ramips: dts: Unify naming of gpio-led nodes

[openwrt/staging/wigyori.git] / target / linux / ramips / dts / F5D8235_V2.dts

diff --git a/target/linux/ramips/dts/F5D8235_V2.dts b/target/linux/ramips/dts/F5D8235_V2.dts
index 6d4ed1d8cfc01539298afa605d6e78abc4044c33..93725e933699c735eb5684c896de254cabec9f81 100644 (file)
--- a/target/linux/ramips/dts/F5D8235_V2.dts
+++ b/target/linux/ramips/dts/F5D8235_V2.dts
@@ -10,7 +10,10 @@
        model = "Belkin F5D8235 v2";
 
        aliases {
-               led-status = &led_router;
+               led-boot = &led_router;
+               led-failsafe = &led_router;
+               led-running = &led_router;
+               led-upgrade = &led_router;
        };
 
        cfi@1f000000 {
@@ -18,28 +21,33 @@
                reg = <0x1f000000 0x800000>;
                bank-width = <2>;
                device-width = <2>;
-               #address-cells = <1>;
-               #size-cells = <1>;
 
-               uboot: partition@0 {
-                       label = "uboot";
-                       reg = <0x0 0x50000>;
-                       read-only;
-               };
-
-               partition@50000 {
-                       label = "firmware";
-                       reg = <0x50000 0x790000>;
-               };
-
-               partition@7e0000 {
-                       label = "nvram";
-                       reg = <0x7e0000 0x10000>;
-               };
-
-               factory: partition@7f0000 {
-                       label = "factory";
-                       reg = <0x7f0000 0x10000>;
+               partitions {
+                       compatible = "fixed-partitions";
+                       #address-cells = <1>;
+                       #size-cells = <1>;
+
+                       uboot: partition@0 {
+                               label = "uboot";
+                               reg = <0x0 0x50000>;
+                               read-only;
+                       };
+
+                       partition@50000 {
+                               compatible = "denx,uimage";
+                               label = "firmware";
+                               reg = <0x50000 0x790000>;
+                       };
+
+                       partition@7e0000 {
+                               label = "nvram";
+                               reg = <0x7e0000 0x10000>;
+                       };
+
+                       factory: partition@7f0000 {
+                               label = "factory";
+                               reg = <0x7f0000 0x10000>;
+                       };
                };
        };
 
@@ -49,7 +57,7 @@
                gpio-sck = <&gpio0 2 GPIO_ACTIVE_HIGH>;
        };
 
-       gpio-leds {
+       leds {
                compatible = "gpio-leds";
 
                internet {
@@ -80,6 +88,8 @@
                storage {
                        label = "f5d8235-v2:blue:storage";
                        gpios = <&gpio0 23 GPIO_ACTIVE_LOW>;
+                       trigger-sources = <&otg_port1>;
+                       linux,default-trigger = "usbport";
                };
 
                storage2 {
@@ -102,7 +112,7 @@
 &pinctrl {
        state_default: pinctrl0 {
                gpio {
-                       ralink,group = "spi", "i2c", "jtag", "rgmii", "mdio", "uartf";
+                       ralink,group = "spi", "i2c", "jtag", "mdio", "uartf";
                        ralink,function = "gpio";
                };
        };
@@ -110,10 +120,21 @@
 
 &ethernet {
        mtd-mac-address = <&uboot 0x40004>;
+       pinctrl-names = "default";
+       pinctrl-0 = <&rgmii_pins>;
 };
 
 &esw {
+       ralink,rgmii = <1>;
        mediatek,portmap = <0x3f>;
+       ralink,fct2 = <0x0002500c>;
+       /*
+        * ext phy base addr 31, rx/tx clock skew 0,
+        * turbo mii off, rgmi 3.3v off, port 5 polling off
+        * port5: enabled, gige, full-duplex, rx/tx-flow-control
+        * port6: enabled, gige, full-duplex, rx/tx-flow-control
+       */
+       ralink,fpa2 = <0x1f003fff>;
 };
 
 &wmac {