ramips: Change all '/include/' clauses to '#include' so preprocessing can be done...
[openwrt/svn-archive/archive.git] / target / linux / ramips / dts / ATP-52B.dts
1 /dts-v1/;
2
3 #include "rt3050.dtsi"
4
5 / {
6 compatible = "ATP-52B", "ralink,rt3052-soc";
7 model = "Argus ATP-52B";
8
9 pinctrl {
10 state_default: pinctrl0 {
11 gpio {
12 ralink,group = "i2c", "jtag", "rgmii", "mdio", "uartf";
13 ralink,function = "gpio";
14 };
15 };
16 };
17
18 cfi@1f000000 {
19 compatible = "cfi-flash";
20 reg = <0x1f000000 0x800000>;
21 bank-width = <2>;
22 device-width = <2>;
23 #address-cells = <1>;
24 #size-cells = <1>;
25
26 partition@0 {
27 label = "bootloader";
28 reg = <0x0 0x30000>;
29 read-only;
30 };
31
32 partition@30000 {
33 label = "config";
34 reg = <0x30000 0x10000>;
35 };
36
37 factory: partition@40000 {
38 label = "factory";
39 reg = <0x40000 0x10000>;
40 };
41
42 partition@50000 {
43 label = "firmware";
44 reg = <0x50000 0x7a0000>;
45 };
46 };
47
48 gpio-leds {
49 compatible = "gpio-leds";
50
51 run {
52 label = "atp-52b:green:run";
53 gpios = <&gpio0 9 1>;
54 };
55
56 net {
57 label = "atp-52b:amber:net";
58 gpios = <&gpio0 13 1>;
59 };
60 };
61
62 gpio-keys-polled {
63 compatible = "gpio-keys-polled";
64 #address-cells = <1>;
65 #size-cells = <0>;
66 poll-interval = <20>;
67
68 wps {
69 label = "wps";
70 gpios = <&gpio0 0 1>;
71 linux,code = <0x211>;
72 };
73
74 reset {
75 label = "reset";
76 gpios = <&gpio0 10 1>;
77 linux,code = <0x198>;
78 };
79 };
80
81 ethernet@10100000 {
82 mtd-mac-address = <&factory 0x4>;
83 };
84
85 esw@10110000 {
86 mediatek,portmap = <0x3e>;
87 };
88
89 wmac@10180000 {
90 ralink,mtd-eeprom = <&factory 0>;
91 };
92
93 otg@101c0000 {
94 status = "okay";
95 };
96 };