broadcom-diag: support for the WNDR3700v3 I recently picked up a WNDR3700 to put OpenWRT on, and only after tearing into the box did I find it was one of the v3 boards, with poor OpenWRT support. This patch should add the board detection and LED/button control to the broadcom-diag module, and should generate a netgear .chk image that the bootloader and stock firmware will accept. The changes to the broadcom-diag module are more than a few lines because the WNDR3700v3 is driving its LEDs through an HC164 8-bit shift register. Signed-off-by: Owen Kirby <osk@exegin.com> SVN-Revision: 36482
broadcom-diag: add support for e3200 v1 Hex values in nvram seem to be uppercase on my e3200 device. Define one power led and two buttons (reset/wps). Signed-off-by: Tijs Van Buggenhout <tvb@able.be> Signed-off-by: Hauke Mehrtens <hauke@hauke-m.de> SVN-Revision: 35766
broadcom-diag: Detection of WNDR3400v1 nvram variable "boardtype" is unique for now. -button gpio were taken from nvram. -led information was taken from dd-wrt ( http://svn.dd-wrt.com/browser/src/router/libutils/utils.c ) I hope that I changed the values correctly. Signed-off-by: Dirk Neukirchen <dirkneukirchen@web.de> Signed-off-by: Hauke Mehrtens <hauke@hauke-m.de> SVN-Revision: 35765
broadcom-diag: add diag support for Linksys E1000 V1 This adds diag leds/buttons support for Linksys E1000 V1. It worked on my router, however it may need some tweaking by people more familiar with openwrt and c to make it fit for commiting. Thank you hhm for this patch. SVN-Revision: 34996