ramips: add support for ALFA Network Tube-E4G

ALFA Network Tube-E4G is an outdoor, dual-SIM LTE Cat. 4 CPE, based on
MediaTek MT7620A, equipped with Quectel EC25 miniPCIe modem.

Specification:

- MT7620A (580 MHz)
- 64/128/256 MB of RAM (DDR2)
- 16/32 MB of flash (SPI NOR)
- 1x 10/100 Mbps Ethernet, with passive PoE support (24 V)
- 1x miniPCIe slot (with PCIe and USB 2.0 buses)
- 2x SIM slot (mini, micro) with detect and switch driven by GPIO
- 1x detachable antenna (modem main)
- 1x internal antenna (modem div)
- 1x GPS passive antenna (optional)
- 5x LED (all driven by GPIO)
- 1x button (reset)
- UART (4-pin, 2.54 mm pitch) header on PCB

Other:

Default SIM slot is selected at an early stage by U-Boot, based on
'default_sim' environment value: 1 or unset = SIM1 (mini), 2 = SIM2
(micro). U-Boot also resets the modem, using #PERST signal, before
starting kernel.

Flash instruction:

You can use the 'sysupgrade' image directly in vendor firmware which is
based on OpenWrt (make sure to not preserve settings - use 'sysupgrade
-n -F ...' command). Alternatively, use web recovery mode in U-Boot:

1. Power the device with reset button pressed, the LAN LED will start
   blinking slowly and after ~3 seconds, when it starts blinking faster,
   you can release the button.
2. Setup static IP 192.168.1.2/24 on your PC.
3. Go to 192.168.1.1 in browser and upload 'sysupgrade' image.

Signed-off-by: Piotr Dymacz <pepe2k@gmail.com>

diff --git a/target/linux/ramips/base-files/etc/board.d/01_leds b/target/linux/ramips/base-files/etc/board.d/01_leds
index df5dd84d5aa9f18a0efd056e4fb55ea46a95e910..3a761decb1d8547ec44b9c4988c0b0cad498b566 100755 (executable)
--- a/target/linux/ramips/base-files/etc/board.d/01_leds
+++ b/target/linux/ramips/base-files/etc/board.d/01_leds
@@ -38,6 +38,10 @@ alfa-network,ac1200rm)
 alfa-network,awusfree1)
        set_wifi_led "$boardname:blue:wlan"
        ;;
 alfa-network,awusfree1)
        set_wifi_led "$boardname:blue:wlan"
        ;;

+alfa-network,tube-e4g)
+       ucidef_set_led_netdev "4g" "4g" "$boardname:green:4g" "wwan0"
+       ucidef_set_led_netdev "lan" "lan" "$boardname:blue:lan" "eth0"
+       ;;

 all0256n-4M|\
 all0256n-8M)
        ucidef_set_rssimon "wlan0" "200000" "1"
 all0256n-4M|\
 all0256n-8M)
        ucidef_set_rssimon "wlan0" "200000" "1"

diff --git a/target/linux/ramips/base-files/etc/board.d/02_network b/target/linux/ramips/base-files/etc/board.d/02_network
index 6657b7273d17bb00f2c56835d3bbc65613786ef7..5221838547b458b9403970289a1d0f4026ee1539 100755 (executable)
--- a/target/linux/ramips/base-files/etc/board.d/02_network
+++ b/target/linux/ramips/base-files/etc/board.d/02_network
@@ -147,6 +147,7 @@ ramips_setup_interfaces()
                        "0:lan" "1:lan" "2:lan" "4:wan" "6@eth0"
                ;;
        alfa-network,awusfree1|\
                        "0:lan" "1:lan" "2:lan" "4:wan" "6@eth0"
                ;;
        alfa-network,awusfree1|\

+       alfa-network,tube-e4g|\

        cs-qr10|\
        d105|\
        dlink,dap-1522-a1|\
        cs-qr10|\
        d105|\
        dlink,dap-1522-a1|\

diff --git a/target/linux/ramips/dts/TUBE-E4G.dts b/target/linux/ramips/dts/TUBE-E4G.dts
new file mode 100644 (file)
index 0000000..4097dc6
--- /dev/null
+++ b/target/linux/ramips/dts/TUBE-E4G.dts
@@ -0,0 +1,190 @@
+// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
+/dts-v1/;
+
+#include "mt7620a.dtsi"
+
+#include <dt-bindings/gpio/gpio.h>
+#include <dt-bindings/input/input.h>
+
+/ {
+       compatible = "alfa-network,tube-e4g", "ralink,mt7620a-soc";
+       model = "ALFA Network Tube-E4G";
+
+       aliases {
+               led-boot = &power;
+               led-failsafe = &power;
+               led-running = &power;
+               led-upgrade = &power;
+       };
+
+       chosen {
+               bootargs = "console=ttyS0,115200";
+       };
+
+       gpio-export {
+               compatible = "gpio-export";
+               #size-cells = <0>;
+
+               modem-enable {
+                       gpio-export,name = "modem-enable";
+                       gpio-export,output = <1>;
+                       gpios = <&gpio1 12 GPIO_ACTIVE_HIGH>;
+               };
+
+               modem-rf-enable {
+                       gpio-export,name = "modem-rf-enable";
+                       gpio-export,output = <1>;
+                       gpios = <&gpio0 12 GPIO_ACTIVE_HIGH>;
+               };
+
+               sim-select {
+                       gpio-export,name = "sim-select";
+                       gpio-export,output = <0>;
+                       gpios = <&gpio0 13 GPIO_ACTIVE_HIGH>;
+               };
+
+               sim1-detect {
+                       gpio-export,name = "sim1-detect";
+                       gpios = <&gpio0 9 GPIO_ACTIVE_HIGH>;
+               };
+
+               sim2-detect {
+                       gpio-export,name = "sim2-detect";
+                       gpios = <&gpio2 1 GPIO_ACTIVE_HIGH>;
+               };
+       };
+
+       keys {
+               compatible = "gpio-keys";
+
+               reset {
+                       label = "reset";
+                       linux,code = <KEY_RESTART>;
+                       gpios = <&gpio2 15 GPIO_ACTIVE_LOW>;
+                       debounce-interval = <60>;
+               };
+       };
+
+       leds {
+               compatible = "gpio-leds";
+
+               4g {
+                       label = "tube-e4g:green:4g";
+                       gpios = <&gpio0 7 GPIO_ACTIVE_LOW>;
+               };
+
+               lan {
+                       label = "tube-e4g:blue:lan";
+                       gpios = <&gpio2 4 GPIO_ACTIVE_LOW>;
+               };
+
+               power: power {
+                       label = "tube-e4g:green:power";
+                       gpios = <&gpio2 0 GPIO_ACTIVE_LOW>;
+                       default-state = "keep";
+               };
+
+               sim1 {
+                       label = "tube-e4g:green:sim1";
+                       gpios = <&gpio2 3 GPIO_ACTIVE_LOW>;
+                       default-state = "keep";
+               };
+
+               sim2 {
+                       label = "tube-e4g:green:sim2";
+                       gpios = <&gpio2 2 GPIO_ACTIVE_LOW>;
+                       default-state = "keep";
+               };
+       };
+};
+
+&ehci {
+       status = "okay";
+};
+
+&ethernet {
+       mtd-mac-address = <&factory 0x28>;
+};
+
+&gpio0 {
+       status = "okay";
+};
+
+&gpio1 {
+       status = "okay";
+};
+
+&gpio2 {
+       status = "okay";
+};
+
+&gsw {
+       mediatek,port4 = "ephy";
+};
+
+&ohci {
+       status = "okay";
+};
+
+&pcie {
+       status = "disabled";
+};
+
+&pinctrl {
+       state_default: pinctrl0 {
+               gpio {
+                       ralink,group = "ephy", "nd_sd", "pcie", "uartf";
+                       ralink,function = "gpio";
+               };
+       };
+};
+
+&spi0 {
+       status = "okay";
+
+       flash@0 {
+               compatible = "jedec,spi-nor";
+               reg = <0>;
+               spi-max-frequency = <50000000>;
+               m25p,fast-read;
+
+               partitions {
+                       compatible = "fixed-partitions";
+                       #address-cells = <1>;
+                       #size-cells = <1>;
+
+                       partition@0 {
+                               label = "u-boot";
+                               reg = <0x0 0x30000>;
+                               read-only;
+                       };
+
+                       partition@30000 {
+                               label = "u-boot-env";
+                               reg = <0x30000 0x1000>;
+                       };
+
+                       partition@31000 {
+                               label = "config";
+                               reg = <0x31000 0xf000>;
+                               read-only;
+                       };
+
+                       factory: partition@40000 {
+                               label = "factory";
+                               reg = <0x40000 0x10000>;
+                               read-only;
+                       };
+
+                       partition@50000 {
+                               compatible = "denx,uimage";
+                               label = "firmware";
+                               reg = <0x50000 0xfb0000>;
+                       };
+               };
+       };
+};
+
+&wmac {
+       status = "disabled";
+};

diff --git a/target/linux/ramips/image/mt7620.mk b/target/linux/ramips/image/mt7620.mk
index 7ac228db166402a4750098c97ac3b46cbbcccae9..77a5b5724d76d01cdb1a71f06a65704c2476f0a5 100644 (file)
--- a/target/linux/ramips/image/mt7620.mk
+++ b/target/linux/ramips/image/mt7620.mk
@@ -51,6 +51,15 @@ define Device/alfa-network_ac1200rm
 endef
 TARGET_DEVICES += alfa-network_ac1200rm
 
 endef
 TARGET_DEVICES += alfa-network_ac1200rm
 

+define Device/alfa-network_tube-e4g
+  DTS := TUBE-E4G
+  IMAGE_SIZE := 16064k
+  DEVICE_TITLE := ALFA Network Tube-E4G
+  DEVICE_PACKAGES := kmod-usb2 kmod-usb-ohci uboot-envtools uqmi \
+       -iwinfo -kmod-rt2800-pci -kmod-rt2800-soc -wpad-basic
+endef
+TARGET_DEVICES += alfa-network_tube-e4g
+

 define Device/Archer
   TPLINK_HWREVADD := 0
   TPLINK_HVERSION := 3
 define Device/Archer
   TPLINK_HWREVADD := 0
   TPLINK_HVERSION := 3