ipq-wifi: drop upstreamed board-2.bin The BDFs for the: Aruba AP-303 ASUS RT-AC42U AVM FRITZ!Repeater 1200 Buffalo WTR-M2133HP Cell C RTL30VW D-Link DAP-2610 EnGenius EAP2200 EnGenius EMD1 EnGenius EMR3500 EnGenius EMR5000 EZVIZ CS-W3-WD1200G EUP Google Wifi Linksys MR8300 V1.0 Luma WRTQ-329ACN MobiPromo CM520-79F NEC Platforms WG2600HP3 Plasma Cloud PA1200 (updated version) Plasma Cloud PA2200 ZTE MF286D were upstreamed to the ath10k-firmware repository and landed in linux-firmware.git. Furthermore the BDFs for the: 8devices Habanero OpenMesh A62 OpenMesh A42 AVM FRITZ!Box 4040 have been updated. Signed-off-by: Christian Lamparter <chunkeey@gmail.com>
kernel: bump 5.15 to 5.15.38 Deleted (upstreamed): mediatek/patches-5.15/120-10-v5.18-mtd-nand-fix-ecc-parameters-for-mt7622.patch [1] Other patches automatically rebased. [1] https://git.kernel.org/pub/scm/linux/kernel/git/stable/linux.git/commit/?h=v5.15.38&id=3ec920d755ae69c201b358e8d8e96c32f51145d8 Signed-off-by: Rui Salvaterra <rsalvaterra@gmail.com>
ipq806x: add support for Arris TR4400 v2 / RAC2V1A Hardware specs: SoC: Qualcomm IPQ8065 (dual core Cortex-A15) RAM: 512 MB DDR3 Flash: 256 MB NAND, 32 MB NOR WiFi: QCA9983 2.4 GHz, QCA9984 5 GHz Switch: QCA8337 Ethernet: 5x 10/100/1000 Mbit/s USB: 1x USB 3.0 Type-A Buttons: WPS, Reset Power: 12 VDC, 2.5 A Ethernet ports: 1x WAN: connected to eth2 4x LAN: connected via the switch to eth0 and eth1 (eth0 is disabled in OEM firmware) MAC addresses (OEM and OpenWrt): fw_env @ 0x00 d4:ab:82:??:??:?a LAN (eth1) fw_env @ 0x06 d4:ab:82:??:??:?b WAN (eth2) fw_env @ 0x0c d4:ab:82:??:??:?c WLAN 2.4 GHz (ath1) fw_env @ 0x12 d4:ab:82:??:??:?d WLAN 5 GHz (ath0) fw_env @ 0x18 d4:ab:82:??:??:?e OEM usage unknown (eth0 in OpenWrt) OID d4:ab:82 is registered to: ARRIS Group, Inc., 6450 Sequence Drive, San Diego CA 92121, US More info: https://openwrt.org/inbox/toh/arris/tr4400_v2 IMPORTANT: This port requires moving the 'fw_env' partition prior to first boot to consolidate 70% of the usable space in flash into a contiguous partition. 'fw_env' contains factory-programmed MAC addresses, SSIDs, and passwords. Its contents must be copied to 'rootfs_1' prior to booting via initramfs. Note that the stock 'fw_env' partition will be wiped during sysupgrade. A writable 'stock_fw_env' partition pointing to the old, stock location is included in the port to help rolling back this change if desired. Installation: - Requires serial access and a TFTP server. - Fully boot stock, press ENTER, type in: mtd erase /dev/mtd21 dd if=/dev/mtd22 bs=128K count=1 | mtd write - /dev/mtd21 umount /config && ubidetach -m 23 && mtd erase /dev/mtd23 - Reboot and interrupt U-Boot by pressing a key, type in: set mtdids 'nand0=nand0' set mtdparts 'mtdparts=nand0:155M@0x6500000(mtd_ubi)' set bootcmd 'ubi part mtd_ubi && ubi read 0x44000000 kernel && bootm' env save - Setup TFTP server serving initramfs image as 'recovery.bin', type in: set ipaddr 192.168.1.1 set serverip 192.168.1.2 tftpboot recovery.bin && bootm - Use sysupgrade to install squashfs image. This port is based on work done by AmadeusGhost <amadeus@jmu.edu.cn>. Signed-off-by: Rodrigo Balerdi <lanchon@gmail.com> [add 5.15 changes for 0069-arm-boot-add-dts-files.patch] Signed-off-by: Sungbo Eo <mans0n@gorani.run>
ipq806x: RT4230W: utilize nvmem-cells for ath10k caldata Converts extraction entries from 11-ath10k-caldata into nvmem-cells in the individual board's device-tree file. Same as commit 2047058 ("ipq806x: utilize nvmem-cells for pre-calibration data") Signed-off-by: Chukun Pan <amadeus@jmu.edu.cn> Reviewed-by: Ansuel Smith <ansuelsmth@gmail.com>
ipq806x: Askey RT4230W REV6: enable onboard spi flash There is a mr25h256 spi flash on this machine. From the mtd backup of the stock firmware, this spi flash is empty. [ 3.652745] spi_qup 1a280000.spi: IN:block:16, fifo:64, OUT:block:16, fifo:64 [ 3.653925] spi-nor spi0.0: mr25h256 (32 Kbytes) Signed-off-by: Chukun Pan <amadeus@jmu.edu.cn>
kernel: bump 5.15 to 5.15.34 Deleted (upstreamed): generic/pending-5.15/850-0003-PCI-aardvark-Fix-support-for-MSI-interrupts.patch [1] [1] https://git.kernel.org/pub/scm/linux/kernel/git/stable/linux.git/commit/?h=v5.15.34&id=60eabd66d17fa2cbc31f670b2f201f0bc54090a2 Signed-off-by: Rui Salvaterra <rsalvaterra@gmail.com>
kernel: bump 5.10 to 5.10.111 Removed upstreamed: pending-5.10/850-0003-PCI-aardvark-Fix-support-for-MSI-interrupts.patch apm821xx/patches-5.10/150-ata-sata_dwc_460ex-Fix-crash-due-to-OOB-write.patch All other patches automatically rebased. Build system: x86_64 Build-tested: bcm2711/RPi4B, mt7622/RT3200 Run-tested: bcm2711/RPi4B, mt7622/RT3200 Signed-off-by: John Audia <graysky@archlinux.us>
ipq806x: fix wrong CPU OPP for ipq8062 Fix wrong CPU OPP for ipq8062. Revision of the SoC added an extra 25mV for every pvs. Also fix the voltage min/max value that were wrong. Reviewed-by: Robert Marko robimarko@gmail.com Signed-off-by: Ansuel Smith <ansuelsmth@gmail.com>
ipq806x: fix USB bug in 5.10 dtsi additions The existing device tree has incorrect definitions for usb3_0 and usb3_1 and the blocks they depend upon: their addresses and interrupts are swapped. However, their clocks and resets are not. The result is that the USB blocks are non-functional if only one of them is enabled. This fix backports the definitions from mainline Linux 5.15 to OpenWrt's 5.10 dtsi additions. See the relevant mainline code here: https://github.com/torvalds/linux/blob/v5.17/arch/arm/boot/dts/qcom-ipq8064.dtsi#L1062-L1148 This fix does not break existing ports. But some ports may have enabled both USB blocks even thought their board only implements one, because enabling a single USB block would not have worked before this fix. This means that revisiting all ports of ipq806x devices that implement a single USB port is advised. This work must be done by maintainers that can determine which USB block corresponds to the implemented port on their hardware. Note that this fix swaps the names of the hardware ports. This is unfortunate, but will happen anyway when switching to kernel 5.15. Thus, it is best to do this ASAP, before users get to depend on port names. It is strongly recommended that this fix is backported to 22.03 before its release. This will minimize the number of users affected by the port name swap. Signed-off-by: Rodrigo Balerdi <lanchon@gmail.com>
ipq806x: remove non-working fixes for USB bug in 5.10 dtsi additions These workarrounds are incomplete and non-functional, and thus not needed. Signed-off-by: Rodrigo Balerdi <lanchon@gmail.com>
kernel: bump 5.10 to 5.10.110 Removed upstreamed: generic/backport-5.10/350-v5.18-MIPS-pgalloc-fix-memory-leak-caused-by-pgd_free.patch generic/pending-5.10/850-0014-PCI-aardvark-Fix-reading-PCI_EXP_RTSTA_PME-bit-on-em.patch ipq40xx/patches-5.10/105-ipq40xx-fix-sleep-clock.patch All patches automatically rebased. Build system: x86_64 Build-tested: bcm2711/RPi4B, mt7622/RT3200 Run-tested: bcm2711/RPi4B, mt7622/RT3200 Compile-/run-tested: ath79/generic (Archer C7 v2). Signed-off-by: John Audia <graysky@archlinux.us>
kernel: bump 5.15 to 5.15.33 Deleted (upstreamed): generic/backport-5.15/350-v5.18-MIPS-pgalloc-fix-memory-leak-caused-by-pgd_free.patch [1] generic/backport-5.15/730-v5.16-hv-utils-add-PTP_1588_CLOCK-to-Kconfig-to-fix-build.patch [2] generic/pending-5.15/850-0014-PCI-aardvark-Fix-reading-PCI_EXP_RTSTA_PME-bit-on-em.patch [3] generic/pending-5.15/850-0002-PCI-aardvark-Fix-reading-MSI-interrupt-number.patch [4] Manually rebased: generic/pending-5.15/850-0002-PCI-aardvark-Fix-reading-MSI-interrupt-number.patch ramips/patches-5.15/710-at803x.patch [1] https://git.kernel.org/pub/scm/linux/kernel/git/stable/linux.git/commit/?h=v5.15.33&id=d29cda15cab086d82d692de016f7249545d4b6b4 [2] https://git.kernel.org/pub/scm/linux/kernel/git/stable/linux.git/commit/?h=v5.15.33&id=d5aad7d63b1b5c1f3c4b69e12c05e7c7d196fae8 [3] https://git.kernel.org/pub/scm/linux/kernel/git/stable/linux.git/commit/?h=v5.15.33&id=ed750e22e44366e264bcdf7b1cf0713f08f7980a [4] https://git.kernel.org/pub/scm/linux/kernel/git/stable/linux.git/commit/?h=v5.15.33&id=0fe94b84c43cfea867e1721606185e8686d7d32f Signed-off-by: Rui Salvaterra <rsalvaterra@gmail.com> [Refresh patches again] [Remove generic/pending-5.15/850-0002-PCI-aardvark-Fix-reading-MSI-interrupt-number.patch] Signed-off-by: Hauke Mehrtens <hauke@hauke-m.de>
kernel: bump 5.15 to 5.15.32 Patches automatically rebased. Signed-off-by: Rui Salvaterra <rsalvaterra@gmail.com>
kernel: move some symbols to generic config This commit add some enabled symbols to generic config. LTO is only supported by clang compiler and therefore should be disabled in the generic config instead of duplicating this symbol in each target. CONFIG_LTO_NONE do this job. The second group of symbols is enabled by the options available in the generic config and is therefore added here: * CONFIG_AF_UNIX_OOB is selected by CONFIG_NET && CONFIG_UNIX, * CONFIG_BINARY_PRINTF is selected by CONFIG_BPF_SYSCALL, * CONFIG_NET_SOCK_MSG is selected by CONFIG_BPF_SYSCALL && CONFIG_NET. The other symbols are disabled and should be in the generic config. This commit also removes these symbols from subtargets. Signed-off-by: Aleksander Jan Bajkowski <olek2@wp.pl>
ipq806x: 5:15: fix dedicated krait cpufreq Fix dedicated cpufreq for kernel 5.15 as they changed module order and now it can happen that cpufreq probe after cache driver. Also add lock between cache scaling in set_target as it's now required by opp functions. Signed-off-by: Ansuel Smith <ansuelsmth@gmail.com>
ipq806x: rework rootfs conflicts patch for smem Now that smem actually free the leaked parts, when a rootfs partition is detected, the kernel panics as it try to free the static space allocated for the "ubi" name. Change the logic and fix the name at the allocate_partition function to correctly free the space allocated by smem. Signed-off-by: Ansuel Smith <ansuelsmth@gmail.com>
ipq806x: 5:15: add testing kernel version Refresh patch for 5.15 Rework tweak patch to sync with upstream ipq8064 dtsi and fix regression introduced. Rename nand_controller to nand in every dts. Signed-off-by: Ansuel Smith <ansuelsmth@gmail.com>
ipq806x: 5:15: drop upstream patch - Drop stmmac upstream patches - Drop tsens patches - Drop ADM driver - Drop SMEM parser Signed-off-by: Ansuel Smith <ansuelsmth@gmail.com>