remove sed test garbage left behind on some hosts with an old/unsupported sed

[openwrt/staging/dedeckeh.git] / openwrt / docs / network.txt

diff --git a/openwrt/docs/network.txt b/openwrt/docs/network.txt
index 5610e1d6dae484e7eb6e272e46fd876a192cb5ae..69dbaa60ba8f492c0875060b09b583173921fa48 100644 (file)
--- a/openwrt/docs/network.txt
+++ b/openwrt/docs/network.txt
@@ -45,6 +45,35 @@ PPP based protocols (pppoe, pptp, ...) accept these options:
                ",<interval>" to the keepalive value
        demand:
                Use Dial on Demand (value specifies the maximum idle time)
                ",<interval>" to the keepalive value
        demand:
                Use Dial on Demand (value specifies the maximum idle time)

+               
+       (pptp)
+       server: The remote pptp server IP

 
 For all protocol types, you can also specify the MTU by using the "mtu" option.
 
 
 For all protocol types, you can also specify the MTU by using the "mtu" option.
 

+
+
+
+       Setting up the switch (currently broadcom only)
+
+
+The switch configuration is set by adding a 'switch' config section.
+Example: 
+
+       config switch eth0
+               option vlan0 "1 2 3 4 5*"
+               option vlan1 "0 5"
+
+On Broadcom hardware the section name needs to be eth0, as the switch driver
+does not detect the switch on any other physical device.
+Every vlan option needs to have the name vlan<n> where <n> is the VLAN number
+as used in the switch driver.
+As value it takes a list of ports with these optional suffixes:
+
+       '*': Set the default VLAN (PVID) of the Port to the current VLAN
+       'u': Force the port to be untagged
+       't': Force the port to be tagged
+
+The CPU port defaults to tagged, all other ports to untagged.
+On Broadcom hardware the CPU port is always 5. The other ports may vary with 
+different hardware.