compatible = "belkin,f5d8235-v2", "ralink,rt3052-soc";
model = "Belkin F5D8235 v2";
+ aliases {
+ led-boot = &led_router;
+ led-failsafe = &led_router;
+ led-running = &led_router;
+ led-upgrade = &led_router;
+ };
+
cfi@1f000000 {
compatible = "cfi-flash";
reg = <0x1f000000 0x800000>;
bank-width = <2>;
device-width = <2>;
- #address-cells = <1>;
- #size-cells = <1>;
-
- uboot: partition@0 {
- label = "uboot";
- reg = <0x0 0x50000>;
- read-only;
- };
-
- partition@50000 {
- label = "firmware";
- reg = <0x50000 0x790000>;
- };
-
- partition@7e0000 {
- label = "nvram";
- reg = <0x7e0000 0x10000>;
- };
- factory: partition@7f0000 {
- label = "factory";
- reg = <0x7f0000 0x10000>;
+ partitions {
+ compatible = "fixed-partitions";
+ #address-cells = <1>;
+ #size-cells = <1>;
+
+ uboot: partition@0 {
+ label = "uboot";
+ reg = <0x0 0x50000>;
+ read-only;
+ };
+
+ partition@50000 {
+ compatible = "denx,uimage";
+ label = "firmware";
+ reg = <0x50000 0x790000>;
+ };
+
+ partition@7e0000 {
+ label = "nvram";
+ reg = <0x7e0000 0x10000>;
+ };
+
+ factory: partition@7f0000 {
+ label = "factory";
+ reg = <0x7f0000 0x10000>;
+ };
};
};
gpio-sck = <&gpio0 2 GPIO_ACTIVE_HIGH>;
};
- gpio-leds {
+ leds {
compatible = "gpio-leds";
internet {
gpios = <&gpio0 8 GPIO_ACTIVE_LOW>;
};
- router {
+ led_router: router {
label = "f5d8235-v2:blue:router";
gpios = <&gpio0 9 GPIO_ACTIVE_LOW>;
};
storage {
label = "f5d8235-v2:blue:storage";
gpios = <&gpio0 23 GPIO_ACTIVE_LOW>;
+ trigger-sources = <&otg_port1>;
+ linux,default-trigger = "usbport";
};
storage2 {
&pinctrl {
state_default: pinctrl0 {
gpio {
- ralink,group = "spi", "i2c", "jtag", "rgmii", "mdio", "uartf";
+ ralink,group = "spi", "i2c", "jtag", "mdio", "uartf";
ralink,function = "gpio";
};
};
ðernet {
mtd-mac-address = <&uboot 0x40004>;
+ pinctrl-names = "default";
+ pinctrl-0 = <&rgmii_pins>;
};
&esw {
+ ralink,rgmii = <1>;
mediatek,portmap = <0x3f>;
+ ralink,fct2 = <0x0002500c>;
+ /*
+ * ext phy base addr 31, rx/tx clock skew 0,
+ * turbo mii off, rgmi 3.3v off, port 5 polling off
+ * port5: enabled, gige, full-duplex, rx/tx-flow-control
+ * port6: enabled, gige, full-duplex, rx/tx-flow-control
+ */
+ ralink,fpa2 = <0x1f003fff>;
};
&wmac {