#define IEEE80211_STYPE_ACTION 0x00D0
/* control */
+#define IEEE80211_STYPE_BACK_REQ 0x0080
+#define IEEE80211_STYPE_BACK 0x0090
#define IEEE80211_STYPE_PSPOLL 0x00A0
#define IEEE80211_STYPE_RTS 0x00B0
#define IEEE80211_STYPE_CTS 0x00C0
/* miscellaneous IEEE 802.11 constants */
-#define IEEE80211_MAX_FRAG_THRESHOLD 2346
-#define IEEE80211_MAX_RTS_THRESHOLD 2347
+#define IEEE80211_MAX_FRAG_THRESHOLD 2352
+#define IEEE80211_MAX_RTS_THRESHOLD 2353
#define IEEE80211_MAX_AID 2007
#define IEEE80211_MAX_TIM_LEN 251
-#define IEEE80211_MAX_DATA_LEN 2304
/* Maximum size for the MA-UNITDATA primitive, 802.11 standard section
6.2.1.1.2.
- The figure in section 7.1.2 suggests a body size of up to 2312
- bytes is allowed, which is a bit confusing, I suspect this
- represents the 2304 bytes of real data, plus a possible 8 bytes of
- WEP IV and ICV. (this interpretation suggested by Ramiro Barreiro) */
+ 802.11e clarifies the figure in section 7.1.2. The frame body is
+ up to 2304 octets long (maximum MSDU size) plus any crypt overhead. */
+#define IEEE80211_MAX_DATA_LEN 2304
+/* 30 byte 4 addr hdr, 2 byte QoS, 2304 byte MSDU, 12 byte crypt, 4 byte FCS */
+#define IEEE80211_MAX_FRAME_LEN 2352
#define IEEE80211_MAX_SSID_LEN 32
u8 new_chan;
u8 switch_count;
} __attribute__((packed)) chan_switch;
+ struct{
+ u8 action_code;
+ u8 dialog_token;
+ __le16 capab;
+ __le16 timeout;
+ __le16 start_seq_num;
+ } __attribute__((packed)) addba_req;
+ struct{
+ u8 action_code;
+ u8 dialog_token;
+ __le16 status;
+ __le16 capab;
+ __le16 timeout;
+ } __attribute__((packed)) addba_resp;
+ struct{
+ u8 action_code;
+ __le16 params;
+ __le16 reason_code;
+ } __attribute__((packed)) delba;
} u;
} __attribute__ ((packed)) action;
} u;
u8 ra[6];
} __attribute__ ((packed));
+/**
+ * struct ieee80211_bar - HT Block Ack Request
+ *
+ * This structure refers to "HT BlockAckReq" as
+ * described in 802.11n draft section 7.2.1.7.1
+ */
+struct ieee80211_bar {
+ __le16 frame_control;
+ __le16 duration;
+ __u8 ra[6];
+ __u8 ta[6];
+ __le16 control;
+ __le16 start_seq_num;
+} __attribute__((packed));
+
+/**
+ * struct ieee80211_ht_cap - HT capabilities
+ *
+ * This structure refers to "HT capabilities element" as
+ * described in 802.11n draft section 7.3.2.52
+ */
+struct ieee80211_ht_cap {
+ __le16 cap_info;
+ u8 ampdu_params_info;
+ u8 supp_mcs_set[16];
+ __le16 extended_ht_cap_info;
+ __le32 tx_BF_cap_info;
+ u8 antenna_selection_info;
+} __attribute__ ((packed));
+
+/**
+ * struct ieee80211_ht_cap - HT additional information
+ *
+ * This structure refers to "HT information element" as
+ * described in 802.11n draft section 7.3.2.53
+ */
+struct ieee80211_ht_addt_info {
+ u8 control_chan;
+ u8 ht_param;
+ __le16 operation_mode;
+ __le16 stbc_param;
+ u8 basic_set[16];
+} __attribute__ ((packed));
+
+/* 802.11n HT capabilities masks */
+#define IEEE80211_HT_CAP_SUP_WIDTH 0x0002
+#define IEEE80211_HT_CAP_MIMO_PS 0x000C
+#define IEEE80211_HT_CAP_GRN_FLD 0x0010
+#define IEEE80211_HT_CAP_SGI_20 0x0020
+#define IEEE80211_HT_CAP_SGI_40 0x0040
+#define IEEE80211_HT_CAP_DELAY_BA 0x0400
+#define IEEE80211_HT_CAP_MAX_AMSDU 0x0800
+#define IEEE80211_HT_CAP_AMPDU_FACTOR 0x03
+#define IEEE80211_HT_CAP_AMPDU_DENSITY 0x1C
+/* 802.11n HT IE masks */
+#define IEEE80211_HT_IE_CHA_SEC_OFFSET 0x03
+#define IEEE80211_HT_IE_CHA_WIDTH 0x04
+#define IEEE80211_HT_IE_HT_PROTECTION 0x0003
+#define IEEE80211_HT_IE_NON_GF_STA_PRSNT 0x0004
+#define IEEE80211_HT_IE_NON_HT_STA_PRSNT 0x0010
+
+/* MIMO Power Save Modes */
+#define WLAN_HT_CAP_MIMO_PS_STATIC 0
+#define WLAN_HT_CAP_MIMO_PS_DYNAMIC 1
+#define WLAN_HT_CAP_MIMO_PS_INVALID 2
+#define WLAN_HT_CAP_MIMO_PS_DISABLED 3
/* Authentication algorithms */
#define WLAN_AUTH_OPEN 0
WLAN_STATUS_UNSUPP_RSN_VERSION = 44,
WLAN_STATUS_INVALID_RSN_IE_CAP = 45,
WLAN_STATUS_CIPHER_SUITE_REJECTED = 46,
+ /* 802.11e */
+ WLAN_STATUS_UNSPECIFIED_QOS = 32,
+ WLAN_STATUS_ASSOC_DENIED_NOBANDWIDTH = 33,
+ WLAN_STATUS_ASSOC_DENIED_LOWACK = 34,
+ WLAN_STATUS_ASSOC_DENIED_UNSUPP_QOS = 35,
+ WLAN_STATUS_REQUEST_DECLINED = 37,
+ WLAN_STATUS_INVALID_QOS_PARAM = 38,
+ WLAN_STATUS_CHANGE_TSPEC = 39,
+ WLAN_STATUS_WAIT_TS_DELAY = 47,
+ WLAN_STATUS_NO_DIRECT_LINK = 48,
+ WLAN_STATUS_STA_NOT_PRESENT = 49,
+ WLAN_STATUS_STA_NOT_QSTA = 50,
};
WLAN_REASON_INVALID_RSN_IE_CAP = 22,
WLAN_REASON_IEEE8021X_FAILED = 23,
WLAN_REASON_CIPHER_SUITE_REJECTED = 24,
+ /* 802.11e */
+ WLAN_REASON_DISASSOC_UNSPECIFIED_QOS = 32,
+ WLAN_REASON_DISASSOC_QAP_NO_BANDWIDTH = 33,
+ WLAN_REASON_DISASSOC_LOW_ACK = 34,
+ WLAN_REASON_DISASSOC_QAP_EXCEED_TXOP = 35,
+ WLAN_REASON_QSTA_LEAVE_QBSS = 36,
+ WLAN_REASON_QSTA_NOT_USE = 37,
+ WLAN_REASON_QSTA_REQUIRE_SETUP = 38,
+ WLAN_REASON_QSTA_TIMEOUT = 39,
+ WLAN_REASON_QSTA_CIPHER_NOT_SUPP = 45,
};
WLAN_EID_HP_PARAMS = 8,
WLAN_EID_HP_TABLE = 9,
WLAN_EID_REQUEST = 10,
+ /* 802.11e */
+ WLAN_EID_QBSS_LOAD = 11,
+ WLAN_EID_EDCA_PARAM_SET = 12,
+ WLAN_EID_TSPEC = 13,
+ WLAN_EID_TCLAS = 14,
+ WLAN_EID_SCHEDULE = 15,
+ WLAN_EID_TS_DELAY = 43,
+ WLAN_EID_TCLAS_PROCESSING = 44,
+ WLAN_EID_QOS_CAPA = 46,
/* 802.11h */
WLAN_EID_PWR_CONSTRAINT = 32,
WLAN_EID_PWR_CAPABILITY = 33,
/* 802.11g */
WLAN_EID_ERP_INFO = 42,
WLAN_EID_EXT_SUPP_RATES = 50,
+ /* 802.11n */
+ WLAN_EID_HT_CAPABILITY = 45,
+ WLAN_EID_HT_EXTRA_INFO = 61,
/* 802.11i */
WLAN_EID_RSN = 48,
WLAN_EID_WPA = 221,
WLAN_EID_QOS_PARAMETER = 222
};
+/* Action category code */
+enum ieee80211_category {
+ WLAN_CATEGORY_SPECTRUM_MGMT = 0,
+ WLAN_CATEGORY_QOS = 1,
+ WLAN_CATEGORY_DLS = 2,
+ WLAN_CATEGORY_BACK = 3,
+ WLAN_CATEGORY_WMM = 17,
+};
+
+/* BACK action code */
+enum ieee80211_back_actioncode {
+ WLAN_ACTION_ADDBA_REQ = 0,
+ WLAN_ACTION_ADDBA_RESP = 1,
+ WLAN_ACTION_DELBA = 2,
+};
+
+/* BACK (block-ack) parties */
+enum ieee80211_back_parties {
+ WLAN_BACK_RECIPIENT = 0,
+ WLAN_BACK_INITIATOR = 1,
+ WLAN_BACK_TIMER = 2,
+};
+
+/* A-MSDU 802.11n */
+#define IEEE80211_QOS_CONTROL_A_MSDU_PRESENT 0x0080
+
/* cipher suite selectors */
#define WLAN_CIPHER_SUITE_USE_GROUP 0x000FAC00
#define WLAN_CIPHER_SUITE_WEP40 0x000FAC01
projects / openwrt / staging / lynxis / omap.git / blobdiff