target/linux/ramips/dts/V11STFE.dts

   1 /dts-v1/;
   2
   3 #include "rt2880.dtsi"
   4
   5 / {
   6         compatible = "V11ST-FE", "ralink,rt2880-soc";
   7         model = "Ralink V11ST-FE";
   8
   9         pci@440000 {
  10                 status = "okay";
  11
  12                 host-bridge {
  13                         pci-bridge@1 {
  14                                 status = "okay";
  15                         };
  16                 };
  17         };
  18
  19         nor-flash@1c000000 {
  20                 compatible = "cfi-flash";
  21                 reg = <0x1c000000 0x800000>;
  22                 bank-width = <2>;
  23                 #address-cells = <1>;
  24                 #size-cells = <1>;
  25
  26                 partition@0 {
  27                         reg = <0x0 0x0030000>;
  28                         label = "u-boot";
  29                         read-only;
  30                 };
  31
  32                 partition@30000 {
  33                         reg = <0x00030000 0x00010000>;
  34                         label = "u-boot-env";
  35                         read-only;
  36                 };
  37
  38                 factory: partition@40000 {
  39                         reg = <0x00040000 0x00010000>;
  40                         label = "factory";
  41                         read-only;
  42                 };
  43
  44                 partition@50000 {
  45                         reg = <0x00050000 0x003b0000>;
  46                         label = "firmware";
  47                 };
  48         };
  49
  50         gpio-keys-polled {
  51                 compatible = "gpio-keys-polled";
  52                 #address-cells = <1>;
  53                 #size-cells = <0>;
  54                 poll-interval = <100>;
  55
  56                 wps {
  57                         label = "wps";
  58                         gpios = <&gpio0 0 0>;
  59                         linux,code = <0x211>;
  60                 };
  61         };
  62
  63         gpio-leds {
  64                 compatible = "gpio-leds";
  65
  66                 status {
  67                         label = "v11st-fe:green:status";
  68                         gpios = <&gpio0 12 1>;
  69                 };
  70         };
  71 };
  72
  73 &gpio0 {
  74         status = "okay";
  75 };
  76
  77 &ethernet {
  78         status = "okay";
  79 };
  80
  81 &wmac {
  82         ralink,mtd-eeprom = <&factory 0>;
  83 };