kirkwood: add support for 4.3

[openwrt/staging/chunkeey.git] / docs / network.tex

diff --git a/docs/network.tex b/docs/network.tex
index c14c4db9ed7f69cf9704a35e465870cc0a6affb8..cf1200dcd43e0081ebfea483cf4087d92414e86b 100644 (file)
--- a/docs/network.tex
+++ b/docs/network.tex
@@ -22,11 +22,13 @@ of interfaces and add:
 \end{Verbatim}
 
 It is possible to use VLAN tagging on an interface simply by adding the VLAN IDs
-to it, e.g. \texttt{eth0.1}. These can be nested as well. See the switch section for
+to it, e.g. \texttt{eth0.15}. These can be nested as well. See the switch section for
 this.
 
 \begin{Verbatim}
-config inter
+config interface
+    option ifname    "eth0.15"
+    option proto     "none"
 \end{Verbatim}
 
 This sets up a simple static configuration for \texttt{eth0}. \texttt{proto} specifies the
@@ -105,7 +107,7 @@ The name for the route section is optional, the \texttt{interface}, \texttt{targ
 \texttt{gateway} options are mandatory.
 Leaving out the \texttt{netmask} option will turn the route into a host route.
 
-\subsubsection{Setting up the switch (currently broadcom only)}
+\subsubsection{Setting up the switch (broadcom only)}
 
 The switch configuration is set by adding a \texttt{'switch'} config section.
 Example:
@@ -150,6 +152,27 @@ Three interfaces will be automatically created using this switch layout :
 You can then assign those interfaces to a custom network configuration name
 like \texttt{lan}, \texttt{wan} or \texttt{dmz} for instance.
 
+\subsubsection{Setting up the switch (swconfig)}
+
+\emph{swconfig} based configurations have a different structure with one extra
+section per vlan. The example below shows a typical configuration:
+
+\begin{Verbatim}
+config 'switch' 'eth0'
+        option 'reset' '1'
+        option 'enable_vlan' '1'
+
+config 'switch_vlan' 'eth0_1'
+        option 'device' 'eth0'
+        option 'vlan' '1'
+        option 'ports' '0 1 2 3 5t'
+
+config 'switch_vlan' 'eth0_2'
+        option 'device' 'eth0'
+        option 'vlan' '2'
+        option 'ports' '4 5t'
+\end{Verbatim}
+
 \subsubsection{Setting up IPv6 connectivity}
 
 OpenWrt supports IPv6 connectivity using PPP, Tunnel brokers or static