target/linux/ramips/dts/V11STFE.dts

   1 /dts-v1/;
   2
   3 #include "rt2880.dtsi"
   4
   5 #include <dt-bindings/gpio/gpio.h>
   6 #include <dt-bindings/input/input.h>
   7
   8 / {
   9         compatible = "ralink,v11st-fe", "ralink,rt2880-soc";
  10         model = "Ralink V11ST-FE";
  11
  12         pci@440000 {
  13                 status = "okay";
  14
  15                 host-bridge {
  16                         pci-bridge@1 {
  17                                 status = "okay";
  18                         };
  19                 };
  20         };
  21
  22         nor-flash@1c000000 {
  23                 compatible = "cfi-flash";
  24                 reg = <0x1c000000 0x800000>;
  25                 bank-width = <2>;
  26                 #address-cells = <1>;
  27                 #size-cells = <1>;
  28
  29                 partition@0 {
  30                         reg = <0x0 0x0030000>;
  31                         label = "u-boot";
  32                         read-only;
  33                 };
  34
  35                 partition@30000 {
  36                         reg = <0x00030000 0x00010000>;
  37                         label = "u-boot-env";
  38                         read-only;
  39                 };
  40
  41                 factory: partition@40000 {
  42                         reg = <0x00040000 0x00010000>;
  43                         label = "factory";
  44                         read-only;
  45                 };
  46
  47                 partition@50000 {
  48                         reg = <0x00050000 0x003b0000>;
  49                         label = "firmware";
  50                 };
  51         };
  52
  53         gpio-keys-polled {
  54                 compatible = "gpio-keys-polled";
  55                 #address-cells = <1>;
  56                 #size-cells = <0>;
  57                 poll-interval = <100>;
  58
  59                 wps {
  60                         label = "wps";
  61                         gpios = <&gpio0 0 GPIO_ACTIVE_HIGH>;
  62                         linux,code = <KEY_WPS_BUTTON>;
  63                 };
  64         };
  65
  66         gpio-leds {
  67                 compatible = "gpio-leds";
  68
  69                 status {
  70                         label = "v11st-fe:green:status";
  71                         gpios = <&gpio0 12 GPIO_ACTIVE_LOW>;
  72                 };
  73         };
  74 };
  75
  76 &gpio0 {
  77         status = "okay";
  78 };
  79
  80 &ethernet {
  81         status = "okay";
  82 };
  83
  84 &wmac {
  85         ralink,mtd-eeprom = <&factory 0>;
  86 };