucidef_set_led_rssi "rssimediumhigh" "RSSIMEDIUMHIGH" "$boardname:green:rssimediumhigh" "wlan0" "51" "100"
        ucidef_set_led_rssi "rssihigh" "RSSIHIGH" "$boardname:green:rssihigh" "wlan0" "76" "100"
        ;;
+comfast,cf-e314n-v2)
+        ucidef_set_led_netdev "wan" "WAN" "$boardname:green:wan" "eth0"
+        ucidef_set_led_netdev "lan" "LAN" "$boardname:green:lan" "eth1"
+       ucidef_set_rssimon "wlan0" "200000" "1"
+        ucidef_set_led_rssi "rssilow" "RSSILOW" "$boardname:red:rssilow" "wlan0" "1" "100"
+        ucidef_set_led_rssi "rssimediumlow" "RSSIMEDIUMLOW" "$boardname:red:rssimediumlow" "wlan0" "26" "100"
+        ucidef_set_led_rssi "rssimediumhigh" "RSSIMEDIUMHIGH" "$boardname:green:rssimediumhigh" "wlan0" "51" "100"
+        ucidef_set_led_rssi "rssihigh" "RSSIHIGH" "$boardname:green:rssihigh" "wlan0" "76" "100"
+        ;;
 comfast,cf-e5)
        ucidef_set_led_switch "lan" "LAN" "$boardname:blue:lan" "switch0" "0x02"
        ucidef_set_led_netdev "wan" "WAN" "$boardname:blue:wan" "eth1"
index 3b89c9c..dd9fa3c 100755 (executable)
@@ -103,6 +103,7 @@ ath79_setup_interfaces()
                ;;
        comfast,cf-e110n-v2|\
        comfast,cf-e120a-v3|\
+       comfast,cf-e314n-v2|\
        tplink,cpe210-v1|\
        tplink,cpe220-v2|\
        tplink,cpe510-v1|\
diff --git a/target/linux/ath79/dts/qca9531_comfast_cf-e314n-v2.dts b/target/linux/ath79/dts/qca9531_comfast_cf-e314n-v2.dts
new file mode 100644 (file)
index 0000000..fa98f75
--- /dev/null
@@ -0,0 +1,154 @@
+// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
+/dts-v1/;
+
+#include <dt-bindings/gpio/gpio.h>
+#include <dt-bindings/input/input.h>
+
+#include "qca953x.dtsi"
+
+/ {
+       compatible = "comfast,cf-e314n-v2", "qca,qca9531";
+       model = "COMFAST CF-E314N v2";
+
+       aliases {
+               serial0 = &uart;
+               led-boot = &system;
+               led-failsafe = &system;
+               led-upgrade = &system;
+       };
+
+       leds {
+               compatible = "gpio-leds";
+
+               pinctrl-names = "default";
+               pinctrl-0 = <&jtag_disable_pins &led_rssilow_pin &led_rssimediumhigh_pin &led_rssihigh_pin>;
+
+               wan {
+                       label = "cf-e314n-v2:green:wan";
+                       gpios = <&gpio 3 GPIO_ACTIVE_LOW>;
+               };
+
+               lan {
+                       label = "cf-e314n-v2:green:lan";
+                       gpios = <&gpio 2 GPIO_ACTIVE_LOW>;
+               };
+
+               rssilow {
+                       label = "cf-e314n-v2:red:signal1";
+                       gpios = <&gpio 11 GPIO_ACTIVE_LOW>;
+               };
+
+               rssimediumlow {
+                       label = "cf-e314n-v2:red:signal2";
+                       gpios = <&gpio 12 GPIO_ACTIVE_LOW>;
+               };
+
+               rssimediumhigh {
+                       label = "cf-e314n-v2:green:signal3";
+                       gpios = <&gpio 13 GPIO_ACTIVE_LOW>;
+               };
+
+               system: rssihigh {
+                       label = "cf-e314n-v2:green:signal4";
+                       gpios = <&gpio 14 GPIO_ACTIVE_LOW>;
+               };
+
+               wlan {
+                       label = "cf-e314n-v2:green:wlan";
+                       gpios = <&gpio 0 GPIO_ACTIVE_LOW>;
+                       linux,default-trigger = "phy0tpt";
+               };
+       };
+
+       keys {
+               compatible = "gpio-keys";
+
+               reset {
+                       label = "reset";
+                       linux,code = <KEY_RESTART>;
+                       gpios = <&gpio 17 GPIO_ACTIVE_LOW>;
+                       debounce-interval = <60>;
+               };
+       };
+};
+
+&pinmux {
+       led_rssilow_pin: pinmux_rssilow_pin {
+               pinctrl-single,bits = <0x8 0x0 0xff000000>;
+       };
+
+       led_rssimediumhigh_pin: pinmux_rssimediumhigh_pin {
+               pinctrl-single,bits = <0xc 0x0 0x00ff0000>;
+       };
+
+       led_rssihigh_pin: pinmux_rssihigh_pin {
+               pinctrl-single,bits = <0x10 0x0 0x000000ff>;
+       };
+};
+
+&spi {
+       status = "okay";
+       num-cs = <1>;
+
+       flash@0 {
+               compatible = "jedec,spi-nor";
+               reg = <0>;
+               spi-max-frequency = <25000000>;
+
+               partitions {
+                       compatible = "fixed-partitions";
+                       #address-cells = <1>;
+                       #size-cells = <1>;
+
+                       partition@0 {
+                               label = "u-boot";
+                               reg = <0x000000 0x010000>;
+                               read-only;
+                       };
+
+                       art: partition@10000 {
+                               label = "art";
+                               reg = <0x010000 0x010000>;
+                               read-only;
+                       };
+
+                       partition@20000 {
+                               compatible = "denx,uimage";
+                               label = "firmware";
+                               reg = <0x020000 0x7c0000>;
+                       };
+
+                       partition@7e0000 {
+                               label = "configs";
+                               reg = <0x7e0000 0x010000>;
+                               read-only;
+                       };
+
+                       partition@7f0000 {
+                               label = "nvram";
+                               reg = <0x7f0000 0x010000>;
+                               read-only;
+                       };
+               };
+       };
+};
+
+&uart {
+       status = "okay";
+};
+
+&eth0 {
+       status = "okay";
+       mtd-mac-address = <&art 0x0>;
+       phy-handle = <&swphy4>;
+};
+
+&eth1 {
+       status = "okay";
+       mtd-mac-address = <&art 0x6>;
+};
+
+&wmac {
+       status = "okay";
+       mtd-cal-data = <&art 0x1000>;
+};
index 5127cfd..7ceb5a8 100644 (file)
@@ -256,6 +256,15 @@ define Device/comfast_cf-e120a-v3
 endef
 TARGET_DEVICES += comfast_cf-e120a-v3
 
+define Device/comfast_cf-e314n-v2
+  ATH_SOC := qca9531
+  DEVICE_VENDOR := COMFAST
+  DEVICE_MODEL := CF-E314N
+  DEVICE_VARIANT := v2
+  DEVICE_PACKAGES := rssileds
+endef
+TARGET_DEVICES += comfast_cf-e314n-v2
+
 define Device/comfast_cf-e5
   ATH_SOC := qca9531
   DEVICE_VENDOR := COMFAST