brcm63xx: add preliminary support for 3.13
[openwrt/svn-archive/archive.git] / target / linux / brcm63xx / patches-3.13 / 535-board_rta770w.patch
1 --- a/arch/mips/bcm63xx/boards/board_bcm963xx.c
2 +++ b/arch/mips/bcm63xx/boards/board_bcm963xx.c
3 @@ -776,6 +776,60 @@ static struct board_info __initdata boar
4 },
5 },
6 };
7 +
8 +// Actually this board is the very same as the rta770bw,
9 +// where the additional 'b' within the name just
10 +// just indicates 'Annex B'. The ADSL Modem itself is able
11 +// to handle both Annex A as well as Annex B -
12 +// the loaded firmware makes the only difference
13 +static struct board_info __initdata board_rta770w = {
14 + .name = "RTA770W",
15 + .expected_cpu_id = 0x6345,
16 +
17 + .has_uart0 = 1,
18 +
19 + .has_enet0 = 1,
20 +
21 + .enet0 = {
22 + .has_phy = 1,
23 + .phy_id = 0,
24 + .force_speed_100 = 1,
25 + .force_duplex_full = 1,
26 + },
27 +
28 + .leds = {
29 + {
30 + .name = "RTA770W:green:usb",
31 + .gpio = 7,
32 + .active_low = 1,
33 + },
34 + {
35 + .name = "RTA770W:green:adsl",
36 + .gpio = 8,
37 + },
38 + {
39 + .name = "RTA770W:green:diag",
40 + .gpio = 10,
41 + .active_low = 1,
42 + },
43 + {
44 + .name = "RTA770W:green:wlan",
45 + .gpio = 11,
46 + .active_low = 1,
47 + },
48 + },
49 +
50 + .buttons = {
51 + {
52 + .desc = "reset",
53 + .gpio = 13,
54 + .type = EV_KEY,
55 + .code = KEY_RESTART,
56 + .active_low = 1,
57 + .debounce_interval = BCM963XX_KEYS_DEBOUNCE_INTERVAL,
58 + },
59 + },
60 +};
61 #endif
62
63 /*
64 @@ -3788,6 +3842,7 @@ static const struct board_info __initcon
65 #ifdef CONFIG_BCM63XX_CPU_6345
66 &board_96345gw2,
67 &board_rta770bw,
68 + &board_rta770w,
69 #endif
70 #ifdef CONFIG_BCM63XX_CPU_6348
71 &board_96348r,