ramips: Use dts alias based status led
[openwrt/staging/wigyori.git] / target / linux / ramips / dts / AWUSFREE1.dts
1 /*
2 * BSD LICENSE
3 *
4 * Copyright (C) 2018 Piotr Dymacz <pepe2k@gmail.com>
5 * All rights reserved.
6 *
7 * Redistribution and use in source and binary forms, with or without
8 * modification, are permitted provided that the following conditions
9 * are met:
10 *
11 * 1. Redistributions of source code must retain the above copyright
12 * notice, this list of conditions and the following disclaimer.
13 * 2. Redistributions in binary form must reproduce the above copyright
14 * notice, this list of conditions and the following disclaimer in the
15 * documentation and/or other materials provided with the distribution.
16 * 3. Neither the names of the copyright holders nor the names of any
17 * contributors may be used to endorse or promote products derived
18 * from this software without specific prior written permission.
19 *
20 * THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS
21 * "AS IS" AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT
22 * LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR
23 * A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT
24 * HOLDER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL,
25 * SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT
26 * LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE,
27 * DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY
28 * THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT
29 * (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE
30 * OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
31 */
32
33 /dts-v1/;
34
35 #include "mt7628an.dtsi"
36
37 #include <dt-bindings/gpio/gpio.h>
38 #include <dt-bindings/input/input.h>
39
40 / {
41 compatible = "alfa-network,awusfree1", "mediatek,mt7628an-soc";
42 model = "ALFA Network AWUSFREE1";
43
44 aliases {
45 led-status = &led_system;
46 };
47
48 chosen {
49 bootargs = "console=ttyS0,115200";
50 };
51
52 gpio-keys-polled {
53 compatible = "gpio-keys-polled";
54 #address-cells = <1>;
55 #size-cells = <0>;
56 poll-interval = <20>;
57
58 reset {
59 label = "reset";
60 gpios = <&gpio1 6 GPIO_ACTIVE_LOW>;
61 linux,code = <KEY_RESTART>;
62 };
63 };
64
65 gpio-leds {
66 compatible = "gpio-leds";
67
68 led_system: system {
69 label = "awusfree1:orange:system";
70 gpios = <&gpio1 11 GPIO_ACTIVE_LOW>;
71 };
72
73 wlan {
74 label = "awusfree1:blue:wlan";
75 gpios = <&gpio1 12 GPIO_ACTIVE_LOW>;
76 };
77 };
78
79 memory@0 {
80 device_type = "memory";
81 reg = <0x0 0x4000000>;
82 };
83 };
84
85 &ehci {
86 status = "disabled";
87 };
88
89 &esw {
90 mediatek,portdisable = <0x1e>;
91 };
92
93 &ethernet {
94 mtd-mac-address = <&factory 0x2e>;
95 };
96
97 &gpio1 {
98 status = "okay";
99 };
100
101 &ohci {
102 status = "disabled";
103 };
104
105 &pinctrl {
106 state_default: pinctrl0 {
107 gpio {
108 ralink,group = "p0led_an", "wdt", "wled_an";
109 ralink,function = "gpio";
110 };
111
112 ext_lna {
113 ralink,group = "uart1";
114 ralink,function = "sw_r";
115 };
116
117 ext_pa {
118 ralink,group = "i2s";
119 ralink,function = "antenna";
120 };
121 };
122 };
123
124 &spi0 {
125 status = "okay";
126
127 m25p80@0 {
128 #address-cells = <1>;
129 #size-cells = <1>;
130 compatible = "jedec,spi-nor";
131 reg = <0>;
132 spi-max-frequency = <10000000>;
133 m25p,chunked-io = <32>;
134
135 partition@0 {
136 label = "u-boot";
137 reg = <0x0 0x30000>;
138 read-only;
139 };
140
141 partition@30000 {
142 label = "u-boot-env";
143 reg = <0x30000 0x1000>;
144 };
145
146 partition@031000 {
147 label = "config";
148 reg = <0x31000 0xf000>;
149 read-only;
150 };
151
152 factory: partition@40000 {
153 label = "factory";
154 reg = <0x40000 0x10000>;
155 read-only;
156 };
157
158 partition@50000 {
159 label = "firmware";
160 reg = <0x50000 0x7b0000>;
161 };
162 };
163 };
164
165 &wmac {
166 status = "okay";
167 mediatek,mtd-eeprom = <&factory 0x0>;
168 };